Thickness dependence of the room-temperature ethanol sensor properties of Cu2O polycrystalline films.

This study investigates the fabrication process of copper thin films via thermal evaporation, with precise control over film thickness achieved throughZ-position adjustment. Analysis of the as-fabricated copper films reveals a discernible relationship between grain size (〈D〉) andZ-position, characterized by a phenomenological equation〈D〉XRDn(Z)=〈D〉0n1+32rZ2+158rZ4, which is further supported by a growth exponent (n) of 0.41 obtained from the analysis. This value aligns well with findings in the literature concerning the growth of copper films, thus underlining the validity and reliability of our experimental outcomes. The resulting crystallites, ranging in size from 20 to 26 nm, exhibit a resistivity within the range of 3.3-4.6µΩ · cm. Upon thermal annealing at 200 °C, cuprite Cu2O thin films are produced, demonstrating crystallite sizes ranging from ∼9 to ∼24 nm with increasing film thickness. The observed monotonic reduction in Cu2O crystallites relative to film thickness is attributed to a recrystallization process, indicating amorphization when oxygen atoms are introduced, followed by the nucleation and growth of newly formed copper oxide phase. Changes in the optical bandgap of the Cu2O films, ranging from 2.31 to 2.07 eV, are attributed mainly to the quantum confinement effect, particularly important in Cu2O with size close than the Bohr exciton diameter (5 nm) of the Cu2O. Additionally, correlations between refractive index and extinction coefficient with film thickness are observed, notably a linear relationship between refractive index and charge carrier density. Electrical measurements confirm the presence of a p-type semiconductor with carrier concentrations of ∼1014cm-3, showing a slight decrease with film thickness. This phenomenon is likely attributed to escalating film roughness, which introduces supplementary scattering mechanisms for charge carriers, leading to a resistivity increase, especially as the roughness approaches or surpasses the mean free path of charge carriers (8.61 nm). Moreover,ab-initiocalculations on the Cu2O crystalline phase to investigate the impact of hydrostatic strain on its electronic and optical properties was conducted. We believe that our findings provide crucial insights that support the elucidation of the experimental results. Notably, thinner cuprite films exhibit heightened sensitivity to ethanol gas at room temperature, indicating potential for highly responsive gas sensors, particularly for ethanol breath testing, with significant implications for portable device applications.

Synthesis and characterization ofα-Fe2O3nanoparticles showing potential applications for sensing quaternary ammonium vapor at room temperature.

P-type and n-type metal oxide semiconductors are widely used in the manufacture of gas sensing materials, due to their excellent electronic, electrical and electrocatalytic properties. Hematite (α-Fe2O3) compound has been reported as a promising material for sensing broad types of gases, due to its affordability, good stability and semiconducting properties. In the present work, the efficient and easy-to-implement sol-gel method has been used to synthesizeα-Fe2O3nanoparticles (NPs). The TGA-DSC characterizations of the precursor gel provided information about the phase transformation temperature and the mass percentage of the hematite NPs. X-ray diffraction, transmission electron microscopy and x-ray photoelectron spectroscopy data analyses indicated the formation of two iron oxide phases (hematite and magnetite) when the NPs are subjected to thermal treatment at 400 °C. Meanwhile, only the hematite phase was determined for thermal annealing above 500 °C up to 800 °C. Besides, the crystallite size shows an increasing trend with the thermal annealing and no defined morphology. A clear reduction of surface defects, associated with oxygen vacancies was also evidenced when the annealing temperature was increased, resulting in changes on the electrical properties of hematite NPs. Resistive gas-sensing tests were carried out using hematite NPs + glycerin paste, to detect quaternary ammonium compounds. Room-temperature high sensitivity values (Sr âˆ¼ 4) have been obtained during the detection of ∼1 mM quaternary ammonium compounds vapor. The dependence of the sensitivity on the particle size, the mass ratio of NPs with respect to the organic ligand, changes in the dielectric properties, and the electrical conduction mechanism of gas sensing was discussed.

Cu-doped SnO2 nanoparticles: size and antibacterial activity investigations.

Nowadays, the use of self-cleaning surfaces is increasing globally, especially after the COVID-2019 pandemic, and the use of nanoparticles has been shown as a plausible option for this purpose. In the present study, Cu-doped SnO2 nanocrystals were successfully synthesized (in the copper content range of 0-30 mol%) using the polymeric precursor method. The structural, morphological, vibrational, and antibacterial activity were carefully studied to unveil the effect of copper ions on the properties of the hosting matrix, aiming at maximizing the usage of Cu-doped SnO2 nanocrystals. The results show fabrication of nanoparticles near their respective exciton Bohr diameter (5.4 nm for SnO2), however, monophasic SnO2 was observed up to 15 mol%. Above this limit, a secondary CuO phase was observed, as shown by the assessed X-ray diffraction (XRD), Fourier transform infrared, and Raman spectroscopy data. Furthermore, the redshift of the primary A1g vibrational mode of SnO2 is successfully described using the phonon-confinement model, demonstrating a good relationship between the Raman correlation length (L) and the crystallite size (〈D〉), the latter determined from XRD. Regarding the antibacterial activity, assessed via the disc-diffusion testing method (DDTM) while challenging two bacterial species (S. aureus and E. coli), our results suggest a rapid diffusion of the nanoparticles out of the paper disc, with a synergistic effect credited to the Sn1-xCuxO2-CuO phases contributing to the inhibition of the bacteria growth. Moreover, the DDTM data scales with cell viability, the latter analyzed using the Hill equation, from which both lethal dose 50 (LD50) and benchmark dose (BMD) were extracted.

High efficiency of magnetite nanoparticles for the arsenic removal from an aqueous solution and natural water taken from Tambo River in Peru.

Water is an essential compound on earth and necessary for life. The presence of highly toxic contaminants such as arsenic and others, in many cases, represents one of the biggest problems facing the earth´s population. Treatment of contaminated water with magnetite (Fe3O4) nanoparticles (NPs) can play a crucial role in arsenic removal. In this report, we demonstrate arsenic removal from an aqueous solution and natural water taken from the Peruvian river (Tambo River in Arequipa, Peru) using magnetite NPs synthesized by the coprecipitation method. XRD data analysis of Fe3O4 NPs revealed the formation of the cubic-spinel phase of magnetite with an average crystallite size of ~ 13 nm, which is found in good agreement with the physical size assessed from TEM image analysis. Magnetic results evidence that our NPs show a superparamagnetic-like behavior with a thermal relaxation of magnetic moments mediated by strong particle-particle interactions. FTIR absorption band shows the interactions between arsenate anions and Fe-O and Fe-OH groups through a complex mechanism. The experimental results showed that arsenic adsorption is fast during the first 10 min; while the equilibrium is reached within 60 min, providing an arsenic removal efficiency of ~ 97%. Adsorption kinetics is well modeled using the pseudo-second-order kinetic equation, suggesting that the adsorption process is related to the chemisorption model. According to Langmuir's model, the maximum arsenic adsorption capacity of 81.04 mg·g- 1 at pH = 2.5 was estimated, which describes the adsorption process as being monolayer, However, our results suggest that multilayer adsorption can be produced after monolayer saturation in agreement with the Freundlich model. This finding was corroborated by the Sips model, which showed a good correlation to the experimental data. Tests using natural water taken from Tambo River indicate a significant reduction of arsenic concentration from 356 µg L- 1 to 7.38 µg L- 1, the latter is below the limit imposed by World Health Organization (10 µg L- 1), suggesting that magnetite NPs show great potential for the arsenic removal.

Bioelectrogenesis with microbial fuel cells (MFCs) using the microalga Chlorella vulgaris and bacterial communities

Background: Microbial Fuel Cell (MFC) technology is used in various applications such as wastewater treatment with the production of electrical energy. The objective of this study was to estimate the biodepuration of oils and fats, the elimination of blue dye brl and bioelectro-characterization in MFCs with Chlorella vulgaris and bacterial community. Results: The operation of MFCs at 32 d showed an increase in bioelectrogenic activity (from 23.17 to 327.67 mW/m2 ) and in the potential (from 200 to 954 mV), with biodepuration of fats and oils (95%) in the microalgal cathode, and a removal of the chemical oxygen demand COD (anode, 71%, cathode, 78.6%) and the blue dye brl (73%) at the anode, here biofilms were formed by the bacterial community consisting of Actinobacteria and Deltaproteobacteria. Conclusions: These findings suggest that MFCs with C. vulgaris and bacterial community have a simultaneous efficiency in the production of bioelectricity and bioremediation processes, becoming an important source of bioenergy in the future.

Cultivo de Arthrospira platensis (Spirulina) en fotobiorreactor tubular doblemente curvado a condiciones ambientales en el sur del Perú / Cultivation of Arthrospira platensis (Spirulina) in curved doubly tubular photobioreactor to environmental conditions in the South of the Peru

El presente trabajo investigó el cultivo de la microalga Arthrospira platensis (Spirulina) en valores de productividad cultivado en fotobiorreactor tubular doblemente curvado a condiciones ambientales con el fin de aprovechar la alta radiación solar de la región Arequipa en el sur de Perú (16°24´50´´ LS; 71°32´02´´ LO; 2344 msnm). El fotobiorreactor fue construido con un tubo transparente de policloruro de vinilo (PVC). La productividad del cultivo fue de 13.9 g/m² en 14 días ó 1 g/m²/día y una concentración de clorofila - "a" de 0.00785 mg/L con una máxima radiación de 1179 W/m², y una iluminación de 121500 lux, convirtiendo sus filamentos helicoidales a morfologías anormales, tales como formas irregulares curvas e incluso lineales con fragmentaciones, demostrando que el cultivo se vio afectado por la alta radiación y las variaciones de temperaturas de Arequipa.

The present work investigated the cultivation of microalgae Arthrospira platensis (Spirulina) in productivity values cultivated in doubly curved tubular photobioreactor to environmental conditions in order to take advantage of the high solar radiation of the Arequipa region in southern Peru (16°24´50´´ LS; 71°32´02´´LW; 2344 msnm.). The photobioreactor was built with a transparent tube of polyvinyl chloride (PVC). The productivity of the crop was 13.9 g/m² in 14 days or 1 g/m²/day and a concentration of chlorophyll - "a" 0.00785 mg/L with a maximum radiation of 1179 W/m², and a 121500 lux illumination, making its helical filaments abnormal morphologies, such as curves and linear even irregular shapes with fragmentation, demonstrating that the crop was affected by high radiation and variations in temperatures of Arequipa.