Gender differences in carpal tunnel relative cross-sectional area: a possible causative factor in idiopathic carpal tunnel syndrome.

UNLABELLED: Previous research has not established a consistent difference in hand size or carpal tunnel cross-sectional area between patients with and without carpal tunnel syndrome. We tested the hypothesis that there would be no difference in relative carpal tunnel sizes between men and women. We defined relative carpal tunnel size as the cross-sectional areas at the inlet (level of the pisiform) and outlet (level of the hook of the hamate) of the carpal tunnel divided by the length of the capitate (as a measure of hand size). We made the measurements on the magnetic resonance imaging scans of 50 men and 50 women taken for symptoms unrelated to carpal tunnel syndrome. The mean relative cross-sectional area was appreciably smaller in women than men (p < 0.05). This suggests that the carpal tunnel cross-sectional area relative to the size of the hand is constitutionally smaller in women than in men. This could in theory be a significant factor in patients developing carpal tunnel syndrome. LEVEL OF EVIDENCE: V.

Evaluation of occupational and patient radiation doses in orthopedic surgery.

This study intends to measure the radiation dose to patients and staff during (i) Dynamic Hip Screw (DHS) and (ii) Dynamic Cannula Screw (DCS) and to evaluate entrance surface Air kerma (ESAK) dose and organ doses and effective doses. Calibrated Thermoluminescence dosimeters (TLD-GR200A) were used. The mean patients' doses were 0.46mGy and 0.07mGy for DHS and DCS procedures, respectively. The mean staff doses at the thyroid and chest were 4.69mGy and 1.21mGy per procedure. The mean organ and effective dose for patients and staff were higher in DHS compared to DCS. Orthopedic surgeons were exposed to unnecessary radiation doses due to the lack of protection measures. The radiation dose per hip procedure is within the safety limit and less than the previous studies.

Moving segments region of interest attenuator for x-ray fluoroscopy.

Region of interest (ROI) imaging has previously been proposed as a means of reducing x-ray fluoroscopy radiation dose. Previous ROI attenuators made of partially attenuating metal plates change beam quality, which may lead to uncertainty in image restoration procedures. The design and construction of a prototype moving segments ROI attenuator (MS-ROI), which maintains beam quality across the whole field of view is described. The x-ray beam intensity is halved by 36 lead segments which are rapidly rotated between the x-ray tube and patient, with a central hole projecting a circular ROI at full intensity. Image processing techniques with automatic detection of the ROI boundary were used to homogenize image brightness across the whole image. Images restored using these techniques were judged to be visually acceptable, with a good match between pixel values inside and outside the ROI. Image contrast within the ROI was improved by 18% due to reduced scatter and veiling glare from the periphery. The introduction of the MS-ROI attenuator also results in a 48% increase in statistical noise in the area outside the ROI, with no significant change in object contrast. The patient entrance dose measured using the dose area product (DAP) method was reduced by 53.4% under manual exposure control, with the dose to operators reduced by 48.4% under automatic brightness control. Further work is needed to determine whether the attenuator can be used with pulsed fluoroscopy, and to reduce vibrational effects on the ROI boundary. The MS-ROI attenuator provides a more constant ratio of central-to-peripheral image intensity, and maintains uniform beam quality and image contrast across the whole image in comparison to simple metal plate attenuators.