All-fiber mode-group-selective photonic lantern using graded-index multimode fibers.

We demonstrate the first all-fiber mode-group-selective photonic lantern using multimode graded-index fibers. Mode selectivity for mode groups LP(01), LP(11) and LP(21)+LP(02) is 20-dB, 10-dB and 7-dB respectively. The insertion loss when butt coupled to multimode graded-index fiber is below 0.6-dB. The use of the multimode graded-index fibers in the taper can significantly reduce the adiabaticity requirement.

Mode-multiplexed transmission over conventional graded-index multimode fibers.

We present experimental results for combined mode-multiplexed and wavelength multiplexed transmission over conventional graded-index multimode fibers. We use mode-selective photonic lanterns as mode couplers to precisely excite a subset of the modes of the multimode fiber and additionally to compensate for the differential group delay between the excited modes. Spatial mode filters are added to suppress undesired higher order modes. We transmit 30-Gbaud QPSK signals over 60 WDM channels, 3 spatial modes, and 2 polarizations, reaching a distance of 310 km based on a 44.3 km long span. We also report about transmission experiments over 6 spatial modes for a 17-km single-span experiment. The results indicate that multimode fibers support scalable mode-division multiplexing approaches, where modes can be added over time if desired. Also the results indicate that mode-multiplexed transmission distance over 300 km are possible in conventional multimode fibers.

High quantum efficiency of near-infrared emission in bismuth doped AlGeP-silica fiber.

A self-calibrating method is described for measuring the radiative quantum efficiency (QE) in doped optical fibers. The method uses an integrating sphere to collect the fluorescence from the fiber, with pump light transmitted through the fiber end serving as a reference. QE measurements for a 780 or 808 nm pump were made on bismuth-doped AlGeP-silica fibers prepared by aerosol deposition. For both wavelengths, a value of QE=1.0+/-0.05 was obtained. Fluorescence was observed in two bands centered around 800 and 1300 nm, and the relative strength of these bands was found to vary with the pump wavelength.

Technique for continuous tuning of optical fiber lasers.

For the first time to the authors' knowledge, we have demonstrated how thermally controlled overcoupled fused fiber couplers and fiber loop mirrors based on these couplers can be used as broadband tuning elements in a fiber laser cavity. No bulk optical elements play any role in this technique. Temperature tuning the coupler results in a shift in the coupling ratio or in the effective output coupler transmission. For a fixed pump source, and for a given laser cavity, this shift causes the lasing wavelength to shift. We have continuously tuned an Er silica fiber laser in this manner over the range of 1527-1570 nm in a ring configuration, and, using a fiber loop mirror with these couplers in a linear Tm silica fiber laser cavity, we have achieved more than 50-nm broadband tuning over the range of 1850-1910 nm. The tuning range and the sensitivity to temperature depend on the degree of overcoupling of the loop mirror coupler.