Effect of blue light plus chlorhexidine therapy on Streptococcus mutans biofilm and its regrowth in an in vitro orthodontic model.

INTRODUCTION: Fixed orthodontic appliances create areas of stagnation for dental biofilms and make it difficult to clean the teeth; therefore, there is a risk of developing incipient caries lesions during the orthodontic treatment. The objective of this study is to determine if the combination of 2 different therapies, phototherapy by blue light (BL) and the antimicrobial 0.12% chlorhexidine (CHX) on enamel, orthodontic brackets, and elastics, would reduce or inhibit mature Streptococcus mutans biofilms and their regrowth on these substrates 24 hours after the application of the treatment; and if this treatment would interfere with bracket adhesion to the enamel. METHODS: Biofilms of S. mutans UA159 were formed for 5-days over samples composed of a bovine enamel, orthodontic bracket, and orthodontic elastic. Then, the specimens were treated with 0.89% NaCl for 1 minute, BL for 12 minutes (72 J/cm2), 0.12% CHX for 1 minute, and BL for 12 minutes, followed by 0.12% CHX for 1 minute (BL+CHX). Biofilm was evaluated by colonies forming units and dry weight immediately after treatments and 24 hours after treatments (regrowth). The pH of the spent media was measured on the fifth and sixth days. Biofilm formation on the samples after the treatments and regrowth was visually evaluated by confocal laser scanning microscopy. Shear bond strength (SBS) between bracket and enamel was evaluated using a universal testing machine at a crosshead speed of 1 mm/min. After bonding, specimens were thermocycled (500× at 5-55°C), treated, and thermocycled again. RESULTS: After 5 days of biofilm formation, BL+CHX significantly reduced the bacterial viability on enamel compared with NaCl (P = 0.004) and BL (P = 0.014). For bracket and elastic, all the treatments resulted in similar bacterial viability (P ≥0.081). In the regrowth, CHX and BL+CHX significantly reduced the bacterial viability in the enamel compared with the NaCl (P ≤0.015) and BL (P ≤0.013). For bracket, BL+CHX significantly reduced the bacterial viability compared with NaCl (P = 0.008) and BL (P = 0.009). For the elastic, BL+CHX eliminated the biofilms from the substrate. CHX and BL+CHX significantly reduced the bacterial viability 24 hours after treatment for all substrates (P ≤0.05). The media pH significantly increased when samples were treated with CHX and BL+CHX (P ≤0.001). Confocal laser scanning microscopy images visually showed an abundant quantity of red cells in the samples treated with BL+CHX. There was no difference in the SBS between the treatments (P ≥0.932). CONCLUSIONS: The association between BL and CHX reduced S. mutans biofilm and its regrowth on an in vitro orthodontic model and did not influence the bonding strength between bracket and enamel.

Novel resin-based material containing ß-tricalcium phosphate nanoparticles for the reduction of dentin permeability.

OBJECTIVES: To synthesize and characterize a novel dentin adhesive containing Beta-Tricalcium Phosphate (ß-TCP) nanoparticles and test its ability to reduce dentin permeability (dP). METHODS: Experimental adhesives were prepared by mixing Bis-GMA, TEGDMA, HEMA (50/25/25 wt.%), photo-initiators, and inhibitors. The following groups were tested: Experimental adhesives without ß-TCP (Exp.); with 10 wt.% ß-TCP (Exp.10 wt.% ß-TCP); with 15 wt.% ß-TCP (Exp.15 wt.% ß-TCP), Scotchbond Multi-Purpose (SBMP) and Clearfil SE Protect Bond (CFPB). Degree of conversion (DC%, 10 and 20 s); Flexural Strength (FS), Knoop Hardness (KHN), and Cell Viability (OD%) tests were performed. dP was evaluated by hydraulic conductance, using human dentin disks (n=12), at three-time intervals: post-EDTA (T0); post-treatment (T1); and post-erosion/abrasion cycling (T2). Data were statistically analyzed (α=0.05). RESULTS: For all groups, exposure time for 20 s presented a higher DC% than for 10 s. For FS, filled adhesives did not differ from unfilled and from CFPB. Experimental adhesives did not differ among them and showed lower KHN than the commercial products. Cell viability did not differ among adhesives, except Exp. 15 wt.%, which showed lower OD% than Exp., Exp. 10% and, CFPB. For dP, only Exp.10 and 15 wt.% ß-TCP did not present difference between the times T1 and T2. After cycling, Exp.10 wt.% ß-TCP presented lower permeability than Exp. and CFPB. CONCLUSIONS: The incorporation of 10 wt.% ß-TCP nanoparticles into the resin-based dental material did not affect its mechanical properties and biocompatibility, and promoted the greatest reduction in dentin permeability, sustaining this effect under erosive/abrasive challenges. CLINICAL SIGNIFICANCE: A novel resin-based dental material containing ß-TCP nanoparticles was able to reduce dentin permeability, maintaining its efficacy after erosive/abrasive challenges. The synthesized material did not affect dental pulp cell viability and might be promising for other conditions that require dental remineralization, such as tooth wear and dental caries.

Effect of a modified adhesive system with encapsulated arginine and calcium carbonate on dentin permeability.

To modify an adhesive system with halloysite clay nanotubes (HNTs) containing arginine and calcium carbonate and to evaluate their cytocompatibility, viscosity and efficacy in reducing dentin permeability. HNTs containing arginine and calcium carbonate were incorporated into the primer and adhesive of a three-step adhesive system (SBMP), and their viscosity was measured. Discs (n = 4/group) were prepared: SBMP (control), HNT-PR (modified primer), HNT-ADH (modified adhesive) and HNT-PR + ADH (modified primer and adhesive) were evaluated regarding cell death and viability. Dentin discs were prepared and randomly assigned into the following treatments (n = 10): NC (no treatment), SBMP, HNT-PR, HNT-ADH, HNT-PR + ADH and COL (Colgate® Sensitive Pro-relief™ prophylaxis paste). After, they were submitted to an erosive-abrasive cycling. Dentin permeability (hydraulic conductance) was evaluated at baseline, 24 h after treatment and after cycling. Both the modified primer and adhesive showed significantly higher viscosity than their controls. Group HNT-PR resulted in significantly higher cytotoxicity when compared to SBMP and HNT-PR + ADH groups. Group HNT-ADH resulted in the highest cell viability compared to all other groups. All groups showed significantly lower dentin permeability when compared to the NC group. Post-cycling, SBMP and HNT-ADH groups showed significantly lower permeability when compared to COL group. The addition of encapsulated arginine and calcium carbonate did not affect the cytocompatibility of the materials nor their ability to reduce dentin permeability.