Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 2 de 2
Filtrar
Mais filtros

Base de dados
Ano de publicação
Tipo de documento
Intervalo de ano de publicação
1.
Adv Mater ; : e2409261, 2024 Aug 02.
Artigo em Inglês | MEDLINE | ID: mdl-39092687

RESUMO

The bottom contact in perovskite solar cells (PSCs) is easy to cause deep trap states and severe instability issues, especially under maximum power point tracking (MPPT). In this study, sodium gluconate (SG) is employed to disperse tin oxide (SnO2) nanoparticles (NPs) and regulate the interface contact at the buried interface. The SG-SnO2 electron transfer layer (ETL) enabled the deposition of pinhole-free perovskite films in ambient air and improved interface contact by bridging effect. SG-SnO2 PSCs achieved an impressive power conversion efficiency (PCE) of 25.34% (certified as 25.17%) with a high open-circuit voltage (VOC) exceeding 1.19 V. The VOC loss is less than 0.34 V relative to the 1.53 eV bandgap, and the fill factor (FF) loss is only 2.02% due to the improved contact. The SG-SnO2 PSCs retained around 90% of their initial PCEs after 1000 h operation (T90 = 1000 h), higher than T80 = 1000 h for the control SnO2 PSC. Microstructure analysis revealed that light-induced degradation primarily occurred at the buried holes and grain boundaries and highlighted the importance of bottom-contact engineering.

2.
ACS Omega ; 7(7): 6271-6279, 2022 Feb 22.
Artigo em Inglês | MEDLINE | ID: mdl-35224389

RESUMO

Tight oil reservoirs have poor physical properties, insufficient formation energy, and low natural productivity. CO2 flooding is an important technical mean that enhances the oil recovery of dense reservoirs and achieves effective CO2 sequestration, but strong heterogeneity of the tight oil reservoir usually results in gas channeling and poor enhanced oil recovery effect. The existing methods to prevent gas channeling are mainly to use the small-molecule amine system and the polymer gel system to plug fracture and high permeability channels. The small-molecular amine system has low flash points and pollutes the environment and the polymer gel has poor injectivity and great damage to the formation, which limit their large-scale application. Therefore, a new viewpoint of CO2-low interfacial tension viscoelastic fluid synergistic flooding for enhanced oil recovery in a tight oil reservoir was made. The performance of low interfacial tension viscoelastic fluid (GOBT) was studied. The injectivity and oil displacement effect of CO2-GOBT synergistic flooding were evaluated, and the mechanism of CO2-GOBT synergistic flooding was discussed. The experimental results showed that 0.4% GOBT is a low interfacial tension viscoelastic fluid, which has strong adaptability to the salinity water of tight oil reservoirs (6788-80,000 mg/L), good viscosity stability at different pHs, excellent capacity to emulsify crude oil, and the ability to improve reservoir water wettability. CO2 alternating 0.4% GOBT flooding has good injection ability in cores (K a = 0.249 mD), and injecting 0.4% GOBT can effectively increase the injection pressure of subsequent CO2 flooding. CO2 alternating 0.4% GOBT flooding can effectively improve water flooding recovery in tight sandstone reservoirs, which is better than CO2 flooding and 0.4% GOBT flooding in both homogeneous and heterogeneous conditions. The mechanisms of CO2 alternating 0.4% GOBT flooding to enhance the oil recovery include that GOBT and CO2 foam block high permeability layers, shunt and sweep low permeability layers, and GOBT emulsify and wash oil. CO2 partially dissolving in GOBT synergistically enhances the core water wettability, which improves GOBT injectability, emulsification, and stripping ability to residual oil.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA