Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 7 de 7
Filtrar
Mais filtros

Base de dados
Tipo de documento
Intervalo de ano de publicação
1.
Nature ; 580(7804): 478-482, 2020 04.
Artigo em Inglês | MEDLINE | ID: mdl-32322080

RESUMO

Ultrathin ferroelectric materials could potentially enable low-power perovskite ferroelectric tetragonality logic and nonvolatile memories1,2. As ferroelectric materials are made thinner, however, the ferroelectricity is usually suppressed. Size effects in ferroelectrics have been thoroughly investigated in perovskite oxides-the archetypal ferroelectric system3. Perovskites, however, have so far proved unsuitable for thickness scaling and integration with modern semiconductor processes4. Here we report ferroelectricity in ultrathin doped hafnium oxide (HfO2), a fluorite-structure oxide grown by atomic layer deposition on silicon. We demonstrate the persistence of inversion symmetry breaking and spontaneous, switchable polarization down to a thickness of one nanometre. Our results indicate not only the absence of a ferroelectric critical thickness but also enhanced polar distortions as film thickness is reduced, unlike in perovskite ferroelectrics. This approach to enhancing ferroelectricity in ultrathin layers could provide a route towards polarization-driven memories and ferroelectric-based advanced transistors. This work shifts the search for the fundamental limits of ferroelectricity to simpler transition-metal oxide systems-that is, from perovskite-derived complex oxides to fluorite-structure binary oxides-in which 'reverse' size effects counterintuitively stabilize polar symmetry in the ultrathin regime.

3.
Adv Mater ; 32(23): e2000508, 2020 Jun.
Artigo em Inglês | MEDLINE | ID: mdl-32346899

RESUMO

Results of switching behavior of the improper ferroelectric LuFeO3 are presented. Using a model set of films prepared under controlled chemical and growth-rate conditions, it is shown that defects can reduce the quasi-static switching voltage by up to 40% in qualitative agreement with first-principles calculations. Switching studies show that the coercive field has a stronger frequency dispersion for the improper ferroelectrics compared to a proper ferroelectric such as PbTiO3 . It is concluded that the primary structural order parameter controls the switching dynamics of such improper ferroelectrics.

4.
Sci Rep ; 10(1): 3583, 2020 Feb 27.
Artigo em Inglês | MEDLINE | ID: mdl-32107393

RESUMO

A room temperature amorphous ferromagnetic oxide semiconductor can substantially reduce the cost and complexity associated with utilizing crystalline materials for spintronic devices. We report a new material (Fe0.66Dy0.24Tb0.1)3O7-x (FDTO), which shows semiconducting behavior with reasonable electrical conductivity (~500 mOhm-cm), an optical band-gap (2.4 eV), and a large enough magnetic moment (~200 emu/cc), all of which can be tuned by varying the oxygen content during deposition. Magnetoelectric devices were made by integrating ultrathin FDTO with multiferroic BiFeO3. A strong enhancement in the magnetic coercive field of FDTO grown on BiFeO3 validated a large exchange coupling between them. Additionally, FDTO served as an excellent top electrode for ferroelectric switching in BiFeO3 with no sign of degradation after ~1010 switching cycles. RT magneto-electric coupling was demonstrated by modulating the resistance states of spin-valve structures using electric fields.

5.
ACS Omega ; 2(6): 2925-2934, 2017 Jun 30.
Artigo em Inglês | MEDLINE | ID: mdl-31457627

RESUMO

We report comparative field electron emission (FE) studies on a large-area array of two-dimensional MoS2-coated @ one-dimensional (1D) brookite (ß) TiO2 nanorods synthesized on Si substrate utilizing hot-filament metal vapor deposition technique and pulsed laser deposition method, independently. The 10 nm wide and 760 nm long 1D ß-TiO2 nanorods were coated with MoS2 layers of thickness ∼4 (±2), 20 (±3), and 40 (±3) nm. The turn-on field (E on) of 2.5 V/µm required to a draw current density of 10 µA/cm2 observed for MoS2-coated 1D ß-TiO2 nanorods emitters is significantly lower than that of doped/undoped 1D TiO2 nanostructures, pristine MoS2 sheets, MoS2@SnO2, and TiO2@MoS2 heterostructure-based field emitters. The orthodoxy test confirms the viability of the field emission measurements, specifically field enhancement factor (ßFE) of the MoS2@TiO2/Si emitters. The enhanced FE behavior of the MoS2@TiO2/Si emitter can be attributed to the modulation of the electronic properties due to heterostructure and interface effects, in addition to the high aspect ratio of the vertically aligned TiO2 nanorods. Furthermore, these MoS2@TiO2/Si emitters exhibit better emission stability. The results obtained herein suggest that the heteroarchitecture of MoS2@ß-TiO2 nanorods holds the potential for their applications in FE-based nanoelectronic devices such as displays and electron sources. Moreover, the strategy employed here to enhance the FE behavior via rational design of heteroarchitecture structure can be further extended to improve other functionalities of various nanomaterials.

6.
ACS Appl Mater Interfaces ; 7(50): 27597-601, 2015 Dec 23.
Artigo em Inglês | MEDLINE | ID: mdl-26654105

RESUMO

A novel hybrid visible-light photodetector was created using a planar p-type inorganic NiO layer in a junction with an organic electron acceptor layer. The effect of different oxygen pressures on formation of the NiO layer by pulsed laser deposition shows that higher pressure increases the charge carrier density of the film and lowers the dark current in the device. The addition of a monolayer of small molecules containing conjugated π systems and carboxyl groups at the device interface was also investigated and with correct alignment of the energy levels improves the device performance with respect to the quantum efficiency, responsivity, and photogeneration. The thickness of the organic layer was also optimized for the device, giving a responsivity of 1.54 × 10(-2) A W(-1) in 460 nm light.

7.
Nanoscale ; 6(7): 3550-6, 2014 Apr 07.
Artigo em Inglês | MEDLINE | ID: mdl-24598944

RESUMO

An efficient self-powered photodetector design involving a C-Si hetero-interface with back-to-back MOS-Schottky (Pt-SiO2-Si-C-Pt) device action is presented. Pulsed laser deposition of a carbon thin film is used which dynamically removes the native surface oxide to form the desired Schottky interface. The combined device action yields two orders of magnitude photoresponse at zero bias.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA