Continuous hemofiltration model using porcine blood for comparing filter life.

The purpose of the present study was to establish a continuous hemofiltration model using porcine blood to compare filter life. Continuous hemofiltration (CHF) experiments were performed using an in vitro hemofilter evaluation system utilizing porcine blood containing trisodium citrate in addition to nafamostat mesilate as anticoagulants. The lifetime of the hemofilter was evaluated using the transmembrane pressure and the pressure drop across the hemofilter at varying trisodium citrate concentrations. The porcine blood used in this experiment was considered to be in a slightly hypercoagulable state because of the continuous contact with non-biological materials and calcium inflow from substitution fluid. Blood containing 7 or 8 mM of trisodium citrate and nafamostat mesilate could be effectively used to compare the lifetimes of hemofilters utilized under the same conditions. In this CHF model using porcine blood, the plugging of the hollow fibers occurred shortly after the plugging of the membrane pores. In conclusion, a CHF model using porcine blood can be established by adjusting the concentration of trisodium citrate added to the blood.

Effects of the tip structure of temporary indwelling catheters on blood recirculation at various blood flow rates and diameters of the mock blood vessel.

AIMS: The aim of the present study was to determine the effects of the tip structure of the catheters used for hemodialysis on blood recirculation at varying blood flow rates and diameters of the mock blood vessel in a well-defined in vitro experimental system, focusing on reverse connection mode. METHODS: A mock circulatory circuit was created with silicon tubing (15 or 20 mm), a circulatory pump, connected through the catheter to dialysis circuit and dialyzer attached to dialysis machine. The tip of the inserted catheter was fixed to the center of the silicone tube, and 3 L of pig blood was poured into the blood side of the dialyzer and the recirculation rates were measured at blood flow rates of 100, 150, and 200 mL/min. Five types of commercially available catheters were used: (A) Argyle™, (B) Gentle Cath™ (Hardness gradient type), (C) Gentle Cath™, (D) Niagara™, and (E) Power-Trialysis®. RESULTS: In the case of reverse connection mode, (1) the recirculation rates were lower in the catheter with a relatively large side hole (catheter C, 17%), catheters with a greater distance between the end hole and side hole (catheters C and D, 25%), and catheter with a symmetrical tip structure (catheter E, 10%) as compared with those in catheters A and B (40% and 25%); (2) increase of the blood flow rate in the dialysis machine was associated with a reduced recirculation rate; and (3) a wider inner diameter of the mock blood vessel and faster flow rate in the vessel were associated with a reduced recirculation rate. CONCLUSION: The lowest recirculation was observed with the catheter with symmetrical holes, which produces a helical blood flow line that does not intersect with the blood streamline flowing out to the blood supply hole.