Nuclear Quantum Effects on Nonadiabatic Dynamics of a Green Fluorescent Protein Chromophore Analogue: Ring-Polymer Surface-Hopping Simulation.

Herein, we have used the "on-the-fly" ring-polymer surface-hopping simulation method with the centroid approximation (RPSH-CA), in combination with the multireference OM2/MRCI electronic structure calculations to study the photoinduced dynamics of a green fluorescent protein (GFP) chromophore analogue in the gas phase, i.e., o-HBI, at 50, 100, and 300 K with 1, 5, 10, and 15 beads (3600 1 ps trajectories). The electronic structure calculations identified five new minimum-energy conical intersection (MECI) structures, which, together with the previous one, play crucial roles in the excited-state decay dynamics of o-HBI. It is also found that the excited-state intramolecular proton transfer (ESIPT) occurs in an ultrafast manner and is completed within 20 fs in all the simulation conditions because there is no barrier associated with this ESIPT process in the S1 state. However, the other excited-state dynamical results are strongly related to the number of beads. At 50 and 100 K, the nuclear quantum effects (NQEs) are very important; therefore, the excited-state dynamical results change significantly with the bead number. For example, the S1 decay time deduced from time-dependent state populations becomes longer as the bead number increases. Nevertheless, an essentially convergent trend is observed when the bead number is close to 10. In contrast, at 300 K, the NQEs become weaker and the above dynamical results converge very quickly even with 1 bead. Most importantly, the NQEs seriously affect the excited-state decay mechanism of o-HBI. At 50 and 100 K, most trajectories decay to the S0 state via perpendicular keto MECIs, whereas, at 300 K, only twisted keto MECIs are responsible for the excited-state decay. The present work not only comprehensively explores the temperature-dependent photoinduced dynamics of o-HBI, but also demonstrates the importance and necessity of NQEs in nonadiabatic dynamics simulations, especially at relatively low temperatures.

[Spatial-temporal Distribution and Source Analysis of Polycyclic Aromatic Hydrocarbons in the Sediments of Poyang Lake].

The concentrations, spatial-temporal distribution, and influencing factors of 16 polycyclic aromatic hydrocarbons (PAHs) in the sediments of Poyang Lake were studied, and a quantitative source analysis of PAHs in different areas of the lake was conducted. PAHs were widespread within the sediments. The concentrations of ∑16PAHs in the surface sediments of all sites ranged from 203 to 2 318 µg·kg-1. The concentrations of PAHs in the surface sediments of the lake body were higher than those in the surface sediments of the inlet rivers. The ratio of PAHs in Poyang Lake was 4 rings > 5 rings > 6 rings > 3 rings > 2 rings; the composition of 4-ring PAHs was dominant, and its content accounted for 86.11% of ∑16PAHs. The 2- and 3-ring and some 4-ring PAHs, including Flua and Pyr, were more susceptible to SOM, and the 4 through 6-ring PAHs were more susceptible to ORP and heavy metals and other environmental factors. Spatially, the higher concentration of ∑16PAHs occurred in the area of the lake adjacent to Duchang County and Poyang County, where the terrain was relatively closed, and the water exchange with the surrounding area was less than that in other sections, which was not conducive to the migration, transformation, and degradation of pollutants. In the temporal distribution, the changes in PAHs concentration level and the development of GDP in Jiangxi Province showed high consistency, and the influence of economic development and human activities might have been the main reason for the increasing PAHs concentration level. The main sources of PAHs in surface sediments of Poyang Lake included petroleum pollution and oil and coal and biomass combustion sources, and there were some spatial differences in PAHs sources in different regions. This study can provide a reference for PAHs pollution in surface sediments of Poyang Lake, which is important for the ecological environmental protection and management of Poyang Lake.

[Augmenting locking plate with autologous bone graft for the treatment of nonunion of long bone fracture in the lower extremity with retaining of the original intramedullary nail].

OBJECTIVE: To explore clinical effect of attaching locking plate with bone grafting based on retaining the original intramedullary nail in treating non-union after intramedullary nail fixation of long shaft fractures of lower limbs. METHODS: A retrospective study was conducted on 20 patients treated with non-union fractures after intramedullary nailing of long shaft fractures of lower limbs from June 2015 to June 2020. All patients were treated with the original intramedullary nailing and bone grafting from the iliac bone, and were underwent open reduction plate internal fixation and bone grafting for old fractures. Among them, 14 were males and 6 were females, aged from 35 to 56 years old with an average of (42.2±9.6) years old. Nine patients were femoral shaft fracture and 11 patients were tibial shaft fracture. According to characteristics of fracture end nonunion, 6 patients were stable/atrophic, 9 patients were unstable/large, and 5 patients were unstable/atrophic. The nonunion time ranged from 8 to 12 months with an average of(9.8±2.0) months after the initial surgery. Visual analogue scale (VAS), knee range of motion, bone healing time, complications and fracture-end healing were recorded before and at the latest follow-up. RESULTS: All patients were followed up for 18 to 48 months with an average of (36.3±10.5) months. The incision of all patients were healed at stageⅠwithout complications such as infection or internal fixation ruptur. Healing time of femur and tibia was (8.5±2.6) months and (9.5±2.2) months. Knee joint motion increased from preoperative (101.05±8.98) ° to postoperative (139.35±8.78) ° at the latest follow-up (t=-12.845, P<0.001). VAS decreased from preoperative (5.15±1.72) to postoperative (0.75±0.96) at the latest follow-up (t=11.186, P<0.001). CONCLUSION: On the basis of retaining the original intramedullary nail, the addition of locking plate internal fixation and autogenous iliac bone grafting have advantages of simple operation, less trauma, fewer complications and high fracture healing rate. It is one of the effective surgical schemes for the treatment of nonunion after intramedullary nail fixation of long bone fracture of lower extremity.