Heterostructure of Si and CoSe2: A Promising Photocathode Based on a Non-noble Metal Catalyst for Photoelectrochemical Hydrogen Evolution.

Development of a solar water splitting device requires design of a low-cost, efficient, and non-noble metal compound as alternative to noble metals. For the first time, we showed that CoSe2 can function as co-catalyst in phototoelectrochemical hydrogen production. We designed a heterostructure of p-Si and marcasite-type CoSe2 for solar-driven hydrogen production. CoSe2 successively coupled with p-Si can act as a superior photocathode in the solar-driven water splitting reaction. Photocurrents up to 9 mA cm(-2) were achieved at 0 V vs. reversible hydrogen electrode. Electrochemical impedance spectroscopy showed that the high photocurrents can be attributed to low charge transfer resistance between the Si and CoSe2 interfaces and that between the CoSe2 and electrolyte interfaces. Our results suggest that this CoSe2 is a promising alternative co-catalyst for hydrogen evolution.

Amorphous Phosphorus-Doped Cobalt Sulfide Modified on Silicon Pyramids for Efficient Solar Water Reduction.

Cobalt sulfide (CoS x) functioned as a co-catalyst to accelerate the kinetics of photogenerated electrons on Si photocathode, leading to the enhancement of solar hydrogen evolution efficiency. By doping phosphorus heteroatoms, CoS x materials showed an improved catalytic activity because of superior surface area and quantity of active sites. Furthermore, increased vacancies in unoccupied electronic states were observed, as more phosphorus atoms doped into CoS x co-catalysts. Although these vacant sites improved the capability to accept photoinduced electrons from Si photoabsorber, chemisorption energy of atomic hydrogen on catalysts was the dominant factor affecting in photoelectrochemical performance. We suggested that P-doped CoS x with appropriate doping quantities showed thermoneutral hydrogen adsorption. Excess phosphorus dopants in CoS x contributed to excessively strong adsorption with H atoms, causing the poor consecutive desorption ability of photocatalytic reaction. The optimal P-doped CoS x-decorated Si photocathode showed a photocurrent of -20.6 mA cm-2 at 0 V. Moreover, a TiO2 thin film was deposited on the Si photocathode as a passivation layer for improving the durability. The current density of 10 nm TiO2-modified photocathode remained at approximately -13.3 mA cm-2 after 1 h of chronoamperometry.

Wide Range pH-Tolerable Silicon@Pyrite Cobalt Dichalcogenide Microwire Array Photoelectrodes for Solar Hydrogen Evolution.

This study employed silicon@cobalt dichalcogenide microwires (MWs) as wide range pH-tolerable photocathode material for solar water splitting. Silicon microwire arrays were fabricated through lithography and dry etching technologies. Si@Co(OH)2 MWs were utilized as precursors to synthesize Si@CoX2 (X = S or Se) photocathodes. Si@CoS2 and Si@CoSe2 MWs were subsequently prepared by thermal sulfidation and hydrothermal selenization reaction of Si@Co(OH)2, respectively. The CoX2 outer shell served as cocatalyst to accelerate the kinetics of photogenerated electrons from the underlying Si MWs and reduce the recombination. Moreover, the CoX2 layer completely deposited on the Si surface functioned as a passivation layer by decreasing the oxide formation on Si MWs during solar hydrogen evolution. Si@CoS2 photocathode showed a photocurrent density of -3.22 mA cm(-2) at 0 V (vs RHE) in 0.5 M sulfuric acid electrolyte, and Si@CoSe2 MWs revealed moderate photocurrent density of -2.55 mA cm(-2). However, Si@CoSe2 presented high charge transfer efficiency in neutral and alkaline electrolytes. Continuous chronoamperometry in acid, neutral, and alkaline solutions was conducted at 0 V (vs RHE) to evaluate the photoelectrochemical durability of Si@CoX2 MWs. Si@CoS2 electrode showed no photoresponse after the chronoamperometry test because it was etched through the electrolyte. By contrast, the photocurrent density of Si@CoSe2 MWs gradually increased to -5 mA cm(-2) after chronoamperometry characterization owing to the amorphous structure generation.