RESUMO
As a type of intelligent dimming film, polymer-dispersed liquid crystals (PDLCs) have been widely applied in various fields, such as smart windows, light shutters and displays. The properties of PDLCs are greatly influenced by the structure of the raw materials. In this work, the impact of crosslinking agents with different cyclic or chain groups was investigated by comparing the electro-optical performance and the morphology of the polymer matrix in the as-made PDLC films. It was found that the incorporation of large steric groups into the crosslinking agents can alter the morphology of the polymer matrix and thus affect the electro-optical properties. However, the impact is distinct when the spatial structure or rigidity is different. Besides, a combination of crosslinking agents with flexible alkyl-chain structures and steric structures can further reduce the threshold voltage while keeping the high contrast ratio. After detailed comparison, an optimized combination of BDDA/TCDDA in a weight ratio of 1/1 is selected to demonstrate the enhanced properties of the as-constructed film with a thickness of 20 µm. It exhibits low threshold voltage (8.2 V), low saturation voltage (21.2 V) and a high contrast ratio (203) simultaneously. This research offers an optimizing method from the crosslinking agent perspective and is anticipated to promote the further improvement of the PDLC's performance.
RESUMO
As a type of smart dimming film, polymer-dispersed liquid crystals (PDLCs) show great prospects in the fields of indoor partition, electronic curtains, and automobile windows. However, its high off-axis haze greatly impacts the application scope. This obvious shortcoming is mainly caused by the serious mismatch between the effective refractive index of the liquid crystal (neff) and the refractive index of the polymer matrix (np) at large viewing angles. Thereby, factors affecting the viewing angle of a PDLC film are analyzed in this research, including the birefringence of the liquid crystal (Δn), film thickness, and the refractive index of the polymer matrix (np). Balanced electro-optical properties are guaranteed simultaneously. It is found that high on-state transmittance and low off-axis haze can be achieved at large viewing angles in the suggested optimized case where Δn is within the range of 0.1-0.13; the film thickness is between 20 µm and 15 µm; and np approaches no but the difference does not exceed 0.03.
RESUMO
With the switchability between transparent and light-scattering states, polymer-dispersed liquid crystals (PDLC) are widely used as smart windows, flexible display devices, projectors, and other devices. In outdoor applications, in addition to excellent electro-optical properties, there is also a high demand for film stability. In this work, a PDLC film with high mechanical strength and structural stability is prepared that can maintain stability at 80 °C for 2000 h. By choosing liquid crystals with a wide temperature range, adopting acrylate polymer monomers containing hydroxyl groups, and adjusting the polymer content, the PDLC film can work well from -20 °C to 80 °C. On this basis, the effects of the introduction of rigid monomers on the mechanical properties and electro-optical properties of PDLC films are investigated.
Assuntos
Cristais Líquidos , PolímerosRESUMO
Biaxiality and chirality are two of the most interesting topics in materials and biological science, particularly in liquid crystals. What is even more interesting is that these two properties are related. It was theoretically predicted that morphological chirality is impossible without morphological biaxiality in chiral nematic liquid crystals. We experimentally study the effect of biaxiality on chirality. We show that when achiral liquid crystal dimers with large molecular biaxiality are doped into chiral nematic liquid crystals, their helical pitch is significantly decreased. We have also observed an abnormal fingerprint texture of the chiral nematic liquid crystal doped dimers, which suggests morphological biaxiality. Our experimental results support the biaxial theory of chiral nematic liquid crystals.
RESUMO
When subjected to an AC electric field perpendicular to its layers, the cholesteric planar state may undergo a periodic layer undulation, known as the Helfrich deformation, which generates a color change of the reflected light. The Helfrich deformation of regular cholesteric liquid crystals is, however, unstable and easily taken over by the focal conic state, and thus the color tuning range is narrow. We demonstrated that the Helfrich deformation can be stabilized in a large electric field region by doping a bent dimer with an anomalously small bend elastic constant and dispersing a small amount of polymer network. By varying the dimer concentration, we were able to systematically change the bend elastic constant and thus verify the theoretical prediction of the undulation threshold electric field and periodicity. We also achieved reflectance tuning with electric field less than 2 V µm-1 and color tuning covering the entire visible light region with electric field as low as 4 V µm-1.
RESUMO
Controlling self-assembly behaviors of liquid crystals is a fundamental issue for designing them as intelligent actuators. Here, anisotropic porous polyvinylidene fluoride film is utilized as a template to induce homogeneous alignment of liquid crystals. The mechanism of liquid crystal alignment induced by anisotropic porous polyvinylidene fluoride film is illustrated based on the relationship between the alignment behavior of liquid crystals and surface microstructure of anisotropic polyvinylidene fluoride film. Liquid crystal elastomer actuators with fast responsiveness, large strain change, and reversible actuation behaviors are achieved by the photopolymerization of liquid crystal monomer in liquid crystal cells coated with anisotropic porous films.
Assuntos
Elastômeros/síntese química , Cristais Líquidos/química , Polímeros/química , Anisotropia , Elastômeros/química , Polivinil/química , PorosidadeRESUMO
Chiral nematic liquid crystals possess a self-assembled helical structure and exhibit unique selective reflection in visible and infrared light regions. Their optical properties can be electrically tuned. The tuning involves the unwinding and restoring of the helical structure. We carried out an experimental study on the mechanism of the restoration of the helical structure. We constructed chiral nematic liquid crystals with variable elastic constants by doping bent-dimers and studied their impact on the restoration. With matched twist and bend elastic constants, the helical structure can be restored dramatically fast from the field-induced homeotropic state. Furthermore, defects can be eliminated to produce a perfect planar state which exhibits high selective reflection.
RESUMO
Polymer-stabilized liquid crystal (PSLC) is a promising material toward the practical application of serving as energy-saving reverse-mode smart windows owing to its superior electro-optical (E-O) properties, simple and efficient processability, and compatibility to most practical circumstances. However, its feeble peel strength originated from low polymer content and poor adhesion between polymer networks and substrates inhibited its large-scale flexible film production. It is still a challenging task to derive good mechanical properties and superior E-O performance for PSLCs at the same time. In this study, a highly durable liquid crystal/polymer composite film showing enhanced peel strength and excellent E-O properties was attained by simultaneously building photoreactive self-assemble alignment layers through an efficient one-step method and the sculpture of a patterned polymer wall structure. This film has comprehensive ascendant E-O properties of lower driving voltages, faster response times, and higher contrast ratio, together with an over 30 times lift of the peel strength. The effectuation mechanisms of the alignment, E-O properties, peel-strength, microstructures, and cyclic durability of the films have been systematically studied. This novel liquid crystal/polymer composite film demonstrates advantages in every aspect of performance compared to traditional PSLC devices, which hoards promising applications in smart windows for cars and buildings.
RESUMO
Smart windows with synergetic light modulation have heightened demands for applications in smart cars and novel buildings. However, improving the on-demand energy-saving efficiency is quite challenging due to the difficulty of modulating sunlight with a broad bandwidth in an energy-saving way. Herein, a smart window with switchable near-infrared light transmittance and passive radiative cooling is prepared via a monomer design strategy and photoinduced polymerization. The effects of hydrogen bonds and fluorine groups in acrylate monomers on the electro-optical properties as well as microstructures of polymer-dispersed liquid crystal films have been systematically studied. Some films show a high contrast ratio of 90.4 or a low threshold voltage (Vth) of 2.0 V, which can be roll-to-roll processed in a large area. Besides, the film has a superior indoor temperature regulation ability due to its passive radiative cooling and controllable near-infrared light transmittance properties. Its radiative cooling efficiency is calculated to be 142.69 W/m2 and NIR transmittance could be switched to below 10%. The introduction of a carboxylic monomer and fluorinated monomer into the system endows the film with a highly efficient temperature management capability. The film has great potential for applications in fields such as flexible smart windows, camouflage materials, and so on.
RESUMO
Objective: To analyse the short-term clinical results of the effect of apically repositioned flap combined with free gingival graft to widen keratinized tissue in implant area, so as to provide a basis for its clinical application. Methods: Fifteen patients with intraoral single or multiple missing teeth, who did not undergo implant restoration or who re-examined after implant restoration completed were included, along with KW less than 1-2 mm on the buccal side of the median line of the alveolar ridge crest in the implant area, or KW less than 1-2 mm on the buccal side of the abutments and dental crown margins. All underwent apically repositioned flap combined with free gingival graft, which were reviewed. Results: Fifteen patients with missing keratinized gingivae underwent free gingival flap graft, survived with all grafted gingival flaps. Compared with before implantation, significant keratinized tissue widening and area gain were obtained at 1 and 3 months postoperatively. Conclusion: The free gingival flap graft can significantly widen the buccal keratinized mucosa of the implant, and to some extent maintains the health status of the implant, which is worthy of clinical promotion and application.
Assuntos
Gengiva , Mucosa Bucal , Humanos , Gengiva/transplante , Mucosa Bucal/cirurgia , Assistência Odontológica , Retalhos Cirúrgicos/transplanteRESUMO
Polymer-dispersed liquid crystals (PDLCs) show great application potential in the areas of displays and smart windows. However, their electro-optical (E-O) properties such as contrast ratio and threshold voltage still need further improvement. In this study, the effects of α-substituted acrylate monomers on the morphology and E-O properties of PDLC composite films were systematically studied. It was found that the large substituent tended to increase the void size of the polymer matrix, while the small fluorine substitution led to a microsphere-type polymer morphology, which deteriorated the E-O performance. Finally, a largely improved E-O performance of low threshold voltage (0.437 V/µm), low saturation voltage (1.012 V/µm), and high contrast ratio (27) was achieved in an 8 µm-thick film by the addition of a chlorine-substituted monomer. This study provides a new approach for optimizing PDLCs from a material perspective.
RESUMO
Light-emitting diodes (LEDs) based on all-inorganic lead halide perovskite quantum dots (PQDs) have undergone rapid development especially in the past five years, and external quantum efficiencies (EQEs) of the corresponding green- and red-emitting devices have exceeded 23%. However, the blue-emitting devices are facing greater challenges than their counterparts, and their poor luminous efficiency has hindered the display application of PQD-based LEDs (PeQLEDs). This review focuses on the key challenges of blue-emitting PeQLEDs including low EQEs, short operating lifetime, and spectral instability, and discusses the essential mechanism by referring to the latest research. We then systematically summarize the development of preparation methods of blue emission PQDs, as well as the current strategies on alleviating the poor device performance involved in composition engineering, ligand engineering, surface/interface engineering, and device structural engineering. Ultimately, suggestions and outlooks are proposed around the major challenges and future research direction of blue PeQLEDs.
RESUMO
Electron transport layers (ETLs) play a key role in the electron transport properties and photovoltaic performance of solar cells. Although the existing ETLs such as TiO2, ZnO and SnO2 have been widely used to fabricate high performance solar cells, they still suffer from several inherent drawbacks such as low electron mobility and poor chemical stability. Therefore, exploring other novel and effective electron transport materials is of great importance. Gallium nitride (GaN) as an emerging candidate with excellent optoelectronic properties attracts our attention, in particular its significantly higher electron mobility and similar conduction band position to TiO2. Here, we mainly focus on the investigation of interfacial carrier transport properties of a GaN epilayer/quantum dot hybrid structure. Benefiting from the quantum effects of QDs, suitable energy level arrangements have formed between the GaN and CdSe QDs. It is revealed that the GaN epilayer exhibits better electron extraction ability and faster interfacial electron transfer than the rutile TiO2 single crystal. Moreover, the corresponding electron transfer rates of 4.44 × 108 s-1 and 8.98 × 108 s-1 have been calculated, respectively. This work preliminarily shows the potential application of GaN in quantum dot solar cells (QDSCs). Carefully tailoring the structure and optoelectronic properties of GaN, in particular realizing the low-temperature deposition of high-quality GaN on various substrates, will significantly promote the construction of highly efficient GaN-ETL based QDSCs.
RESUMO
Cellular senescence refers to the permanent arrest of cell cycle caused by intrinsic and/or extrinsic stressors including oncogene activation, irradiation, DNA damage, oxidative stress, and certain cytokines (including senescence associated secretory phenotype). Cellular senescence is an important factor in aging. Accumulation of senescent cells has been implicated in the causation of various age-related organ disorders, tissue dysfunction, and chronic diseases. It is widely accepted that the biological effects triggered by low-dose radiation (LDR) are different from those caused by high-dose radiation. Experimental evidence suggests that LDR may promote growth and development, enhance longevity, induce embryo production, and delay the progression of chronic diseases. The underlying mechanisms of these effects include modulation of immune response, stimulation of hematopoietic system, antioxidative effect, reduced DNA damage and improved ability for DNA damage repair. In this review, we discuss the possible mechanisms by which LDR prevents senescence and aging from the perspectives of inhibiting cellular senescence and promoting the removal of senescent cells. We review a wide broad of evidence about the beneficial impact of LDR in senescence and aging models (including cardiovascular diseases, neurological diseases, arthritis and osteoporosis, chronic obstructive pulmonary disease and idiopathic pulmonary fibrosis) to highlight the potential value of LDR in preventing aging and age-related diseases. However, there is no consensus on the effect of LDR on human health, and several important aspects require further investigation.