RESUMO
The deleterious impact of lead (Pb) pollution on human health is evident in both domestic and occupational settings, provoking an inflammatory response across multiple tissue, limited attention has been devoted to its adverse effects on colitis and the underlying mechanisms. Peiminine (PMI) has been recognized for its anti-inflammatory properties, yet its specific anti-inflammatory effects in lead-induced colitis models remain elusive. Through the establishment of both in vivo and in vitro lead exposure models, suggests that lead exposure can induce colitis and that PMI regulates lead exposure-induced colitis by inhibiting the NF-kB signaling pathway, and alleviates the ability of lead to apoptosis and inflammation levels in intestinal epithelial cells. Consequently, these results present a promising avenue for further exploration of the molecular mechanisms underlying lead-induced colitis, evaluation of the associated risks linked to lead exposure, and the development of therapeutic interventions for colitis resulting from lead exposure.
RESUMO
Solid fuel is the most widely used energy source for cooking and heating in the rural households in developing countries. In this study, emissions from 13 fuel-stove combinations were studied in two typical rural villages in the Fenhe Basin, Shanxi Province, China. This study gathered data on the emission characteristics of particles with an aerodynamic diameter of ≤2.5 µm (PM2.5), organic carbon (OC), elemental carbon (EC), and 21 parent and oxygenated polycyclic aromatic hydrocarbons (pPAHs and oPAHs, respectively); the mechanism of gas formation was also determined. The PM2.5 EFs of biomass burning ranged from 4.11 ± 2.12 to 138 ± 47.2 g/kg, which was higher than that of coal combustion (1.57 ± 0.89 to 4.11 ± 0.63 g/kg). Notably, the average PM2.5 EFs of biomass burning in a traditional stove and elevated kang were 50.9 ± 13.8 and 23.0 ± 3.99 g/kg, respectively, suggesting that the elevated kang had superior emission mitigation. Wood pellet burning in a biomass furnace yielded lower PM2.5 EFs than firewood burning in the biomass furnace, which demonstrated wood pellet combustion's superior emission reduction effect. The relative contribution of OC4 to OC subfractions may be useable as tools for identifying the sources of coal and biomass burning. Regarding PAHs, biomass with abundant lignin pyrolysis produced numerous hydroxyl radicals that were conducive to the release of greater proportions of oPAHs. By contrast, pPAHs had greater relative contributions in coal combustion. Regarding gaseous pollutants, its formation mechanism varied with combustion phase. Emission differences between the two phases were mainly determined by the relative contributions of volatile C/N and char. Clarifying the pollutant formation mechanism can better guide the implementation of emission control from household solid fuel combustion.
Assuntos
Poluentes Atmosféricos , Hidrocarbonetos Policíclicos Aromáticos , Poluentes Atmosféricos/análise , Carbono/análise , China , Carvão Mineral/análise , Material Particulado/análise , Hidrocarbonetos Policíclicos Aromáticos/análiseRESUMO
This study examined volatile organic compounds (VOCs) emitted from the combustion of seven typical biomass fuel types in a traditional stove, elevated kang, and biomass furnace and from the combustion of three types of coal in coal furnaces. The results revealed that emission factors (EFs) of VOCs emitted from combustion processes ranged from 48.8 ± 29.1 mg/kg (for anthracite combustion in an outdoor boiler) to 5700 ± 6040 mg/kg (for sesame straw combustion in a traditional stove). Changing the fuel type engendered a more significant EF reduction (82.7%) than changing the stove type (51.8%). The emitted VOCs (including oxygenated VOCs, OVOCs) can be ordered as follows (in descending order) in terms of proportion: OVOCs > alkenes > aromatic VOCs > alkanes > halo hydrocarbons > alkynes. These results indicate solid fuel combustion processes warrant attention because they produce high OVOC emissions. The ozone formation potential (OFP) values derived for VOCs emitted from solid fuel combustion ranged from 5.83 ± 0.72 to 1910 ± 1750 mg/kg. Clean fuel and clean stove technologies both exhibited >80% efficiency levels in reducing OFP emissions (e.g., 80.6% reduction for the optimal fuel; 89.4% reduction for a clean stove). Therefore, the difference between VOC emission profiles from different combustion technologies should not be ignored. This study also noted substantial differences between VOC emissions from residential combustion and industrial combustion. Accordingly, attention should be paid to the local characteristics of fuels and stoves and to VOC emissions from residential combustion.
Assuntos
Poluentes Atmosféricos , Ozônio , Compostos Orgânicos Voláteis , Poluentes Atmosféricos/análise , Compostos Orgânicos Voláteis/análise , Rios , Monitoramento Ambiental , Ozônio/análise , Carvão Mineral , ChinaRESUMO
Volatile organic compounds (VOCs) emitted from solid fuels combustion (e.g., biomass and coal) are still the dominant precursors for the formation of tropospheric ozone (O3) and secondary organic aerosols (SOAs). Limited research focused on the evolution, as known as atmospheric aging, of VOCs emitted during long-timescale observations. Here, freshly emitted and aged VOCs from common residual solid fuel combustions were collected onto absorption tubes before and after passing through an oxidation flow reactor (OFR) system, respectively. The emission factor (EF) of freshly emitted total VOCs is in descending order of corn cob ≥ corn straw > firewood ≥ wheat straw > coals. Aromatic and oxygenated VOCs (OVOCs) are the two most abundant groups, accounting for >80% of the EF of total quantified VOCs (EFTVOCs). Briquette technology shows an effective reduction of the VOC emission, demonstrating a maximum 90.7% lower EFTVOCs in comparison to that of biomass fuels. In contrast, each VOC shows significantly different degradation in comparison to EF of freshly emitted and after 6- and 12-equivalent day aging (actual atmospheric aging days calculated from aging simulation). The largest degradations after 6-equivalent days of aging are observed on alkenes in the biomass group (60.9% on average) and aromatics in the coal group (50.6% on average), consistent with their relatively high reactivities toward oxidation with O3 and hydroxyl radical. The largest degraded compound is seen for acetone, followed by acrolein, benzene, and toluene. Furthermore, the results show that the distinction of VOC species based on long-timescale (12-equivalent day aging) observation is essential to further explore the effect of regional transport. The alkanes which have relatively lower reactivities but high EFs could be accumulated through long-distance transport. These results provide detailed data on fresh and aged VOCs emitted from residential fuels which could be used to explore the atmospheric reaction mechanism.
Assuntos
Poluentes Atmosféricos , Ozônio , Compostos Orgânicos Voláteis , Poluentes Atmosféricos/análise , Compostos Orgânicos Voláteis/análise , Monitoramento Ambiental , Carvão Mineral , China , Ozônio/análiseRESUMO
To characterize the emissions of polycyclic aromatic hydrocarbons (PAHs) from residential biomass burning and coal combustion in field environments, smoke samples were collected from the combustion of six types of biomass in heated kangs and four types of coal in traditional stoves and semi-gasifier stoves. The emission factors (EFs) of the total PAH were in the range of 84.5-344 mg/kg for biomass burning, with lower EFs for biomass with higher densities, and in the range of 38.0-206 mg/kg for coal combustion, with lower EFs for coals with higher maturity. Moreover, EFs were lower from high-density biomass fuels (wood trunk, 84.5 ± 11.3 mg/kg) than low-maturity coals (bituminous coal, 206 ± 16.5 mg/kg). Parent, oxygenated, alkylated, and nitrated PAHs accounted for 81.1%, 12.6%, 6.2%, and 0.1%, respectively, of the total-PAH EFs from biomass burning, and 84.7%, 13.8%, 1.4%, and 0.1%, respectively, of the total-PAH EFs from coal combustion. PAH source profiles differed negligibly between biomass fuels but differed significantly between bituminous coal and anthracite coal fuels. The characteristic species of sources were phenanthrene, 9-fluorenone, and 2-nitrobiphenyl for biomass burning, and were phenanthrene, benzo[ghi]perylene, 1,4-naphthoquinone, and 2-nitrobiphenyl for coal combustion. The ratios of benzo[b]fluoranthene/(benzo[b]fluoranthene + benzo[k]fluoranthene) were 0.40-0.45 for biomass burning and 0.89-0.91 for coal combustion, and these significantly different values constitute unique markers for distinguishing these fuels in source apportionment. Benzo[a]pyrene-equivalent factor emissions were 2.79-11.3 mg/kg for biomass and 7.49-41.9 mg/kg for coal, where parent PAHs contributed 92.0%-95.1% from biomass burning and 98.6%-98.8% from coal combustion. Total-PAH emissions from residential heating were 1552 t across Shaanxi province, to which wheat straw (445 t) in biomass burning and bituminous coal (438 t) in coal combustion were the highest contributors. Results from this study provide crucial knowledge for the source identification of PAHs as well as for the design of abatement strategies against pollutant emissions.