Preparation and evaluation of molding-type solid-phase extraction media binding with commercially available adhesives.

A fabrication method of molding-type solid-phase extraction media (M-SPEM) bound with commercially available adhesive is presented. Six pieces of M-SPEM were prepared by heating each kneaded product of a particulate sorbent and an adhesive inserted into a six-hole cylindrical mold for hardening under an open system and normal pressure. The particulate sorbent contained in M-SPEM was divinylbenzene-based reversed-phase mode solid-phase extractants that we have reported. An examination of several adhesives showed that the moldability of M-SPEM depended on the composition and properties of the adhesive. The optimized procedure can be used to prepare an M-SPEM containing an 85 wt% particulate sorbent (particulate sorbent/adhesive, 100 mg/17 mg; particle diameter, 90-150 µm), and the M-SPEM has a specific surface area of about 500 m2/g. The established procedure in this study can bind particulate sorbents together, which showed almost no reductions in the adsorption property and liquid permeability compared with those of the particulate sorbent.

Molding-type Solid-phase Extraction Media Glued with Commercially Available Adhesives.

The handling of a particulate sorbent for solid-phase extraction is often troublesome because it causes static clinging and scattering. To overcome this problem, a production method for a simple molding-type solid-phase extraction medium (M-SPEM) was developed in this study by using commercially available adhesives. The content of a particulate sorbent can increase to as much as 85 wt% in the M-SPEM. Because of the high content, the proposed M-SPEMs have a higher specific surface area than previous monolithic media.