Dispersive liquid-liquid microextraction followed by reversed phase HPLC for the determination of decabrominated diphenyl ether in natural water.

A simple, rapid, and efficient method, dispersive liquid-liquid microextraction (DLLME), has been developed for the extraction and preconcentration of decabrominated diphenyl ether (BDE-209) in environmental water samples. The factors relevant to the microextraction efficiency, such as the kind and volume of extraction and dispersive solvent, the extraction time, and the salt effect, were optimized. Under the optimum conditions (extraction solvent: tetrachloroethane, volume, 22.0 microL; dispersive solvent: THF, volume, 1.00 mL; extraction time: below 5 s and without salt addition), the most time-consuming step is the centrifugation of the sample solution in the extraction procedure, which is about 2 min. In this method, the enrichment factor could be as high as 153 in 5.00 mL water sample, and the linear range, correlation coefficient (r(2)), detection limit (S/N = 3), and precision (RSD, n = 6) were 0.001-0.5 microg/mL, 0.9999, 0.2 ng/mL, and 2.1%, respectively. This method was successfully applied to the extraction of BDE-209 from tap, East Lake, and Yangtse River water samples; the relative recoveries were 95.8, 92.9, and 89.9% and the RSD% (n = 3) were 1.9, 2.7, and 3.5%, respectively. Comparison of this method with other methods, such as solid-phase microextraction (SPME), and single-drop microextraction (SDME), indicates that DLLME is a simple, fast, and low-cost method for the determination of BDE-209, and thus has tremendous potential in polybrominated diphenyl ethers (PBDEs) residual analysis in environmental water samples.

An intercalibration study on organobromine compounds: Results on polybrominated diphenylethers and related dioxin-like compounds.

An intercalibration study on organobromine compounds has been conducted to evaluate the accuracy and reliability in the analysis of brominated flame retardants (BFRs) such as polybrominated diphenyl ethers (PBDEs) and their related compounds like polybrominated and monobromo-polychlorinated dibenzodioxins and -furans (PBDDs/DFs, MoBPCDDs/DFs). This paper reports the results for these compounds in 'Mixed Standard Solutions' and 'Air-Dried Sediment'. The relative standard deviations (RSDs) for PBDEs, PBDDs/DFs and MoBPCDDs/DFs in mixed standard solutions ranged from 9% to 24%, 4% to 20% and 8% to 27%, respectively. The results of this study are better than those reported in earlier international interlaboratory studies due to general improvement in analytical methods and an increasing number of available authentic standards, particularly for PBDEs. In the analysis for higher brominated compounds such as octabromodibenzodioxin, the participants were advised to optimize the calibration curves befitting the range of concentrations found in samples because variation of relative response factors was noted. The results for 'Air-Dried Sediment' were also reasonable with RSDs from 10% to 38% for PBDEs, 8% to 38% for PBDDs/DFs and 17% to 36% for MoBPCDDs/DFs. In the sediment sample, possible errors in the sample pretreatment and/or interference by other compounds/impurities were indicated. The concentrations of pentabromodiphenylether, BDE100, varied more than the other PBDE isomers due to its poor separation in some chromatographic conditions. In addition, interference by PBDEs was observed in the analysis for PBDFs. Potential degradation/secondary formulation of PBDEs and PBDFs during the Soxhlet extraction were suggested when copper powder was added into the sediment samples. Inspite of these observations, the results in this study are better than those reported in other interlaboratory studies due to the advice given to participants for improving the results. Compared with the results for PCDDs/DFs (5-23% RSDs) and Co-PCBs (6-24% RSDs), the RSDs for most of the organobromine compounds were high, indicating an immature QA/QC approach for the analysis of PBDEs and related compounds in comparison to common chlorinated dioxins.

Polybrominated diphenyl ether congeners and toxaphene in selected marine standard reference materials.

Polybrominated diphenyl ether (PBDE) congeners and components of the complex mixture toxaphene are stable in the environment and readily bioaccumulated into wildlife and human tissues. PBDEs are presently used in large quantities worldwide as flame retardants in textiles, furniture, computer equipment, and cables. Toxaphene is a complex mixture of chlorinated bornanes and bornenes that was the most heavily used pesticide in the United States until it was banned in 1982; however, some countries continue to use toxaphene. The National Institute of Standards and Technology has quantified PBDE congeners and toxaphene in several available Standard Reference Materials (SRMs) using methods of gas chromatography with electron impact mass spectrometry (GC-EI-MS) and GC negative chemical ionization (NCI) MS, respectively. SRM 1588a Organics in Cod Liver Oil and SRM 1945 Organics in Whale Blubber were examined for PBDE congeners 47, 99, 100, 153, and 154, total toxaphene, and toxaphene congeners 26, 50, and 62. SRM 1946 Lake Superior Fish Tissue was also examined for total toxaphene and toxaphene congeners. The sum of the PBDE congeners (mean, (1 SD) wet basis) for SRM 1945 was 150 ng g(-1) (7 ng g(-1)). The concentration of PBDE 47 in SRM 1588a was 82.7 ng g(-1) (2.8 ng g(-1)). Other PBDEs were detected in SRM 1588a but were not quantified due their low levels. The total toxaphene (wet mass basis) was 1,210 ng g(-1) (127 ng g(-1)), 1,960 ng g(-1) (133 ng g(-1)), and 3,980 ng g(-1) (248 ng g(-1)) in SRMs 1945, 1946, and 1588a, respectively. The values for PBDEs and toxaphene determined in the SRMs, while not certified, indicate that the SRMs will be suitable control materials for PBDE and toxaphene analyses.