Effect of Al2O3 (x = 0, 1, 2, and 3 vol.%) in CrFeCuMnNi-x High-Entropy Alloy Matrix Composites on Their Microstructure and Mechanical and Wear Performance.

This work aims to study the influence of Al2O3 in CrFeCuMnNi high-entropy alloy matrix composites (HEMCs) on their microstructure, phase changes, and mechanical and wear performances. CrFeCuMnNi-Al2O3 HEMCs were synthesized via mechanical alloying (MA) followed by hot compaction (550 °C at 550 MPa), medium frequency sintering (1200 °C), and hot forging (1000 °C at 50 MPa). The XRD results demonstrate the formation of both FCC and BCC phases in the synthesized powders, which were transformed into major stable FCC and minor ordered B2-BCC phases, as confirmed by HRSEM. The microstructural variation of HRSEM-EBSD, in terms of the coloured grain map (inverse pole figures), grain size distribution, and misorientation angle, was analysed and reported. The grain size of the matrix decreased with the increase in Al2O3 particles owing to the higher structural refinement by MA and zener pinning of the incorporated Al2O3 particles. The hot-forged CrFeCuMnNi-3 vol.% Al2O3 sample exhibited an ultimate compressive strength of 1.058 GPa, which was 21% higher than that of the unreinforced HEA matrix. Both the mechanical and wear performance of the bulk samples increased with an increase in Al2O3 content due to solid solution formation, high configurational mixing entropy, structural refinement, and the effective dispersion of the incorporated Al2O3 particles. The wear rate and coefficient of friction values decreased with the increase in Al2O3 content, indicating an improvement in wear resistance owing to the lower domination of abrasive and adhesive mechanisms, as evidenced by the SEM worn surface morphology.

Investigation of the Microstructure and Compressibility of Biodegradable Fe-Mn-Cu/W/Co Nanostructured Alloy Powders Synthesized by Mechanical Alloying.

In this research work, the nanostructured Fe-Mn (BM0), Fe-Mn-Cu (BM1), Fe-Mn-W (BM2), and Fe-Mn-Co (BM3) biodegradable alloys were successfully synthesized using mechanical alloying. The microstructure of the synthesized alloys was examined using XRD, SEM equipped with EDS, and HRTEM techniques. The results obtained based on these techniques confirmed the development of nanostructured BM0, BM1, BM2, and BM3 alloys and homogenous solid solutions with an even elemental dispersion. The compressibility of the synthesized alloys was investigated experimentally and empirically in the as-milled conditions and after applying a stress relief treatment (150 °C for 1 h). The load applied for compaction experiments ranged from 25-1100 MPa with a rate of 1 mm/min. According to the experimentation performed in the current study, the relative density of the as-milled BM0, BM1, BM2, and BM3 alloys was 72.90% and 71.64%, 72.32%, and 72.03%, respectively. After applying the stress relief treatment, the density was observed to increase to 75.23%, 77.10%, 72.65%, and 72.86% for BM0-S, BM1-S, BM2-S and BM3-S samples, respectively. A number of compaction models were tested to identify the optimum models for predicting the compressibility behavior of nanostructured Fe-Mn, Fe-Mn-Cu, Fe-Mn-W, and Fe-Mn-Co alloys in the as-milled and stress-relieved conditions.