Reactive hyperemia and baseline pulse amplitude among smelter workers exposed to fine and ultrafine particles.

OBJECTIVE: Ambient exposure to fine particles is associated with increased cardiovascular morbidity and mortality. Associations between occupational particulate matter (PM) exposure and cardiovascular disease have been studied less. The objective of this study was to examine associations between PM exposure and endothelial function among workers in Norwegian smelters. METHODS: We examined endothelial function with Endo-PAT equipment after a working day (WD) and on a day off (DO) in 59 furnace workers recruited from three metal smelters in Norway. The difference in baseline pulse amplitude (BPA) and reactive hyperemia index (RHI) between the 2 days was analysed in relation to individual exposure to PM < 250 nm (PM250) or the respirable aerosol fraction of particles, and adjusted for relevant covariates. RESULTS: The exposure to PM250 ranged from 0.004 to 5.7 mg/m3. The mean BPA was significantly higher on WD relative to DO (772 vs. 535, p = 0.001). This difference was associated with PM concentrations among participants ≥ 34 years, but not among the younger workers. Reactive hyperemia was significantly lower on workdays relative to days off (1.70 vs. 1.84, p = 0.05). This difference was observed only among participants above the age 34. No associations with PM exposure were observed. CONCLUSIONS: PM exposure was associated with higher BPA among participants older than 34 years. BPA reflects microvessel pulsatility. Our results may indicate an age-dependent cardiovascular susceptibility to PM exposure. Endothelial function measured by RHI was reduced on WD among participants 34 years and older, but we found no associations between PM exposure and RHI.

Portable diagnostic package for Thomson scattering and optical emission spectroscopy on Princeton field-reversed configuration 2 (PFRC 2).

An Advanced Research Projects Agency-Energy funded diagnostic system has been deployed to the Princeton field-reversed configuration 2 (PFRC-2) device, located at Princeton Plasma Physics Laboratory. The Portable Diagnostic Package (PDP), designed at Oak Ridge National Laboratory, allows for the measurement of Thomson Scattering (TS) for electron density and temperature and Optical Emission Spectroscopy (OES) for ion temperature, impurity density, and ion velocity. A tunable spectrometer on the PDP with three gratings provides the flexibility to measure low (1 eV) and high (1000 eV) electron temperature ranges from TS. Additionally, using a second spectrometer, the OES diagnostic can survey light emission from various ion excitation levels for wide wavelength ranges. The electron density (<2 × 1019 m-3) of plasmas generated in PFRC-2 has been below the PDP TS discrimination threshold, which has made TS signal detection challenging against a high-background of laser stray light. The laser stray light was iteratively reduced by making modifications to the entrance and exit geometry on PFRC-2. Rayleigh scattering experiments on PFRC have yielded the TS discrimination sensitivity to be >1 × 1020 m-3 for the PDP. A recently implemented narrow-band notch spectral filter that masks the second harmonic 532 nm Nd:YAG laser wavelength has increased the system's TS light discrimination sensitivity 65 times compared to the instance when the notch filter was not implemented. The hardware implementation including design changes to the flight tubes and Brewster windows will be discussed, along with results from Rayleigh and rotational Raman scattering sensitivity analyses, which were used to establish a quantitative figure of merit on the system performance. The Raman scattering calibration with the notch filter has improved the PDP electron density threshold to 1 ± 0.5 × 1018 m-3.

Physicochemical characterisation of different welding aerosols.

Physicochemical properties important in exposure characterisation of four different welding aerosols were investigated. Particle number size distributions were determined by scanning mobility particle sizer (SMPS), mass size distributions by separation and weighing the individual size fractions of an 11-stage cascade impactor. The size distribution of the primary particles of agglomerates, chemical composition and morphology of the particles were examined by TEM. There were significant differences in the particle number size distributions of the different welding aerosols according to the SMPS determinations. The particle mass size distributions determined gravimetrically were, however, not really different. The dominant range with respect to mass was between 0.1 and 1 µm, regardless of the welding technique. Most of the primary particles in all different welding aerosols had diameters between 5 and 40 nm. All types of primary particles had a tendency to form chainlike agglomerates. A clear size dependence of the particle chemical composition was encountered in the case of manual metal arc welding aerosol. Small particles with diameters below 50 nm were mostly metal oxides in contrast to larger particles which also contained more volatile elements (e.g. potassium, fluorine, sodium, sulphur).

Critical evaluation of sequential leaching procedures for the determination of Ni and Mn species in welding fumes.

In this work, welding fume samples were collected in a welding plant, where corrosion-resistant steel and unalloyed structural steel were welded by gas metal arc welding (GMAW) and manual metal arc welding (MMAW) techniques. The welding fumes were sampled with a fixed-point sampling strategy applying Higgins-Dewell cyclones. The following solutions were used to dissolve the different species of Ni and Mn: ammonium citrate solution [1.7% (m/v) diammonium hydrogen citrate and 0.5% (m/v) citric acid monohydrate] for 'soluble' Ni, 50:1 methanol-bromine solution for metallic Ni, 0.01 M ammonium acetate for soluble Mn, 25% acetic acid for Mn(0) and Mn(2+) and 0.5% hydroxylammonium chloride in 25% acetic acid for Mn(3+) and Mn(4+). 'Insoluble' Ni and Mn contents of the samples were determined after microwave-assisted digestion with the mixture of concentrated (cc). HNO(3), cc. HCl and cc. HF. The sample solutions were analysed by inductively coupled plasma quadrupole mass spectrometry and inductively coupled plasma atomic emission spectrometry. The levels of total Ni and Mn measured in the workplace air were different because of significant differences of the fume generation rates and the distributions of the components in the welding fumes between the welding processes. For quality control of the leaching process, dissolution of the pure stoichiometric Mn and Ni compounds and their mixtures weighing was investigated using the optimized leaching conditions. The results showed the adequacy of the procedure for the pure metal compounds. Based on the extraction procedures, the predominant oxidation states of Ni and Mn proved to be very different depending on the welding techniques and type of the welded steels. The largest amount of Mn in GMAW fumes were found as insoluble Mn (46 and 35% in case of corrosion-resistant steel and unalloyed structural steel, respectively), while MMAW fumes contain mainly soluble Mn, Mn(0) and Mn(2+) (78%) and Mn(3+) and Mn(4+) (54%) in case of corrosion-resistant steel and unalloyed structural steel, respectively. According to the results of the leaching procedures, GMAW fumes are rich in oxidic Ni (79%), while Ni compounds in welding fumes generated during MMAW are mainly in easily soluble form (44%). The crystalline phases were identified in each welding fume by X-ray powder diffraction (XRPD) technique as well. From the XRPD spectra, it is clear that GMAW fumes contain predominantly magnetite (FeFe(2)O(4)). In case of structural steel welding, there was a little amount of ferrite (alpha-Fe) also found. Welding fume generated during MMAW of structural steel contained a complex alkali-alkali earth fluoride phase (KCaF(3)-CaF(2)) and some magnetite and jakobsite (MnFe(2)O(4)). The XRPD results did not fully confirm the ones obtained from the extraction experiments. However, some results, for example the rate of soluble Ni and Mn compounds compared to the total, can be useful for further investigations of welding fumes.

Thyroid homeostasis in mother-child pairs in relation to maternal iodine status: the MISA study.

BACKGROUND/OBJECTIVES: Iodine deficiency during pregnancy may influence maternal and foetal thyroid function with the risk of causing neurocognitive and psychomotor deficits in the offspring. The objective of this study was to assess iodine status in pregnant women from Northern Norway and to investigate the influence of iodine status on maternal and infant thyroid function. SUBJECTS/METHODS: Women from the Northern Norway Mother-and-Child contaminant Cohort Study (MISA) donated a blood and urine sample at three visits during their pregnancy and postpartum period (in second trimester, 3 days and 6 weeks after delivery. N=197). Women were assigned to iodine status groups according to urine iodine concentrations (UICs) in second trimester and mixed effects linear models were used to investigate potential associations between iodine status and repeated measurements of thyroid-stimulating hormone (TSH), thyroid hormones (THs), TH-binding proteins and thyroid peroxidase antibodies. Associations between maternal iodine status and TSH in heel prick samples from the infants were investigated with linear regression. RESULTS: Median UIC in second trimester was 84 µg/l (range 18-522) and 80% had UIC below recommended level (<150 µg/l). Iodine-deficient women had higher concentrations of T3, FT3 and FT4 (estimated differences (confidence intervals) of 0.10 nmol/l (0.01, 0.17), 0.16 pmol/l (0.05, 0.26) and 0.45 pmol/l (0.10, 0.78), respectively) compared with iodine-sufficient women. The concentrations varied within normal reference ranges, but the majority of women with subclinical hypothyroidism were iodine deficient. Maternal iodine status did not influence infant TSH concentrations. CONCLUSIONS: This study indicate iodine deficiency among pregnant women in Norway. Iodine status during pregnancy influences maternal thyroid homeostasis and is therefore a risk factor for foetal and infant development.

Tolerability and pharmacokinetic profile of a novel benzene-poly-carboxylic acids complex with cis-diammineplatinum (II) dichloride in dogs with malignant mammary tumours.

The pharmacokinetic profile, tolerability and efficacy of benzene-poly-carboxylic acids complex with cis-diammineplatinum (II) dichloride (BP-C1) were studied in dogs with mammary cancer. A three-level response surface pathway designed trial was performed on seven dogs. At each level BP-C1 was administered subcutaneously daily for 7 days followed by a 7-day rest period in a dose escalating manner. Adverse events according to VCOG-CTCAE, performance status and tumour progression were recorded. The pharmacokinetic profile followed a two-compartment model with rapid absorption, short distribution, and a slow elimination phase. The overall elimination half-life was 125 h. The maximum tolerated dose of BP-C1 was estimated to be above 0.46 mg kg-1 . A significant reduction in VCOG-CTCAE toxicity which correlated negatively with increasing dose was found. The dogs' general performance status remained unchanged. No decrease in total tumour burden was found, although temporary tumour reduction was seen in some target tumours.

Particle size distribution of workplace aerosols in manganese alloy smelters applying a personal sampling strategy.

Air samples were collected by personal sampling with five stage Sioutas cascade impactors and respirable cyclones in parallel among tappers and crane operators in two manganese (Mn) alloy smelters in Norway to investigate PM fractions. The mass concentrations of PM collected by using the impactors and the respirable cyclones were critically evaluated by comparing the results of the parallel measurements. The geometric mean (GM) mass concentrations of the respirable fraction and the <10 µm PM fraction were 0.18 and 0.39 mg m(-3), respectively. Particle size distributions were determined using the impactor data in the range from 0 to 10 µm and by stationary measurements by using a scanning mobility particle sizer in the range from 10 to 487 nm. On average 50% of the particulate mass in the Mn alloy smelters was in the range from 2.5 to 10 µm, while the rest was distributed between the lower stages of the impactors. On average 15% of the particulate mass was found in the <0.25 µm PM fraction. The comparisons of the different PM fraction mass concentrations related to different work tasks or different workplaces, showed in many cases statistically significant differences, however, the particle size distribution of PM in the fraction <10 µm d(ae) was independent of the plant, furnace or work task.

Formation of collisionless high-beta plasmas by odd-parity rotating magnetic fields.

Odd-parity rotating magnetic fields (RMFo) applied to mirror-configuration plasmas have produced average electron energies exceeding 200 eV at line-averaged electron densities of approximately 10(12) cm-3. These plasmas, sustained for over 10(3)tauAlfven, have low Coulomb collisionality, vc* triple bond L/lambdaC approximately 10(-3), where lambdaC is the Coulomb scattering mean free path and L is the plasma's characteristic half length. Divertors allow reduction of the electron-neutral collision frequency to values where the RMFo coupling indicates full penetration of the RMFo to the major axis.