Evaluation of the Fenton process effectiveness in the remediation of soils contaminated by gasoline: Effect of soil physicochemical properties.

The remediation of four different soils contaminated by gasoline was performed using Fenton processes. Herein, the effect of the main physicochemical characteristics of the soils in the Fenton performance is emphasized. Fenton processes were applied in a column system, with and without addition of soluble iron (II), using undisturbed soil samples collected in four regions of the Paraná State (Brazil). Two groups of contaminants were monitored during the remediation process: BTEX (benzene, toluene, ethylbenzene and xylenes) and TRHs (total recoverable hydrocarbons). Superior degradation efficiencies were observed in the soils with elevated mineral iron content (Red Argisol, Red-Yellow Argisol and Red Latosol), while the soils with low iron content (Spodosol) presented comparable degradation efficiencies only in the presence of soluble Fe2+. Although the presence of mineral iron enabled the Fenton processes, a good correlation between the iron content and the degradation efficiency was not observed, suggesting a dependence on the chemical nature of the native iron. BTEX leaching was observed in all systems, suggesting that the process should be applied with caution, especially in soils with high drainage.

Treatment of gasoline-contaminated waters by advanced oxidation processes.

In this study, the efficiency of advanced oxidative processes (AOPs) was investigated toward the degradation of aqueous solutions containing benzene, toluene and xylenes (BTX) and gasoline-contaminated waters. The results indicated that BTX can be effectively oxidized by near UV-assisted photo-Fenton process. The treatment permits almost total degradation of BTX and removal of more than 80% of the phenolic intermediates at reaction times of about 30 min. Preliminary investigations using water contaminated by gasoline suggest a good potentiality of the process for the treatment of large volumes of aqueous samples containing these polluting species. Heterogeneous photocatalysis and H2O2/UV system show lower degradation efficiency, probably due to the heterogeneous character of the TiO2-mediated system and lost of photonic efficiency of the H2O2/UV system in the presence of highly colored intermediated.

Fractionation of Eucalyptus grandis chips by dilute acid-catalysed steam explosion.

Steam explosion of Eucalyptus grandis has been carried out under various pretreatment conditions (200-210 degrees C, 2-5 min) after impregnation of the wood chips with 0.087 and 0.175% (w/w) H2SO4. This study, arranged as a 2(3) factorial design, indicated that pretreatment temperature is the most critical variable affecting the yield of steam-treated fractions. Pretreatment of 0.175% (w/w) H2SO4-impregnated chips at 210 degrees C for 2 min was the best condition for hemicellulose recovery (mostly as xylose) in the water soluble fraction, reaching almost 70% of the corresponding xylose theoretical yield. By contrast, lower pretreatment temperatures of 200 degrees C were enough to yield steam-treated substrates from which a 90% cellulose conversion was obtained in 48 h, using low enzyme loadings of a Celluclast 1.5 1 plus Novozym 188 mixture (Novo Nordisk). Release of water-soluble chromophores was monitored by UV spectroscopy and their concentration increased with pretreatment severity. The yield of alkali-soluble lignin increased at higher levels of acid impregnation and pretreatment temperatures. Thermoanalysis of these lignin fractions indicated a pattern of lignin fragmentation towards greater pretreatment severities but lignin condensation prevailed at the most drastic pretreatment conditions.