RESUMEN
We report on the collapsing and reswelling ability of grafted poly(methyl vinyl ether) chains of different molecular architectures. In order to study the influence of constraints and confinement of the chains, the polymer was grafted onto AFM tips, as a model of a curved nano-sized surface, and onto macroscopic silicon substrates for comparison purposes. AFM-based force spectroscopy experiments were performed to characterise at the nanoscale the temperature-dependent collapsing process and the reversibility to the swollen state on both substrates. The reversible character of the thermoresponsive transition and its kinetics were shown to greatly depend on the polymer architecture and the constraints encountered by the chains.
RESUMEN
This communication reports on a novel, simple and highly versatile concept, which consists in combining the advantages of two complementary and relevant techniques (i) electrografting and (ii) layer-by-layer deposition process with the goal to tailor strongly adhering coatings to (semi)-conducting surfaces imparting them with tunable specific properties.
Asunto(s)
Membranas Artificiales , Polímeros/química , Electroquímica , Estructura Molecular , Semiconductores , Silicio/química , Acero Inoxidable/química , Propiedades de SuperficieRESUMEN
This paper describes an analytical method for the determination of five biocides of isothiazolinone type (2-methyl-3-isothiazolinone (MI), 5-chloro-2-methyl-3-isothiazolinone (CMI), 1,2-benzisothiazolinone (BIT), 2-octyl-3-isothiazolinone (OI), 4,5-dichloro-2-octyl-3-isothiazolinone (DCOI)) in environmental waters. The method is based on pre-concentration of the analytes by solid-phase extraction onto a mixture of a polymeric material and RP-C18 material and subsequent determination by gas chromatography-mass spectrometry (GC-MS). One of the target compounds (BIT) is derivatised with diazomethane after pre-concentration to improve its chromatographic performance. The method was optimised with respect to pre-concentration conditions (liquid-liquid extraction versus solid-phase extraction, solid-phase material, elution solvent and volume) and extensively validated. Applying the method to surface waters, groundwaters, and drinking waters, limits of detection between 0.01 and 0.1 microg/l could be achieved and the repeatability was below 10% for all compounds except for MI. Additional investigations showed that the stability of the isothiazolinones in environmental waters is limited and sample storage at 4 degrees C is mandatory to preserve the target biocides. First investigations of influents and effluents of a wastewater treatment plant showed that conventional wastewater treatment exhibits a high efficiency for removal of the isothiazolinones. In river waters, the target isothiazolinones could not be detected.
Asunto(s)
Cromatografía de Gases y Espectrometría de Masas/métodos , Tiazoles/química , Agua/química , Diazometano/análisis , Diazometano/química , Monitoreo del Ambiente/métodos , Conservadores Farmacéuticos/análisis , Conservadores Farmacéuticos/química , Reproducibilidad de los Resultados , Extracción en Fase Sólida/métodos , Tiazoles/análisis , Agua/análisis , Contaminantes Químicos del Agua/análisis , Abastecimiento de Agua/análisisRESUMEN
Two strategies were used for the preparation of hyperbranched polymer brushes with a high density of functional groups: (a) the cathodic electrografting of stainless steel by poly[2-(2-chloropropionate)ethyl acrylate] [poly(cPEA)], which was used as a macroinitiator for the atom transfer radical polymerization of an inimer, 2-(2-bromopropionate)ethyl acrylate in the presence or absence of heptadecafluorodecyl acrylate, (b) the grafting of preformed hyperbranched poly(ethyleneimine) onto poly(N-succinimidyl acrylate) previously electrografted onto stainless steel. The hyperbranched polymer, which contained either bromides or amines, was quaternized because the accordingly formed quaternary ammonium or pyridinium groups are known for antibacterial properties. The structure, chemical composition, and morphology of the quaternized and nonquaternized hyperbranched polymer brushes were characterized by ATR-FTIR reflectance, Raman spectroscopy, X-ray photoelectron spectroscopy, and atomic force microscopy. The peeling test confirmed that the grafted hyperbranched polymer films adhered much more strongly to stainless steel than the nongrafted solvent-cast films. The quaternized hyperbranched polymer brushes were more effective in preventing both protein adsorption and bacterial adhesion than quaternary ammonium containing poly(cPEA) primary films, more likely because of the higher hydrophilicity and density of cationic groups.
Asunto(s)
Acrilatos/química , Antibacterianos , Acero Inoxidable/química , Staphylococcus aureus/efectos de los fármacos , Adsorción , Antibacterianos/síntesis química , Antibacterianos/química , Antibacterianos/farmacología , Electroquímica , Pruebas de Sensibilidad Microbiana , Estructura Molecular , Propiedades de SuperficieRESUMEN
In this paper, results of an extensive monitoring programme for pharmaceutical residues in the river Rhine are presented. For one decade (1997 until 2006), the occurrence of widely used human pharmaceuticals like analgesics, lipid regulators, antiepileptics and others has been studied at four locations along the river Rhine. The results of more than 500 analyses clearly prove that compounds such as carbamazepine or diclofenac are regularly found in the river Rhine in concentrations up to several hundred ng per litre. Combining concentration levels with data on water flow enables the calculation of transports, which e.g. for carbamazepine or diclofenac were in the range of several tons per year. The evaluation of the long-term monitoring data shows that only a slight decrease in concentration levels as well as in annual transports can be observed and thus the contamination of the river Rhine by pharmaceutical residues during the last decade has to be regarded as almost constant. Seasonal variations can be detected for bezafibrate, diclofenac and ibuprofen, for which the concentrations are much lower in the summer months. A more effective removal during wastewater treatment in the warmer periods of the year seems to be the major reason for those variations. For carbamazepine, no comparable seasonal effect can be found.
Asunto(s)
Antiinflamatorios no Esteroideos/análisis , Hipolipemiantes/análisis , Ríos/química , Anticonvulsivantes/análisis , Carbamazepina/análisis , Alemania , Pentoxifilina/análisis , Estaciones del Año , Suiza , Factores de Tiempo , Vasodilatadores/análisisRESUMEN
Thermoresponsive brushes have been efficiently grafted onto (semi)conductive surfaces by a two-step process. In the first step, poly(N-succinimidyl acrylate) chains have been chemisorbed onto silicon or stainless steel by the electrografting method. Then, these modified electrodes were immersed in isopropylamine in order to transform the grafted chains to the thermoresponsive poly(N-isopropyl acrylamide). The thermal response of these brushes has been shown by AFM. This straightforward grafting process is quite attractive for surface modification in confined media and is thus promising for microfludics application.
RESUMEN
With the purpose of developing biosensors, the reliable proof of the biological activity of two new sensor systems was obtained by atomic force microscopy (AFM) in both the imaging and the single-molecule force spectroscopy modes. Antigens or antibodies of pharmacological interest were grafted onto self-assembled monolayers of thiols on gold, and AFM imaging demonstrated that the grafting process produced homogeneous submonolayers of isolated proteins. The analysis of the morphology of the surfaces at the different functionalization steps allowed evaluating the protein grafting density and showed that the recognition of complementary species present in the surrounding solution occurred. Single-molecule force spectroscopy experiments between the sensing surfaces and AFM probes, onto which the complementary species were grafted, enabled a direct and rapid test of the biological activity of the sensors by investigating the interaction occurring at the level of one single ligand-receptor bond. Ellipsometry and surface plasmon resonance allowed further characterization of the sensor surfaces and confirmed that the biological recognition took place.
Asunto(s)
Técnicas Biosensibles/métodos , Microscopía de Fuerza Atómica/métodos , Proteínas/química , Proteínas/ultraestructura , Estructura Molecular , Proteínas/inmunología , Proteínas/metabolismo , Resonancia por Plasmón de Superficie , Propiedades de SuperficieRESUMEN
The use of scanning probe microscopy-based techniques to manipulate single molecules and deliver them in a precisely controlled manner to a specific target represents a significant nanotechnological challenge. The ultimate physical limit in the design and fabrication of organic surfaces can be reached using this approach. Here we show that the atomic force microscope (AFM), which has been used extensively to investigate the stretching of individual molecules, can deliver and immobilize single molecules, one at a time, on a surface. Reactive polymer molecules, attached at one end to an AFM tip, are brought into contact with a modified silicon substrate to which they become linked by a chemical reaction. When the AFM tip is pulled away from the surface, the resulting mechanical force causes the weakest bond - the one between the tip and polymer - to break. This process transfers the polymer molecule to the substrate where it can be modified by further chemical reactions.