Cerebral vascular reactivity assessed with acetazolamide single photon emission computer tomography scans before and after carotid endarterectomy.

BACKGROUND AND METHODS: In 64 patients, cerebral perfusion and vascular reactivity were assessed before and after carotid endarterectomy (CEA) using acetazolamide (ACZ)-enhanced single photon emission computer tomography (SPECT). Twenty-five patients were asymptomatic, whereas the remainder were symptomatic. Sixty-one patients had a > or = 70% ipsilateral internal carotid artery stenosis. RESULTS: Fifty SPECT scans revealed decreased vascular reactivity. Twenty-three showed infarcts. Fourteen patients had normal studies. Twenty of the SPECT scans of asymptomatic patients demonstrated poor vascular reactivity. After CEA, 39 patients had improved ipsilateral vasoreactivity. In 12 patients, contralateral improvement was also found. CONCLUSION: ACZ-enhanced SPECT scans, by assessing cerebral perfusion and vascular reactivity, may help to identify patients at risk of stroke should perfusion further diminish. Postoperative studies confirm improvement in vascular reactivity. ACZ-enhanced SPECT scans may provide objective evidence for the selection of patients with a high-grade asymptomatic carotid stenosis for CEA.

Multicomponent adsorption on activated carbons under supercritical conditions.

Adsorption of binary mixtures onto activated carbon Norit R1 for the system nitrogen-methane-carbon dioxide was investigated over the pressure range up to 15 MPa. A new model is proposed to describe the experimental data. It is based on the assumption that an activated carbon can be characterized by the distribution function of elements of adsorption volume (EAV) over the solid-fluid potential. This function may be evaluated from pure component isotherms using the equality of the chemical potentials in the adsorbed phase and in the bulk phase for each EAV. In the case of mixture adsorption a simple combining rule is proposed, which allows determining the adsorbed phase density and its composition in the EAV at given pressure and compositions of the bulk phase. The adsorbed concentration of each adsorbate is the integral of its density over the set of EAV. The comparison with experimental data on binary mixtures has shown that the approach works reasonably well. In the case of high-pressure binary mixture adsorption, when only total amount adsorbed was measured, the proposed model allows reliably determining partial amounts of the adsorbed components.

Modeling of gas adsorption equilibrium over a wide range of pressure: a thermodynamic approach based on equation of state.

A thermodynamic approach based on the Bender equation of state is suggested for the analysis of supercritical gas adsorption on activated carbons at high pressure. The approach accounts for the equality of the chemical potential in the adsorbed phase and that in the corresponding bulk phase and the distribution of elements of the adsorption volume (EAV) over the potential energy for gas-solid interaction. This scheme is extended to subcritical fluid adsorption and takes into account the phase transition in EAV. The method is adapted to gravimetric measurements of mass excess adsorption and has been applied to the adsorption of argon, nitrogen, methane, ethane, carbon dioxide, and helium on activated carbon Norit R1 in the temperature range from 25 to 70 degrees C. The distribution function of adsorption volume elements over potentials exhibits overlapping peaks and is consistently reproduced for different gases. It was found that the distribution function changes weakly with temperature, which was confirmed by its comparison with the distribution function obtained by the same method using nitrogen adsorption isotherm at 77 K. It was shown that parameters such as pore volume and skeleton density can be determined directly from adsorption measurements, while the conventional approach of helium expansion at room temperature can lead to erroneous results due to the adsorption of helium in small pores of activated carbon. The approach is a convenient tool for analysis and correlation of excess adsorption isotherms over a wide range of pressure and temperature. This approach can be readily extended to the analysis of multicomponent adsorption systems.

Gas forming processes within lignite mining dumps.

Gas analyses of the soil atmosphere of lignite mining dumps yielded increased contents of carbon dioxide. To get information about the potential sources and the carbon dioxide releasing capacity of the dumps, samples of dump material were investigated for their contents and isotopic compositions of organic and inorganic carbon as well as the carbon dioxide in the soil atmosphere. The contents of organic and inorganic carbon were found to vary depending on type of dump material. The isotopic composition of the organic carbon ranges between -24.5 and -26.5 per thousand, which is typical for humous materials. The carbonates are found to be of marine origin (delta13C: +0.5 to -1.1 per thousand). By means of the isotope investigations it could be shown that the carbon dioxide in the lignite mining dump arises from these two different sources. Mixing ratios can be calculated using the isotope balance equation. Both reaction paths are associated with oxygen consumption and do not result in an increased gas pressure within the dump.