RESUMEN
Second-generation bioenergy, a carbon neutral or negative renewable resource, is crucial to achieving India's net-zero emission targets. Crop residues are being targeted as a bioenergy resource as they are otherwise burned on-field, leading to significant pollutant emissions. But estimating their bioenergy potential is problematic because of broad assumptions about their surplus fractions. Here, we use comprehensive surveys and multivariate regression models to estimate the bioenergy potential of surplus crop residues in India. These are with high sub-national and crop disaggregation that can facilitate the development of efficient supply chain mechanisms for its widespread usage. The estimated potential for 2019 of 1313 PJ can increase the present bioenergy installed capacity by 82% but is likely insufficient alone to meet India's bioenergy targets. The shortage of crop residue for bioenergy, combined with the sustainability concerns raised by previous studies, imply a need to reassess the strategy for the use of this resource.
Asunto(s)
Agricultura , Contaminantes Ambientales , India , CarbonoRESUMEN
Fine particulate matter (PM2.5) mass and its chemical constituents were measured over Van Vihar National Park (VVNP) in Bhopal, central India. Fine PM collected over two years onto Teflon filters using a Mini-Vol® sampler were analyzed for trace elements using an Energy Dispersive X-ray fluorescence (ED-XRF) spectrometer. The temporal behaviour, dry deposition fluxes and transport pathways of elements, in addition to their health risks were examined in this study. S, K, Si, Al, Ca, and Fe accounted for most of the PM2.5-bound trace elements (~88% on average). Pronounced seasonality was observed for major elements (S, K, and Cl) and reconstructed soil (estimated as the sum of oxides of crustal elements, i.e., Si, Al, Ca, Fe, and Ti), with winter and post-monsoon season highs, potentially due to source strengths and favourable metrology during these seasons. The synoptic meteorology during these seasons favoured the fetch of particles from highly polluted regions such as the Indo-Gangetic Plain. The estimated average dry depositional flux of each element in this study was comparable to those measured/estimated for each of these species over other urban areas. The sum of the dry deposition flux for crustal elements (1301.9 ± 880.7 µg m-2 d-1) was in agreement with global dust cycle models. Air-parcel trajectory cluster analysis revealed that S, K, and Cl were influenced by biomass and coal burning in predominantly in central, and northwestern India, while reconstructed soil was influenced by air masses from the Arabian and Thar deserts. Finally, human exposure risk assessment to carcinogens (As, Cr, Cd, Pb and Ni) and non-carcinogens (Cu, Zn, Mn, V, Hg, Se and Al) revealed that no significant risk was posed by these elements. The assessment in this study was a screening for severe adverse effects, rather than a speciated health assessment. Thus, over the study region, monitoring, health risk assessment and mitigation measures, where needed, must be enhanced to ensure that trace elements induced health effects continue to be within safe levels.
Asunto(s)
Contaminantes Atmosféricos , Oligoelementos , Contaminantes Atmosféricos/análisis , Monitoreo del Ambiente , Humanos , India , Parques Recreativos , Material Particulado/análisis , Estaciones del Año , Oligoelementos/análisisRESUMEN
Atmospheric PM2.5 thermal elemental carbon (EC), optical black carbon (BC), brown carbon (BrC), and mineral dust (MD) were characterized during a field campaign at a regionally representative site (Bhopal, central India) all year-long during 2019. In this study, the optical characteristics of PM2.5 during 'EC-rich', 'OC-rich', and 'MD-rich' days were used in a three-component model to estimate site-specific Absorption Ångström exponent (AAE) and absorption coefficient (babs) of light-absorbing PM2.5 constituents. The AAE for 'EC-rich', 'OC-rich', and 'MD-rich' days were 1.1 ± 0.2, 2.7 ± 0.3, and 3.0 ± 0.9, respectively. The percentage contribution of calculated babs of EC, BrC, and MD to the total babs at 405 nm was dominated by EC during the entire study period (EC; 64 % ± 36 %, BrC: 30 % ± 5 %, MD: 10 % ± 1 %). Further, site-specific mass absorption cross-section (MAC) values were calculated to assess the impact of their use over the use of manufacturer-specified MAC values in estimating BC concentrations. The r2 between thermal EC and optical BC was higher (r2 = 0.67, slope = 1.1) when daily site-specific MAC values were used rather than using the default MAC value (16.6 m2 g-1; r2 = 0.54 and slope = 0.6). Overall, had the default MAC880 been used instead of the site-specific values, we would have underestimated the BC concentration by 39 % ± 18 % during the study period.
RESUMEN
Thermal elemental carbon (EC), optical black carbon (BC), organic carbon (OC), mineral dust (MD), and 7-wavelength optical attenuation of 24-hour ambient PM2.5 samples were measured/estimated at a regionally representative site (Bhopal, central India) during a business-as-usual year (2019) and the COVID-19 lockdowns year (2020). This dataset was used to estimate the influence of emissions source reductions on the optical properties of light-absorbing aerosols. During the lockdown period, the concentration of EC, OC, BC880 nm, and PM2.5 increased by 70 % ± 25 %, 74 % ± 20 %, 91 % ± 6 %, and 34 % ± 24 %, respectively, while MD concentration decreased by 32 % ± 30 %, compared to the same time period in 2019. Also, during the lockdown period, the estimated absorption coefficient (babs) and mass absorption cross-section (MAC) values of Brown Carbon (BrC) at 405 nm were higher (42 % ± 20 % and 16 % ± 7 %, respectively), while these quantities for MD, i.e., babs-MD and MACMD values were lower (19 % ± 9 % and 16 % ± 10 %), compared to the corresponding period during 2019. Also, babs-BC-808 (115 % ± 6 %) and MACBC-808 (69 % ± 45 %) values increased during the lockdown period compared with the corresponding period during 2019. It is hypothesized that although anthropogenic emissions (chiefly industrial and vehicular) reduced drastically during the lockdown period compared to the business-as-usual period, an increase in the values of optical properties (babs and MAC) and concentrations of BC and BrC, were likely due to the increased local and regional biomass burning emissions during this period. This hypothesis is supported by the CBPF (Conditional Bivariate Probability Function) and PSCF (Potential Source Contribution Function) analyses for BC and BrC.
Asunto(s)
Contaminantes Atmosféricos , COVID-19 , Humanos , Contaminantes Atmosféricos/análisis , Carbono/análisis , Control de Enfermedades Transmisibles , COVID-19/epidemiología , Polvo/análisis , Monitoreo del Ambiente , India , Material Particulado/análisis , Aerosoles y Gotitas Respiratorias , Hollín/análisisRESUMEN
Time-synchronized, 24 h integrated PM2.5 trace element (TE) measurements made as a part of the COALESCE project (Venkataraman et al., 2020) at Bhopal, Mesra, and Mysore during all of 2019 were analyzed in this study. The concentrations of 15 key elements ranged between 0.05 ng m-3 and 50 µg m-3 across the study sites. Pronounced seasonal variation of elements from multiple source classes showed that the crustal origin elements (Al, Si, Fe, Ti, and Ca) peaked during the pre-monsoon season, while the anthropogenic activities driven element (P, S, K, V, Mn, Cu, Zn, and Pb) concentrations increased during the winter and post-monsoon seasons. Spearman correlation coupled with hierarchical clustering separated the matrix of elements into three common clusters at all sites, corresponding to crustal sources, combustion and biomass burning emissions, and industrial/non-exhaust vehicular emissions, respectively. Furthermore, episodes of metal pollution throughout the year were examined using characteristic radar charts of TEs to identify the association between TE sources and poor air quality. For example, maximum metal pollution in Bhopal occurred during the post-monsoon season, attributable to biomass burning, dust storms, industrial and non-exhaust vehicular emissions. Finally, an ecological risk assessment revealed that the risk index was higher than the threshold value of 600 for all heavy metals at all sites. Pb, Cu, and Zn were the top contributors to 'extremely high risk' amongst all heavy metals. Overall, the results show that although TE concentrations at all three locations were much lower than in other urban locations in India, the risk from heavy metals to the ecosystem (and likely to human health) cannot be ignored. The findings warrant a full source apportionment of fine PM to better identify TE-rich source contributions and future studies to examine the atmospheric processing and eco-system uptake of TEs.