Correlation between charge density wave phase transition and hydrogen adsorption in 1T-TaS2thin film devices.

Thin films of tantalum disulfide in the 1T-polytype structural phase (1T-TaS2), a type of metallic two-dimensional (2D) transition metal dichalcogenides (TMDs), are reactive to H2. Interestingly, in the incommensurate charge-density wave (ICCDW) phase with a metallic state, the electrical resistance of the 1T-TaS2thin film decreases when H2is adsorbed on it and returns to its initial value upon desorption. In contrast, the electrical resistance of the film in the nearly commensurate CDW (NCCDW) phase, which has a subtle band overlap or a small bandgap, does not change upon H2adsorption/desorption. This difference in H2reactivity is a result of differences in the electronic structure of the two 1T-TaS2phases, namely, the ICCDW and NCCDW phases. Compared to other semiconductor 2D-TMDs such as MoS2and WS2, the metallic TaS2has been theoretically proven to capture gas molecules more easily because Ta has a stronger positive charge than Mo or W. Our experimental results provide evidence of this. Notably, this study is the first example of H2sensing using 1T-TaS2thin films and demonstrates the possibility of controlling the reactivity of the sensors to the gas by changing the electronic structure via CDW phase transitions.

Use of LAMP Detection to Identify Potential Contamination Sources of Plant-Pathogenic Pythium Species in Hydroponic Culture Systems of Tomato and Eustoma.

Hydroponic culture systems are subject to high risks of diseases caused by zoosporic plant pathogens. Control is generally difficult because of the rapid spread of zoospores in the nutrient solutions. In Japan, tomato and eustoma, which are cultivated using the D-tray and nutrient film techniques, respectively, are susceptible to diseases caused by Pythium aphanidermatum and P. irregulare. We used loop-mediated isothermal amplification to identify potential contamination sources of these two pathogens by monitoring their presence in the water supply wells, seedling terraces, nutrient solutions, diseased plants, and ground soils of a tomato greenhouse complex and a eustoma greenhouse complex. The results indicated that the pathogens may enter the culture systems from the soils around the greenhouses. Entry most likely occurs when seedlings are moved from the seedling terraces to the greenhouses, and sterilization of the hydroponic systems may not be sufficient. Therefore, monitoring pathogens in the culture systems and ground soils is very important for the management and prevention of these diseases.

Design of composite photocatalyst of TiO2 and Y-zeolite for degradation of 2-propanol in the gas phase under UV and visible light irradiation.

Hydrophobic Y-zeolite (SiO2/Al2O3 = 810) and TiO2 composite photocatalysts were designed by using two different types of TiO2 precursors, i.e., titanium ammonium oxalate and ammonium hexafluorotitanate. The porous structure, surface property and state of TiO2 were investigated by various characterization techniques. By using an ammonium hexafluorotitanate as a precursor, hydrophobic modification of the Y-zeolite surface and realizing visible light sensitivity was successfully achieved at the same time after calcination at 773 K in the air. The prepared sample still maintained the porous structure of Y-zeolite and a large surface area. Highly crystalline anatase TiO2 was also formed on the Y-zeolite surface by the role of fluorine in the precursor. The usages of ammonium hexafluorotitanate were effective for the improvement of the photocatalytic performance of the composite in the degradation of 2-propanol in the gas phase under UV and visible light (λ > 420 nm) irradiation.

Changes of quinolone resistance genes and their relations with microbial profiles during vermicomposting of municipal excess sludge.

Antibiotic resistance genes abundant in municipal excess sludge reduce the agricultural value of vermicompost. However, little attention has been paid on the fate and behavior of the problem-causing agents in vermicomposting. In this study, the fate and behavior of quinolone resistance genes in excess activated sludge during vermicomposting were studied with reactors introduced with Eisenia fetida for three different densities. The substrate pile without earthworms was operated as control in parallel. The results showed that earthworms could significantly reduce the absolute abundance of quinolone resistance genes in the excess sludge, with a reduction ratio of 85.6-100% for qnr A and 92.3-95.3% for qnr S, respectively (p < 0.05). For microbial profiles, both the dehydrogenase activity and the abundance of microbes (16S rDNA) revealed a distinct decreasing trend after 7 days from the start of the experiment; however, the bacterial diversity in the final products seemed to be enriched with the emergence of the uncultured Flavobacteriales bacterium and uncultured Anaerolineaceae bacterium. Redundancy analysis revealed clearly that the qnr genes had positive correlations with the targeted indexes of microbial profiles, with the correlations with the bacterial abundance and dehydrogenase activity being more statistically significant than the bacterial diversity (p < 0.05). The results of this study suggested that earthworms could promote the attenuation of quinolone resistance genes in the excess sludge through lowering the bacterial abundance and activity, and the promotion effect could be enhanced by increasing the density of earthworms.

Electrical Characteristics of Pentacene Films on Cross-Linked Polymeric Insulators of Varying Thicknesses.

Pentacene films vacuum-sublimed on a cross-linked polymeric insulator (CPVP-C6) prepared using poly(4-vinylphenol) (PVP) and 1,6-bis(trichlorosilyl)hexane (C6) were studied with a special concern on possible influences of the CPVP-C6 thickness on the electrical characteristics of the pentacene films. It was found that the conductivities of the pentacene films on a thin CPVP-C6 film (10 nm) were approximately 2 orders of magnitude higher than those on a glass substrate and increased slightly with the increase in the thickness of the underlying CPVP-C6 film. In addition, the X-ray diffraction measurements showed that the stacking structure of pentacene molecules was remarkably enhanced by increasing the thickness of the CPVP-C6 film, suggesting that the increase in conductivity is due, at least in part, to the improvement in carrier mobilities caused by the growth of large pentacene grains. An attempt to directly evaluate carrier mobilities using pentacene/CPVP-C6 field-effect transistors was made, and a seeming increase in the carrier mobilities observed with the increase in the CPVP-C6 thickness was ascribed to a hygroscopic nature of the CPVP-C6 film, which was evidenced by the capacitance and quartz crystal microbalance measurements. Possible reasons are discussed to explain the enhanced conductivities of the pentacene films on the increased thicknesses of CPVP-C6.

Simple detection of Pythium irregulare using loop-mediated isothermal amplification assay.

Pythium irregulare is an important soil-borne pathogen that causes seed, stem and root rot, and seedling damping-off in various crops. Here, we have developed a rapid and reliable approach for detecting the pathogen using loop-mediated isothermal amplification (LAMP) in combination with primers designed from the sequences of the P. irregulare ribosomal DNA internal transcribed spacer region. The specificity of the primers for P. irregulare was tested using 50 isolates of 40 Pythium species, 11 Phytophthora isolates and 8 isolates of 7 other soil-borne pathogens. The assay showed that the limit of sensitivity of the LAMP method was 100 fg of pure DNA, a similar level to that of a polymerase chain reaction. LAMP detected P. irregulare from the supernatant after mixing culture medium (template DNA source) with distilled water. Similarly, positive results were obtained using a 'Plant-LAMP' method applied to a suspension rotted roots in water. A 'Bait-LAMP' method using the supernatant of autoclaved perilla seeds incubated in a soil/water mixture for 1 week at 25°C successfully detected P. irregulare from the soil. The LAMP assay described in this study is therefore a simple and effective way for practical detection of P. irregulare.

Optically controllable dual-gate organic transistor produced via phase separation between polymer semiconductor and photochromic spiropyran molecules.

We produced an optically controllable dual-gate organic field-effect transistor by a simple one-step spin-coating of a mixed solution of photochromic spiropyran (SP) and poly(3-hexylthiophene) (P3HT). Postannealing enhanced polymer chain ordering of P3HT to induce phase separation into an SP-rich lower layer and an SP-free upper layer. These layers worked independently as transistor channels with distinct optical responsivity. The top channel was optically inactive, but the bottom channel was optically active, because of the photoisomerization of SP. These results demonstrate the potential of our technique to produce a multifunctional photoactive organic transistor by a simple process.

Development and application of a loop-mediated isothermal amplification assay for rapid detection of Pythium helicoides.

Root rot of poinsettia, caused by Pythium helicoides at high temperatures in hydroponic cultures, has become a serious problem in many parts of the world. We have developed a species-specific, loop-mediated isothermal amplification (LAMP) assay for the rapid diagnosis of this pathogen. The primers were designed using the ribosomal DNA internal transcribed spacer sequence. Primer specificity was established using 40 Pythium species including P. helicoides, 11 Phytophthora species, and eight other soil-borne pathogens. A sensitivity test was carried out using genomic DNA extracted from P. helicoides, and the detection limit was c. 100 fg which is comparable to that of the polymerase chain reaction (PCR). In addition, we tested the ease of pathogen detection in poinsettia roots. The LAMP results were consistent with those from the conventional plating method and showed more sensitivity than the PCR results. Consequently, the LAMP method developed in this study is effective for the rapid and easy detection of P. helicoides.

Unique device operations by combining optical-memory effect and electrical-gate modulation in a photochromism-based dual-gate transistor.

We demonstrate a new device that combines a light-field effect and an electrical-gate effect to control the drain current in a dual-gate transistor. We used two organic layers, photochromic spiropyran (SP)-doped poly(triarylamine) (PTAA) and pristine PTAA, as top and bottom channels, respectively, connected to common source and drain electrodes. The application of voltage to the top and bottom gates modulated the drain current through each layer independently. UV irradiation suppressed the drain current through the top channel. The suppressed current was then maintained even after the UV light was turned off because of an optical memory effect induced by photoisomerization of SP. In contrast, UV irradiation did not change the drain current in the bottom channel. Our dual-gate transistor thus has two organic channels with distinct photosensitivities: an optically active SP-PTAA film and an optically inactive PTAA film. This device configuration allows multi-level switching via top- and bottom-gate electrical fields with an optical-memory effect.