RESUMEN
Metal-organic frameworks (MOFs) are hybrid materials based on crystalline coordination polymers that consist of metal ions connected by organic ligands. In addition to the traditional applications in gas storage and separation or catalysis, the long-range crystalline order in MOFs, as well as the tunable coupling between the organic and inorganic constituents, has led to the recent development of electrically conductive MOFs as a new generation of electronic materials. However, to date, the nature of charge transport in the MOFs has remained elusive. Here we demonstrate, using high-frequency terahertz photoconductivity and Hall effect measurements, Drude-type band-like transport in a semiconducting, π-d conjugated porous Fe3(THT)2(NH4)3 (THT, 2,3,6,7,10,11-triphenylenehexathiol) two-dimensional MOF, with a room-temperature mobility up to ~ 220 cm2 V-1 s-1. The temperature-dependent conductivity reveals that this mobility represents a lower limit for the material, as mobility is limited by impurity scattering. These results illustrate the potential for high-mobility semiconducting MOFs as active materials in thin-film optoelectronic devices.
RESUMEN
On-chip micro-supercapacitors (MSCs) are important Si-compatible power-source backups for miniaturized electronics. Despite their tremendous advantages, current on-chip MSCs require harsh processing conditions and typically perform like resistors when filtering ripples from alternating current (AC). Herein, we demonstrated a facile layer-by-layer method towards on-chip MSCs based on an azulene-bridged coordination polymer framework (PiCBA). Owing to the good carrier mobility (5×10-3 â cm2 V-1 s-1 ) of PiCBA, the permanent dipole moment of azulene skeleton, and ultralow band gap of PiCBA, the fabricated MSCs delivered high specific capacitances of up to 34.1â F cm-3 at 50â mV s-1 and a high volumetric power density of 1323â W cm-3 . Most importantly, such MCSs exhibited AC line-filtering performance (-73° at 120â Hz) with a short resistance-capacitance constant of circa 0.83â ms.
RESUMEN
The long-term stability of dye-sensitized solar cells (DSSCs) is determined to a large extent by the photodegradation of their sensitizers. Understanding the mechanism of light-induced decomposition of dyes sensitizing a mesoporous oxide matrix may therefore contribute to solutions to increase the life span of DSSCs. Here, we investigate, using ultrafast terahertz photoconductivity measurements, the evolution of interfacial electron-transfer (ET) dynamics in Ru(4,4'-dicarboxylic acid-2,2'-bipyridine)2(NCS)2 (N3) dye-sensitized mesoporous TiO2 electrodes upon dye photodegradation. Under inert environment, interfacial ET dynamics do not change over time, indicating that the dye is stable and photodegradation is absent; the associated ET dynamics are characterized by a sub-100 fs rise of the photoconductivity, followed by long-lived (â«1 ns) electrons in the oxide electrode. When the N3-TiO2 sample is exposed to air under identical illumination conditions, dye photodegradation is evident from the disappearance of the optical absorption associated with the dye. Remarkably, approximately half of the sub-100 fs ET is observed to still occur but is followed by very rapid (â¼10 ps) electron-hole recombination. Laser desorption/ionization mass spectrometry, attenuated total reflection-Fourier transform infrared, and terahertz photoconductivity analyses reveal that the photodegraded ET signal originates from the N3 dye photodegradation product as bi-isonicotinic acid (4,4'-dicarboxylic acid-2,2'-bipyridine), which remains bonded to the TiO2 surface via either bidentate chelation or bridging-type geometry.
RESUMEN
Methylammonium lead iodide perovskite is an outstanding semiconductor for photovoltaics. One of its intriguing peculiarities is that the band gap of this perovskite increases with increasing lattice temperature. Despite the presence of various thermally accessible phonon modes in this soft material, the understanding of how precisely these phonons affect macroscopic material properties and lead to the peculiar temperature dependence of the band gap has remained elusive. Here, we report a strong coupling of a single phonon mode at the frequency of ~ 1 THz to the optical band gap by monitoring the transient band edge absorption after ultrafast resonant THz phonon excitation. Excitation of the 1 THz phonon causes a blue shift of the band gap over the temperature range of 185 ~ 300 K. Our results uncover the mode-specific coupling between one phonon and the optical properties, which contributes to the temperature dependence of the gap in the tetragonal phase.Methylammonium lead iodide perovskite, a promising material for efficient photovoltaics, shows a unique temperature dependence of its optical properties. Kim et al. quantify the coupling between the optical gap and a lattice phonon at 1 THz, which favorably contributes to the thermal variation of the gap.
RESUMEN
The nature of the photoconductivity in solution-processed films of methylammonium lead iodide perovskite is investigated by determining the variation of the photoconductive response with temperature. Ultrabroadband terahertz (THz) photoconductivity spectra in the 0.3-10 THz range can be reproduced well by a simple Drude-like response at room temperature, where free charge carrier motion is characterized by an average scattering time. The scattering time determined from Drude fits in the 0.3-2THz region increases from â¼4 fs at 300 K (tetragonal phase; mobility of â¼27 cm(2) V(-1) s(-1)) to almost â¼25 fs at 77 K (orthorhombic phase, mobility of â¼150 cm(2) V(-1) s(-1)). For the tetragonal phase (temperature range 150 < T < 300 K) the scattering time shows a â¼T(-3/2) dependence, approaching the theoretical limit for pure acoustic phonon (deformation potential) scattering. Hence, electron-phonon, rather than impurity scattering, sets the upper limit on free charge transport for this perovskite.