In vivo comparison of wound healing and scar treatment effect between curcumin-oligochitosan nanoparticle complex and oligochitosan-coated curcumin-loaded-liposome.

This study aimed to compare the in vivo effectiveness between curcumin-oligochitosan nanoplexes (CUR-OCH nanoplexes) and oligochitosan-coated curcumin-encapsulated liposomes (OCH-Lip-CUR) with respect to wound healing and scar treatment. Firstly, CUR-OCH nanoplexes was prepared by drug-polysaccharide complexation method and OCH-Lip-CUR was prepared by a combining method of lipid-film hydration and sonication. Their in vitro cytotoxicity and in vivo wound healing and scar treatment effectiveness were evaluated using 3T3 cells and mice Mus musculus var. Albino, respectively. The resutls indicated that both of them were in nanosize with a moderate PDI (less than 0.3), and exhibited negligible cytotoxicity at low CUR concentration (0.01 mg/mL). Moreover, their application onto wounds resulted in faster healing and higher scar treatment effectiveness than control samples. Interestingly, OCH-Lip-CUR exhibited higher in vivo effectiveness than CUR-OCH nanoplexes. However, based on their own advantages, both of them were good candidates for a commercial formulation for wound healing and scar treatment.

Degradation of Triazole Fungicides by Plant Growth-Promoting Bacteria from Contaminated Agricultural Soil.

The widespread application of triazole fungicides (TFs) in agricultural practices can result in the considerable accumulation of active compound residues in the soil and a subsequent negative impact on the soil microbiota and crop health. In this study, we isolated three TF-degrading bacterial strains from contaminated agricultural soils and identified them as Klebsiella sp., Pseudomonas sp., and Citrobacter sp. based on analysis of morphological characteristics and 16S rRNA gene sequences. The strains used three common TFs, namely hexaconazole, difenoconazole, and propiconazole, as their only sources of carbon and energy for growth in a liquid mineral salt medium, with high concentrations (~ 500 mg/l) of each TF. In addition to the ability to degrade fungicides, the isolates also exhibited plant growth-promoting characteristics, such as nitrogen fixation, indole acetic acid production, phosphate dissolution, and cellulose degradation. The synergistic combination of three bacterial isolates significantly improved plant growth and development with an increased survival rate (57%), and achieved TF degradation ranging from 85.83 to 96.59% at a concentration of approximately 50 mg/kg of each TF within 45 days in the soil-plant system. Based on these findings, the three strains and their microbial consortium show promise for application in biofertilizers, to improve soil health and facilitate optimal plant growth.

HTDMA-modified bentonite clay for effective removal of Pb(II) from aqueous solution.

This work studies the Pb(II) removal onto bentonite clay modified by hexadecyl trimethyl ammonium bromide (HDTMA). Characterizations of the unmodified and modified materials were performed by using XRD, SEM, TG-DSC, FT-IR, and BET surface area analyses. Factors influencing the uptake of Pb(II) from aqueous solution, such as pHsolution, ion strength, uptake time, adsorbent dosage, and initial Pb(II) concentration, were examined. The obtained results showed that bentonite clay was successfully modified by HDTMA, resulting in an increase in its surface area by about 70 %. The Pb(II) adsorption onto modified bentonite clay reached equilibrium at pH = 5.0 after 120 min. Studies within the isotherm and kinetic models demonstrated that the adsorption followed the Sips isotherm and pseudo-second-order kinetic models. The maximum monolayer adsorption capacity calculated from the Langmuir model at 30 °C was 25.8 mg/g, which is much higher than that obtained for the unmodified sample (18.9 mg/g). The FT-IR and TG-DSC analyses indicated that the formation of inner-sphere complexes plays a fundamental role in the mechanism of Pb(II) uptake onto HDTMA-bentonite clay. This mechanism of Pb(II) adsorption was further investigated, for the first time, by using the positron annihilation lifetime (PAL) and electron momentum (EMD) measurements. The PAL and EMD analyses indicated that the existence of Al and Si mono-vacancies in the HDTMA-bentonite should have essential contributions to the adsorption mechanism. In particular, we found a very interesting mechanism that the Pb(II) adsorption should occur inside the interlayer spaces of the HDTMA-bentonite.