RESUMEN
China's Tianwen-1 Mars rover carries a laser-induced breakdown spectroscopy (LIBS) payload named MarSCoDe to analyze the mineral and rock composition on Mars. MarSCoDe is expected to experience a wide working temperature range of about 100 °C, which will lead to a spectral shift of up to â¼40 pixels (â¼8.13 nm). Even worse, drastic changes in temperature and environment may cause a loss or increase of some spectral lines of an on-board calibration Ti target. An elastic particle swarm optimization (PSO) approach is proposed to fulfill the on-board spectral calibration of MarSCoDe under this harsh condition. Through establishing a standard wavelength set (SWS) and an individual particle wavelength set (PWS), and further elastically selecting a part of PWS to compare with SWS, the problem of spectral shift and number mismatch can be solved gradually with the evolution of the particle swarm. Some tests of standard lamps and Ti with MarSCoDe, placed in a Mars simulation environment chamber (MSEC) in a temperature range of 70 °C, were completed. Compared with the standard spectrum of the Ti target (obtained at 20 °C), the spectral shifts of the first, second, and third channels are approximately 0.33 nm (5 pixels), 0.85 nm (6.4 pixels), and 8.09 nm (39.8 pixels), respectively, at -40 °C before correction; after PSO correction, the spectral shifts are greatly reduced to up to 0.015 nm, and specially for the 626.28 nm line, the spectral shift is reduced from 8.09 nm to about 0 nm. Experimental results demonstrate that the PSO-based approach can not only correct the on-board spectral shift but also solve the number mismatch of spectral lines of MarSCoDe in the harsh working environment of Mars. Further, it can be extended to the on-board calibration of other spectral payloads for deep space exploration.
Asunto(s)
Marte , Minerales , Calibración , Simulación por Computador , Análisis Espectral , TemperaturaRESUMEN
A remote Raman prototype with a function of excitation energy adjusting for the purpose of obtaining a Raman signal with good signal-to-noise ratio (SNR), saving power consumption, and possibly avoiding destroying a target by high energy pulses, which may have applications for Chinese planetary explorations, has been setup and demonstrated for detecting different minerals. The system consists of a spectrograph equipped with a thermoelectrically cooled charge-coupled device (CCD) detector, a telescope with 150 mm diameter and 1500 mm focus length, and a compact 1064 nm Nd:YAG Q-switched laser with an electrical adjusted pulse energy from 0 to 200 mJ/pulse. A KTP crystal was used for second harmonic generation in a 1064 nm laser to generate a 532 nm laser, which is the source of Raman scatting. Different laser pulse energies and integration time were used to obtain distinguishable remote Raman spectra of various samples. Results show that observed remote Raman spectra at a distance of 4 m enable us to identify silicates, carbonates, sulfates, perchlorates, water/water ice, and organics that have been found or may exist on extraterrestrial planets. Detailed Raman spectral assignments of the measured planetary materials and the feasible applications of remote Raman system for planetary explorations are discussed.
RESUMEN
Laboratory simulation is the only feasible way to achieve Martian environmental conditions on Earth, establishing a key link between the laboratory and Mars exploration. The mineral phases of some Martian surface materials (especially hydrated minerals), as well as their spectral features, are closely related to environmental conditions. Therefore, Martian environment simulation is necessary for Martian mineral detection and analysis. A Mars environment chamber (MEC) coupled with multiple in situ spectral sensors (VIS (visible)-NIR (near-infrared) reflectance spectroscopy, Raman spectroscopy, laser-induced breakdown spectroscopy (LIBS), and UV-VIS emission spectroscopy) was developed at Shandong University at Weihai, China. This MEC is a comprehensive research platform for Martian environmental parameter simulation, regulation, and spectral data collection. Here, the structure, function and performance of the MEC and the coupled spectral sensors were systematically investigated. The spectral characteristics of some geological samples were recorded and the effect of environmental parameter variations (such as gas pressure and temperature) on the spectral features were also acquired by using the in situ spectral sensors under various simulated Martian conditions. CO2 glow discharge plasma was generated and its emission spectra were assigned. The MEC and its tested functional units worked well with good accuracy and repeatability. China is implementing its first Mars mission (Tianwen-1), which was launched on 23 July 2020 and successfully entered into a Mars orbit on 10 February 2021. Many preparatory works such as spectral databases and prediction model building are currently underway using MECs, which will help us build a solid foundation for real Martian spectral data analysis and interpretation.
RESUMEN
Water ice and other volatiles that accumulated in the Moon's polar regions are among the top priority targets for lunar exploration, due to their significances in both lunar geology and extraterrestrial resource utilization. Locating suitable landing sites and determining the provenance of sampled/measured surface materials are critical for future landed missions. Here, we map over 800 sites of plains terrains in the Moon's south polar region, with a total surface area of ~46,000 km2. Orbital measurements and analog studies show that most of these plains have apparently higher albedo and lower iron content than volcanic mare plains, suggesting an origin of ejecta-induced debris flows from distant impact craters, especially from the Schrödinger basin. Our findings suggest that the entire lunar south polar region probably have experienced contributions from distant basin materials. We recommend these plains as priority landing sites for future exploration of lunar polar volatiles and early bombardment history.
RESUMEN
Perovskite single crystals have attracted tremendous attention owing to their excellent optoelectronic properties and stability compared to typical multicrystal structures. However, the growth of high-quality perovskite single crystals (PSCs) generally relies on temperature gradients or the introduction of additives to promote crystal growth. In this study, a vacuum evaporation crystallization technique is developed that allows PSCs to be grown under extremely stable conditions at constant temperature and without requiring additives to promote crystal growth. The new method enables the growth of PSCs of unprecedented quality, that is, MAPbBr3 single crystals that exhibit an ultranarrow full width at half maximum of 0.00701°, which surpasses that of all previously reported values. In addition, the MAPbBr3 single crystals deliver exceptional optoelectronic performance, including a long carrier lifetime of 1006 ns, an ultralow trap-state density of 3.67 × 109 cm-3, and an ultrahigh carrier mobility of 185.86 cm2 V-1 s-1. This method is applicable to various types of PSCs, including organic-inorganic hybrids, fully inorganic structures, and low-dimensional structures.
RESUMEN
Raman spectroscopy has emerged as a crucial mineral analysis technique in planetary surface exploration missions. Nonetheless, the inherently low Raman scattering efficiency of planetary silicate materials makes it challenging to extract enough Raman information. Theoretical and experimental studies of the remote Raman scattering properties of planetary materials are also urgent requirements for future lunar and planetary explorations. Here, Shandong University Remote Raman Spectrometer (SDU-RRS) was developed to demonstrate the feasibility of lunar remote Raman technology and conduct preliminary research on remote Raman scattering properties. SDU-RRS utilizes a pulsed 532 nm laser, a non-focal Cassegrain telescope, a volume phase holographic grating, an intensified charge-coupled device, and the time-gating technique to detect weak-signal silicate minerals. The spectral resolution obtained with atomic emission lamps was <4.91 cm-1, and the wavelength accuracy was <1 cm-1, across the spectral range of 241-2430 cm-1. SDU-RRS can detect natural augite within a feldspar-olivine-augite matrix at a concentration of 20 % at â¼1 m under ambient lighting conditions. A series of experiments were conducted to evaluate the influence of measurement conditions and physical matrix effects on acquired Raman signals, either qualitatively or quantitatively, on geological materials. The study indicates that the transmission of Raman-scattered light conforms to Lambert's cosine law, and a linear correlation exists between Raman intensity and laser power. The study also evaluated the impact of grain size, surface roughness, porosity, and shadow-hiding effects. Reducing grain size decreases Raman intensity and broadens Raman spectra. These characteristics are essential for achieving definitive mineralogical information from granular materials by remote Raman spectroscopy in lunar and planetary explorations.
RESUMEN
Lunar exploration is deemed crucial for uncovering the origins of the Earth-Moon system and is the first step for advancing humanity's exploration of deep space. Over the past decade, the Chinese Lunar Exploration Program (CLEP), also known as the Chang'e (CE) Project, has achieved remarkable milestones. It has successfully developed and demonstrated the engineering capability required to reach and return from the lunar surface. Notably, the CE Project has made historic firsts with the landing and on-site exploration of the far side of the Moon, along with the collection of the youngest volcanic samples from the Procellarum KREEP Terrane. These achievements have significantly enhanced our understanding of lunar evolution. Building on this success, China has proposed an ambitious crewed lunar exploration strategy, aiming to return to the Moon for scientific exploration and utilization. This plan encompasses two primary phases: the first crewed lunar landing and exploration, followed by a thousand-kilometer scale scientific expedition to construct a geological cross-section across the lunar surface. Recognizing the limitations of current lunar exploration efforts and China's engineering and technical capabilities, this paper explores the benefits of crewed lunar exploration while leveraging synergies with robotic exploration. The study refines fundamental lunar scientific questions that could lead to significant breakthroughs, considering the respective engineering and technological requirements. This research lays a crucial foundation for defining the objectives of future lunar exploration, emphasizing the importance of crewed missions and offering insights into potential advancements in lunar science.
RESUMEN
Electrostatic discharge experiments under simulated martian atmospheric conditions indicate that atmospheric CO2 has been sequestered into carbonate by the Mars dust activities during the Amazonia era.
RESUMEN
Peony seed oil (PSO) is a new woody nut oil which is unique to China. Its unsaturated fatty acids are over 90% and are rich in α - linolenic acid. Although the PSO industry is in its infancy, it is bound to become a top vegetable oil food material because of its own advantages. The potential high commercial profit of its adulteration with cheap vegetable oil will be an important factor hindering the healthy development of PSO industry. It is of great significance to study the adulteration of PSO for preventing large-scale adulteration. In this study, the qualitative and quantitative analysis of PSO was realised based on Raman spectroscopy combined with chemometrics analysis, and the fatty acid composition of PSO was analysed according to Raman characteristic peaks. The technology can be applied to routine analysis and quality control of PSO.
Asunto(s)
Ácidos Grasos/análisis , Análisis de los Alimentos/métodos , Paeonia/química , Aceites de Plantas/química , Semillas/química , China , Contaminación de Alimentos/prevención & control , Espectrometría RamanRESUMEN
How to quickly and safely identify blood species has always been an urgent problem for scientists. Smear test method has the risk of blood contamination, and the blood itself may carry some unknown viruses or pathogens, which will bring health risks to the testing personnel. Therefore, in order to meet the urgent needs of rapid and safe detection of blood, a technology which can detect dynamic confocal Raman spectroscopy of flowing blood in bionic blood vessel was proposed. The blood, which was sealed in the bionic blood vessel, flowed through the focus gaze area of laser by the microfluidic pump, to detect the dynamic blood Raman spectrum. Human blood and cattle blood were selected as experimental objects, and the experiments were carried out under the same parameters. Combined with PCA-LDA (principal component analysis and linear discriminate analysis) classification model, the predictive classification of the two species without error recognition was realized. The hidden weak Raman signals were mined by derivative spectra, and the fundamental differences of Raman spectra of two species were compared. Then the biochemical information that caused the differences was also analyzed. The results show the method can meet the detection requirements of sealed blood, and the Raman spectra of flowing blood is more representative than those of static blood.
Asunto(s)
Biónica , Espectrometría Raman , Animales , Bovinos , Análisis de Componente PrincipalRESUMEN
Based on the space group theory, the normal vibration modes of DKDP crystal were analyzed and the assigned. Raman spectra were measured at the room temperature. Results show that the lattice vibration spectra of DKDP arise mainly from the internal vibrations of D2PO4(-) anionic cluster. Compared with the Raman spectra of an aqueous solution of KH2PO4 and an NaD2(PO4)2 crystal, the four internal vibration models of the D2PO4(-) in DKDP were assigned as 881 cm(-1) (v1), 357 cm(-1) (v2), 514/541 cm(-1) (v3), 965 cm(-1) (v4), respectively.
RESUMEN
The chemical compositions of relatively young mare lava flows have implications for the late volcanism on the Moon. Here we report the composition of soil along the rim of a 450-m diameter fresh crater at the Chang'e-3 (CE-3) landing site, investigated by the Yutu rover with in situ APXS (Active Particle-induced X-ray Spectrometer) and VNIS (Visible and Near-infrared Imaging Spectrometer) measurements. Results indicate that this region's composition differs from other mare sample-return sites and is a new type of mare basalt not previously sampled, but consistent with remote sensing. The CE-3 regolith derived from olivine-normative basaltic rocks with high FeO/(FeO+MgO). Deconvolution of the VNIS data indicates abundant high-Ca ferropyroxene (augite and pigeonite) plus Fe-rich olivine. We infer from the regolith composition that the basaltic source rocks formed during late-stage magma-ocean differentiation when dense ferropyroxene-ilmenite cumulates sank and mixed with deeper, relatively ferroan olivine and orthopyroxene in a hybridized mantle source.