Adsorption properties of BSA and DsRed proteins deposited on thin SiO2 layers: optically non-absorbing versus absorbing proteins.

Protein adsorption on solid surfaces is of interest for many industrial and biomedical applications, where it represents the conditioning step for micro-organism adhesion and biofilm formation. To understand the driving forces of such an interaction we focus in this paper on the investigation of the adsorption of bovine serum albumin (BSA) (optically non-absorbing, model protein) and DsRed (optically absorbing, naturally fluorescent protein) on silica surfaces. Specifically, we propose synthesis of thin protein layers by means of dip coating of the dielectric surface in protein solutions with different concentrations (0.01-5.0 g l-1). We employed spectroscopic ellipsometry as the most suitable and non-destructive technique for evaluation of the protein layers' thickness and optical properties (refractive index and extinction coefficient) after dehydration, using two different optical models, Cauchy for BSA and Lorentz for DsRed. We demonstrate that the thickness, the optical properties and the wettability of the thin protein layers can be finely controlled by proper tuning of the protein concentration in the solution. These results are correlated with the thin layer morphology, investigated by AFM, FTIR and PL analyses. It is shown that the proteins do not undergo denaturation after dehydration on the silica surface. The proteins arrange themselves in a lace-like network for BSA and in a rod-like structure for DsRed to form mono- and multi-layers, due to different mechanisms driving the organization stage.

Structural phase transition causing anomalous photoluminescence behavior in perovskite (C6H11NH3)2[PbI4].

Optical and structural properties of the organic-inorganic hybrid perovskite-type (C6H11NH3)2[PbI4] (abbreviated as C6PbI4) were investigated using optical absorption, photoluminescence (PL), and x-ray diffraction measurements. Room temperature, optical absorption measurements, performed on spin-coated films of C6PbI4, revealed two absorption bands at 2.44 and 3.21 eV. Upon 325 nm (3.815 eV) laser irradiation, strong green PL emission peaks were observed at 2.41 eV (P1) and 2.24 eV (P2) and assigned to free and localized excitons, respectively. The exciton binding energy was estimated at 356 meV. At low temperature, two additional emission bands were detected at 2.366 eV (P3) and a large band (LB) at 1.97 eV. The former appeared only below 40 K and the latter emerged below 130 K. The thermal dependence of the PL spectra revealed an abnormal behavior accompanied by singularities in the peak positions and intensities at 40 and 130 K. X-ray diffraction studies performed on powder and single crystals as a function of temperature evidenced significant changes of the interlayer spacing at 50 K and ∼138 K. Around 138 K, a commensurate to incommensurate structural phase transition occurred on cooling. It involves a symmetry breaking leading to a distortion of the PbI6 octahedron. The resulting incommensurate spatial modulation of the Pb-I distances (and Pb-I-Pb angles) causes a spatial modulation of the band gap, which is at the origin of the emergence of the LB below ∼130 K and the anomalous behavior of the position of P1 below 130 K. The change of the interlayer spacing in the 40-50 K range may in turn be related to the significant decrease of the intensity of P2 and the maximum emission of the LB. These results underline the intricate character of the structural and the PL properties of the hybrid perovskites; understanding such properties should benefit to the design of optoelectronic devices with targeted properties.

Subharmonic resonant optical excitation of confined acoustic modes in a free-standing semiconductor membrane at GHz frequencies with a high-repetition-rate femtosecond laser.

We propose subharmonic resonant optical excitation with femtosecond lasers as a new method for the characterization of phononic and nanomechanical systems in the gigahertz to terahertz frequency range. This method is applied for the investigation of confined acoustic modes in a free-standing semiconductor membrane. By tuning the repetition rate of a femtosecond laser through a subharmonic of a mechanical resonance we amplify the mechanical amplitude, directly measure the linewidth with megahertz resolution, infer the lifetime of the coherently excited vibrational states, accurately determine the system's quality factor, and determine the amplitude of the mechanical motion with femtometer resolution.

Vibrational study of phase transition in N-benzyl methyl ammonium dihydrogenmonophosphate monohydrate.

Raman spectra (100-3200 cm(-1)) of polycrystalline samples of C(6)H(5)CH(2)NH(2)CH(3)H(2)PO(4).H(2)O were studied at temperature ranging from 77 to 350 K. By comparison with homologue compounds and calculated wavenumbers, an assignment of the observed bands is proposed. The thermal evolution of Raman spectra reveals an order-disorder phase transition at about 120 K involving the hydrogen bonds coupled with the distortion of the organic cations. The line at 244 cm(-1)assigned to tau(CH(3)) shows a remarkable evolution across the transition. Therefore, a careful analysis of the thermal evolution of this mode was performed using Porto model. The activation energy, obtained from the plot of Deltanu(1/2) versus temperature, is E(a)=1.27 kcal mol(-1). This value is of the same order of magnitude as the one found for homologue hydrogen bonded compounds.

Structural, vibrational and ab initio studies of L-histidine oxalate.

Single crystals of L-histidine oxalate were obtained by slow evaporation of an aqueous solution at room temperature. The grown crystals have been subjected to X-ray diffraction (XRD), Infrared, and Raman spectroscopy. The title compound crystallises in the non-centrosymmetric space group P2(1)2(1)2(1,) the crystal cohesion is achieved by relatively strong hydrogen bonds, so that the NH3 groups show significant distortion with respect to the tetrahedral symmetry. Raman and infrared spectra of the title compound were recorded in the frequency range 300-3200 and 400-4000 cm-1, respectively. To obtain a reliable assignment of the observed spectral lines, we have calculated the geometry and the frequencies of the vibrational modes of histidine cation and the oxalate anion using the semi empirical PM3 method.

Resonant surface plasmon-exciton interaction in hybrid MoSe2@Au nanostructures.

In this work we investigate the interaction between plasmonic and excitonic resonances in hybrid MoSe2@Au nanostructures. The latter were fabricated by combining chemical vapor deposition of MoSe2 atomic layers, Au disk processing by nanosphere lithography and a soft lift-off/transfer technique. The samples were characterized by scanning electron and atomic force microscopy. Their optical properties were investigated experimentally using optical absorption, Raman scattering and photoluminescence spectroscopy. The work is focused on a resonant situation where the surface plasmon resonance is tuned to the excitonic transition. In that case, the near-field interaction between the surface plasmons and the confined excitons leads to interference between the plasmonic and excitonic resonances that manifests in the optical spectra as a transparency dip. The plasmonic-excitonic interaction regime is determined using quantitative analysis of the optical extinction spectra based on an analytical model supported by numerical simulations. We found that the plasmonic-excitonic resonances do interfere thus leading to a typical Fano lineshape of the optical extinction. The near-field nature of the plasmonic-excitonic interaction is pointed out experimentally from the dependence of the optical absorption on the number of monolayer stacks on the Au nanodisks. The results presented in this work contribute to the development of new concepts in the field of hybrid plasmonics.

Plasmonic photo-current in freestanding monolayered gold nanoparticle membranes.

We report on photo-current generation in freestanding monolayered gold nanoparticle membranes excited by using a focused laser beam. The absence of a substrate leads to a 50% increase of the photo-current at the surface plasmon resonance. This current is attributed to a combination of trap state dynamics and bolometric effects in a nanocomposite medium yielding a temperature rise of 40 K.

Acoustic vibration modes and electron-lattice coupling in self-assembled silver nanocolumns.

Using ultrafast spectroscopy, we investigated electron-lattice coupling and acoustic vibrations in self-assembled silver nanocolumns embedded in an amorphous Al2O3 matrix. The measured electron-lattice energy exchange time is smaller in the nanocolumns than in bulk silver, with a value very close to that of isolated nanospheres with comparable surface to volume ratio. Two vibration modes were detected and ascribed to the breathing and extensional mode of the nanocolumns, in agreement with numerical simulations.

Surface enhanced Raman scattering of silver sensitized cobalt nanoparticles in metal-dielectric nanocomposites.

We report the preparation of a new type of nanocomposite containing cobalt and silver nanoparticles organized in parallel layers with a well controlled separation. This arrangement allows the observation of an enhanced low-frequency Raman signal at the vibration frequency of cobalt nanoparticles excited through the surface plasmons of silver nanoparticles. Numerical simulations of the electric field confirm the emergence of hot spots when the separation between silver and cobalt nanoparticles is small enough.