RESUMEN
The response of a free-standing graphene monolayer exposed to a few tens of femtoseconds long extreme ultraviolet (XUV) pulse was studied theoretically in order to analyze and compare contributions of various mechanisms to the graphene damage, understood here as a global atomic disintegration. Our simulation results indicate that nonthermal disintegration of the atomic structure is the predominant damage mechanism for a free-standing graphene layer. Only at high absorbed doses, charge-induced disintegration of the graphene structure prevails. We also demonstrate that the progressing damage can be probed by femtosecond optical pulses in the soft UV regime (4 eV photon energy). The achieved quantitative understanding of the damage mechanisms may enable a better control of graphene-based devices when they are exposed to x-ray radiation, as well as an efficient processing of graphene layers with ultrashort intense XUV pulses.
RESUMEN
A proof of concept is shown for the design of a high pressure heterogeneous catalysis reaction cell suitable for surface sensitive x-ray diffraction and x-ray reflectometry over planar samples using high energy synchrotron radiation in combination with mass spectrometry. This design enables measurements in a pressure range from several tens to hundreds of bars for surface investigations under realistic industrial conditions in heterogeneous catalysis or gaseous corrosion studies.
RESUMEN
Diffuse reflectance spectroscopy (DRS) can be used as a rapid and sensitive method for the quantitative determination of low amounts of aluminum. In this analytical technique, the analyte in samples are extracted onto a solid sorbent matrix loaded with a colorimetric reagent and then quantified directly on the adsorbent surface. Alternatively, colored aluminum complexes formed in solution can also be immobilized onto adsorbent surface and be measured by DRS technique. Octadecyl silica disk, methyltrioctylammonium chloride-naphthalene and MCM-41 were examined as adsorbents. Eriochrome cyanine R and quinalizarin were used as coloring reagents. Optimal sorption conditions were found for each system of analyte-reagent-adsorbent. The concentration of analyte is determined using the appropriate form of the Kubelka-Munk function. We obtained for each of the aluminium-reagent-adsorbent system a calibration curve by plotting the absorbance versus the log10(2)[Al(3+)]mugml(-1). The linear dynamic range extends over two orders of magnitude within 0.01-15mugml(-1) with little differences in the range and in the correlation coefficients among the adsorbents. We consider that for a rapid determination of aluminum a spot-test-DRS combination with a detection limit of 1.0x10(-2)mugml(-1) is the more facile and preferred technique.