RESUMEN
Organic additives are typically used in the pulse electrodeposition of copper (Cu) to prevent void formation during the filling of high aspect ratio features. In this work, the role of bath chemistry as modified by organic additives was investigated for its effects on Cu trench microstructure. Polyethylene glycol (PEG), bis(3-sulfopropyl) disulfide (SPS), and Janus green b (JGB) concentrations were varied in the Cu electrodeposition bath. Results indicated a correlation between the JGB/SPS ratio and the surface roughness and residual stresses in the Cu. Electron backscattering diffraction (EBSD) and transmission Kikuchi diffraction (TKD) were used to study the cross-sectional microstructure in the trenches. Finer grain morphologies appeared in trenches filled with organic additives as compared to additive-free structures. Cu trench (111) texture also decreased with increasing organic additive concentrations due to more pronounced influence of sidewall seed layers on trench features. Twin density in the microstructure closely tracked calculated stresses in the Cu trenches. A comprehensive microstructural analysis was conducted in this study, on an area of focus that has garnered little attention from the literature, yet can have a major impact on microelectronic reliability.
RESUMEN
In this work we studied the impact of pulse electroplating parameters on the cross-sectional and surface microstructures of blanket copper films using electron backscattering diffraction and x-ray diffraction. The films evaluated were highly (111) textured in the direction perpendicular to the film surface. The degree of preferential orientation was found to decrease with longer pulse on-times, due to strain energy driven growth of other grain orientations. Residual biaxial stresses were also measured in the films and higher pulse frequencies during deposition led to smaller biaxial stresses in the films. Film stress was also found to correlate with the amount of twinning in the copper film cross-sections. This has been attributed to the twins' thermal stability and mechanical properties.
RESUMEN
In this paper, we attempt to understand the physico-chemical changes that occur in devices during device "burn-in". We discuss the use of low frequency dielectric spectroscopy to detect, characterize and monitor changes in electrical defects present in the dielectrics of through silicon vias (TSV) for three dimensional (3D) interconnected integrated circuit devices, as the devices are subjected to fluctuating thermal loads. The observed changes in the electrical characteristics of the interconnects were traceable to changes in the chemistry of the isolation dielectric used in the TSV construction. The observed changes provide phenomenological insights into the practice of burn-in. The data also suggest that these "chemical defects" inherent in the 'as-manufactured' products may be responsible for some of the unexplained early reliability failures observed in TSV enabled 3D devices.
RESUMEN
Nondestructive measurements of the full elastic strain and stress tensors from individual dislocation cells distributed along the full extent of a 50â µm-long polycrystalline copper via in Si is reported. Determining all of the components of these tensors from sub-micrometre regions within deformed metals presents considerable challenges. The primary issues are ensuring that different diffraction peaks originate from the same sample volume and that accurate determination is made of the peak positions from plastically deformed samples. For these measurements, three widely separated reflections were examined from selected, individual grains along the via. The lattice spacings and peak positions were measured for multiple dislocation cell interiors within each grain and the cell-interior peaks were sorted out using the measured included angles. A comprehensive uncertainty analysis using a Monte Carlo uncertainty algorithm provided uncertainties for the elastic strain tensor and stress tensor components.