Process Optimization and Equilibrium, Thermodynamic, and Kinetic Modeling of Toxic Congo Red Dye Adsorption from Aqueous Solutions Using a Copper Ferrite Nanocomposite Adsorbent.

In the present investigation of copper ferrite, a CuFe2O4 nanocomposite adsorbent was synthesized using the sol-gel method, and its relevance in the adsorptive elimination of the toxic Congo red (CR) aqueous phase was examined. A variety of structural methods were used to analyze the CuFe2O4 nanocomposite; the as-synthesized nanocomposite had agglomerated clusters with a porous, irregular, rough surface that could be seen using FE-SEM, and it also contained carbon (23.47%), oxygen (44.31%), copper (10.21%), and iron (22.01%) in its elemental composition by weight. Experiments were designed to achieve the most optimized system through the utilization of a central composite design (CCD). The highest uptake of CR dye at equilibrium occurred when the initial pH value was 5.5, the adsorbate concentration was 125 mg/L, and the adsorbent dosage was 3.5 g/L. Kinetic studies were conducted, and they showed that the adsorption process followed a pseudo-second-order (PSO) model (regression coefficient, R2 = 0.9998), suggesting a chemisorption mechanism, and the overall reaction rate was governed by both the film and pore diffusion of adsorbate molecules. The process through which dye molecules were taken up onto the particle surface revealed interactions involving electrostatic forces, hydrogen bonding, and pore filling. According to isotherm studies, the equilibrium data exhibited strong agreement with the Langmuir model (R2 = 0.9989), demonstrating a maximum monolayer adsorption capacity (qmax) of 64.72 mg/g at pH 6 and 302 K. Considering the obtained negative ΔG and positive ΔHads and ΔSads values across all tested temperatures in the thermodynamic investigations, it was confirmed that the adsorption process was characterized as endothermic, spontaneous, and feasible, with an increased level of randomness. The CuFe2O4 adsorbent developed in this study is anticipated to find extensive application in effluent treatment, owing to its excellent reusability and remarkable capability to effectively remove CR in comparison to other adsorbents.

Rapid Removal of Toxic Remazol Brilliant Blue-R Dye from Aqueous Solutions Using Juglans nigra Shell Biomass Activated Carbon as Potential Adsorbent: Optimization, Isotherm, Kinetic, and Thermodynamic Investigation.

Recently, the treatment of effluent by agricultural waste biomass has significantly attracted wide interest among researchers due to its availability, efficacy, and low cost. The removal of toxic Remazol Brilliant Blue-R (RBBR) from aqueous solutions using HNO3-treated Juglans nigra (walnut) shell biomass carbon as an adsorbent has been examined under various experimental conditions, such as initial pH, adsorbate concentration, adsorbent dosage, particle size, agitation speed, and type of electrolyte. The experiments are designed to achieve the maximum dye removal efficiency using the response surface methodology (RSM). The optimum pH, adsorbent dosage, and particle size were found to be 1.5, 7 g L-1, and 64 µm, respectively for maximum decolorization efficiency (98.24%). The prepared adsorbent was characterized by particle size, Brunauer-Emmett-Teller (BET) surface area, pore volume, zero-point charge (pHzpc), Fourier transform infrared spectroscopy (FT-IR), field emission scanning electron microscopy/energy dispersive X-ray spectroscopy (FE-SEM/EDX), X-ray diffraction (XRD), and thermogravimetric analysis (TGA). Based on fitting the experimental data with various models, the isotherm and kinetic mechanism are found to be more appropriate with Langmuir isotherm and pseudo-second-order kinetics. The adsorption mechanism can be described by the intra-particle diffusion model, Bangham, and Boyd plots. The overall rate of adsorption is controlled by the external film diffusion of dye molecules. The maximum monolayer adsorption capacity, (qmax) 54.38 mg g-1 for RBBR dye, was obtained at a temperature of 301 K. From a thermodynamic standpoint, the process is endothermic, spontaneous, and the chemisorption process is favored at high temperatures. Desorption studies were conducted with various desorbing reagents in various runs and the maximum desorption efficiency (61.78% in the third run) was obtained using the solvent methanol. Reusability studies demonstrated that the prepared adsorbent was effective for up to three runs of operation. The investigation outcomes concluded that walnut shell biomass activated carbon (WSBAC) is a cost-effective, eco-friendly, and bio-sustainable material that can be used for synthetic dye decolorization in aqueous media.

Fine-Tuned Graphene Oxide Nanocomposite: Harnessing Copper(II)-Imidazole Complex for Enhanced Biological Responses and Balanced Photocatalytic Functionality.

In this study, the synthesis of biologically active copper(II) complex [Cu(im)2]Cl2 was achieved using a reported method. Subsequently, this copper(II) complex was strategically grafted onto graphene oxide, resulting in the formation of a nanocomposite denoted as copper(II)-complex-grafted graphene oxide (Cu-GO). The comprehensive characterization of Cu-GO was conducted through various techniques, including X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FT-IR), UV-visible spectroscopy, emission spectra analysis, X-ray photoelectron spectroscopy (XPS), and Copper K-edge X-ray Absorption Near Edge Structure (XANES) spectroscopy. The antibacterial efficacy of Cu-GO compounds was assessed using disk diffusion and microbroth dilution methods. Notably, the copper complex exhibited the highest effectiveness, showcasing a Minimal Inhibitory Concentration (MIC) value of 500 µL against Klebsiella bacteria. The antibacterial activities of all compounds were systematically screened, revealing the superior performance of the copper complex compared to standalone copper compounds. Expanding the scope of the investigation, we explored the antioxidant and anti-obesity activities of the copper complexes against Klebsiella organisms. The results underscore promising directions for the further exploration of the diverse health-related applications of these compounds. Moreover, the photocatalytic performance of the Cu-GO nanocomposite was evaluated under sunlight irradiation. Notably, the antioxidant and anti-obesity activities of Cu-GO, assessed in terms of percentage inhibition at a concentration of 200 mg/mL, exhibited values of 41% and 45%, respectively. Additionally, the Cu-GO composite exhibited exceptional efficacy, achieving a degradation efficiency of 74% for RhB under sunlight irradiation, surpassing both graphite and GO. These findings not only demonstrate enhanced biological activity, but also highlight a notable level of moderate photocatalytic performance. Such dual functionality underscores the potential versatility of Cu-GO nanocomposites across various applications, blending heightened biological efficacy with controlled photocatalysis. Our study offers valuable insights into the multifunctional attributes of copper(II)-complex-grafted graphene oxide nanocomposites, thereby paving the way for their broader utilization in diverse fields.

Continuous Fixed-Bed Column Studies on Congo Red Dye Adsorption-Desorption Using Free and Immobilized Nelumbo nucifera Leaf Adsorbent.

The adsorption of Congo red (CR), an azo dye, from aqueous solution using free and immobilized agricultural waste biomass of Nelumbo nucifera (lotus) has been studied separately in a continuous fixed-bed column operation. The N. nucifera leaf powder adsorbent was immobilized in various polymeric matrices and the maximum decolorization efficiency (83.64%) of CR occurred using the polymeric matrix sodium silicate. The maximum efficacy (72.87%) of CR dye desorption was obtained using the solvent methanol. Reusability studies of free and immobilized adsorbents for the decolorization of CR dye were carried out separately in three runs in continuous mode. The % color removal and equilibrium dye uptake of the regenerated free and immobilized adsorbents decreased significantly after the first cycle. The decolorization efficiencies of CR dye adsorption were 53.66% and 43.33%; equilibrium dye uptakes were 1.179 mg g-1 and 0.783 mg g-1 in the third run of operation with free and immobilized adsorbent, respectively. The column experimental data fit very well to the Thomas and Yoon-Nelson models for the free and immobilized adsorbent with coefficients of correlation R2 ≥ 0.976 in various runs. The study concludes that free and immobilized N. nucifera can be efficiently used for the removal of CR from synthetic and industrial wastewater in a continuous flow mode. It makes a substantial contribution to the development of new biomass materials for monitoring and remediation of toxic dye-contaminated water resources.