Assessment of biomass ash applications in soil and cement mortars.

The pH-dependent availability and leaching of major and trace elements was investigated for a wide range of biomass ash from different fuels and conversion technologies. A technical and environmental assessment of selected biomass ash for application in soil or cement mortars was performed, using both the total content and leaching of elements. A large variation in biomass ash composition, yet consistent pH dependent leaching patterns were observed for most elements and conversion technologies. Chromium showed a distinct behaviour which was hypothesized to reflect redox conditions during conversion of the biomass. The leaching based approach was found to provide a more realistic assessment of the availability of desired (i.e. nutrients) and undesired elements (i.e. contaminants) in soil systems. When applied to a reference soil at a rate of 2% by weight, the selected biomass ash increased the concentration of particularly Cr, Mo and Zn in soil solution to a level of concern. For cement applications, the release of Ba, Cr and Mo can become of concern during the second life stage, but the release was not attributed to the included biomass ash. Both soil and cement matrixes were found to control the release of elements such as Cu, V and Ni (soil) and As, Cr and Mo (cement) when compared to the released from pure biomass ash, underlining the importance of evaluating the availability and leaching of desired and undesired elements in the application scenario. Given current regulatory criteria, beneficial utilization of biomass ash in cement may be more feasible than in soil, but regulatory criteria based on leaching rather than total content of elements may widen the application potential of biomass ash.

Pilot-scale conversion of lime-treated wheat straw into bioethanol: quality assessment of bioethanol and valorization of side streams by anaerobic digestion and combustion.

INTRODUCTION: The limited availability of fossil fuel sources, worldwide rising energy demands and anticipated climate changes attributed to an increase of greenhouse gasses are important driving forces for finding alternative energy sources. One approach to meeting the increasing energy demands and reduction of greenhouse gas emissions is by large-scale substitution of petrochemically derived transport fuels by the use of carbon dioxide-neutral biofuels, such as ethanol derived from lignocellulosic material. RESULTS: This paper describes an integrated pilot-scale process where lime-treated wheat straw with a high dry-matter content (around 35% by weight) is converted to ethanol via simultaneous saccharification and fermentation by commercial hydrolytic enzymes and bakers' yeast (Saccharomyces cerevisiae). After 53 hours of incubation, an ethanol concentration of 21.4 g/liter was detected, corresponding to a 48% glucan-to-ethanol conversion of the theoretical maximum. The xylan fraction remained mostly in the soluble oligomeric form (52%) in the fermentation broth, probably due to the inability of this yeast to convert pentoses. A preliminary assessment of the distilled ethanol quality showed that it meets transportation ethanol fuel specifications. The distillation residue, which contained non-hydrolysable and non-fermentable (in)organic compounds, was divided into a liquid and solid fraction. The liquid fraction served as substrate for the production of biogas (methane), whereas the solid fraction functioned as fuel for thermal conversion (combustion), yielding thermal energy, which can be used for heat and power generation. CONCLUSION: Based on the achieved experimental values, 16.7 kg of pretreated wheat straw could be converted to 1.7 kg of ethanol, 1.1 kg of methane, 4.1 kg of carbon dioxide, around 3.4 kg of compost and 6.6 kg of lignin-rich residue. The higher heating value of the lignin-rich residue was 13.4 MJ thermal energy per kilogram (dry basis).