RESUMEN
The hydrogen storage properties of Li(7)VN(4) and Li(7)MnN(4) were investigated both by experiment and by density functional theory calculations. Li(7)VN(4) did not sorb hydrogen under our experimental conditions. Li(7)MnN(4) was observed to sorb 7 hydrogen atoms through the formation of LiH, Mn(4)N, and ammonia gas. An applied pressurized mixture of H(2)/Ar and H(2)/N(2) gases was helpful to mitigate the release of NH(3) but could not prevent its formation. The introduction of N(2) also caused weight gain of the sample by re-nitriding the absorbed products LiH and Mn(4)N, which correlated with the presence of Li(2)NH, LiNH(2), and Mn(2)N detected by X-ray diffraction. While our observed results for Li(7)VN(4) and Li(7)MnN(4) differ in detail, they are in overall qualitative agreement with our theoretical work, which strongly suggests that both compounds are unlikely to form quaternary hydrides.
RESUMEN
The local bonding and atomic environments in the Ni-catalyzed destabilized system LiBH4/MgH2 and the quaternary borohydride-amide phase Li3BN2H8, were studied by x-ray absorption spectroscopy. In both cases the Ni catalyst was introduced as NiCl2 and a qualitative comparison of the Ni K-edge near-edge structure suggests the Ni2+ is reduced to primarily Ni0 after ball milling. The extended fine structure of the Ni K edge indicates that the Ni is coordinated by approximately 3 boron atoms with an interatomic distance of approximately 2.1 A and approximately 11 Ni atoms in a split shell at around 2.5 and 2.8 A. These results, and the lack of long-range order, suggest that the Ni is present as a disordered nanocluster with a local structure similar to that of Ni3B. In the fully hydrogenated phase of LiBH4/MgH2 a small amount Mg2NiHx was also present. Surface calculations performed using density functional theory suggest that the lowest kinetic barrier for H2 chemisorption occurs on the Ni3B(100) surface.
Asunto(s)
Boratos/química , Hidrógeno/química , Compuestos de Litio/química , Modelos Químicos , Nanoestructuras/química , Nanoestructuras/ultraestructura , Nanotecnología/métodos , Níquel/química , Catálisis , Simulación por Computador , Cristalización/métodos , Sustancias Macromoleculares/química , Ensayo de Materiales , Conformación Molecular , Tamaño de la Partícula , Propiedades de SuperficieRESUMEN
Chemically ordered L10-type FeNi, also known as tetrataenite, is under investigation as a rare-earth-free advanced permanent magnet. Correlations between crystal structure, microstructure and magnetic properties of naturally occurring tetrataenite with a slightly Fe-rich composition (~ Fe55Ni44) obtained from the meteorite NWA 6259 are reported and augmented with computationally derived results. The tetrataenite microstructure exhibits three mutually orthogonal crystallographic variants of the L10 structure that reduce its remanence; nonetheless, even in its highly unoptimized state tetrataenite provides a room-temperature coercivity of 95.5 kA m(-1) (1200 Oe), a Curie temperature of at least 830 K and a largely temperature-independent anisotropy that preliminarily point to a theoretical magnetic energy product exceeding (BH)max = 335 kJ m(-3) (42 MG Oe) and approaching those found in today's best rare-earth-based magnets.