The effects of irrigation volume to the heat generation during implant surgery.

BACKGROUND: To evaluate the effects of the amount of irrigation on heat generated during implant site preparation. MATERIAL AND METHODS: Ten freshly dissected sheep mandibles were sectioned into 30 equal bone blocks and transferred into a heat-controlled water tank. Implant socket preparations were performed with four consecutive drills. Temperature measurements were performed with a thermocouple inserted into the bone immediately before the preparation and after the drilling using three different physiologic saline irrigation set-ups: 1- No irrigation, 2- 12 ml/min and 3- 30 ml/min irrigation volume. The temperature differences between three different irrigation set-ups for implant drills 1, 2, 3 and 4, and the temperature differences between the drills for three different irrigation set-ups were separately compared. RESULTS: The temperature difference of no irrigation group was significantly higher than 12 ml/min and 30 ml/min groups for all four drills (p<0.05), whereas no statistically significant difference was found between 12 ml/min and 30 ml/min irrigation groups. (p>0.05) The temperature difference of drill 1 is significantly higher than drills 2, 3 and 4 for no irrigation group. (p<0.05) The temperature differences of drill 1, 2 and 3 were significantly higher than the temperature difference of drill 4 for 12 ml/min irrigation group. (p<0.05) Conclusions: The heat generated during drilling is not directly proportional to the coolant volume. Given that certain amount of irrigation is applied, implant sites can be prepared safely without the need for additional irrigation, which may result in reduced visibility of the surgical site and therefore a suboptimal surgery.

Evaluation of different screw fixation techniques and screw diameters in sagittal split ramus osteotomy: finite element analysis method.

Sagittal split ramus osteotomy (SSRO) is used for correction of numerous congenital or acquired deformities in facial region. Several techniques have been developed and used to maintain fixation and stabilisation following SSRO application. In this study, the effects of the insertion formations of the bicortical different sized screws to the stresses generated by forces were studied. Three-dimensional finite elements analysis (FEA) and static linear analysis methods were used to investigate difference which would occur in terms of forces effecting onto the screws and transmitted to bone between different application areas. No significant difference was found between 1·5- and 2-mm screws used in SSRO fixation. Besides, it was found that 'inverted L' application was more successful compared to the others and that was followed by 'L' and 'linear' formations which showed close rates to each other. Few studies have investigated the effect of thickness and application areas of bicortical screws. This study was performed on both advanced and regressed jaws positions.

Evaluation of the course of the marginal mandibular branch of the facial nerve: a fresh cadaveric study.

The aim of this study was to determine the course of marginal mandibular nerve (MMN) in relation to the inferior border of the mandible from the gonion until its terminal insertion to the depressor anguli oris, relating the position to a palpable anatomical landmark with emphasis on the depth of the nerve in relation to platysma and the deep cervical fascia. Twelve fresh adult cadavers were dissected and the mandibular base was contoured using needles with 5mm gaps, starting from the mandibular angle to the muscular termination point of the nerve bilaterally. The distance between the MMN and the mandibular base and total length of the nerve was measured bilaterally. The highest levels of MMN were measured 6.9mm and 6.5mm above, and the lowest levels were measured 4mm and 3mm below the mandibular base on right and left sides, respectively. The mean (SD) total length of the nerve until the muscular termination point was calculated 33.57 (3.41) mm on the right and 33.51 (4.88) mm on the left side. Previous publications that we had read all fell short of defining the schematic pathway of the nerve, as the described landmarks were of a combination of bone and soft tissue, which are not always clinically reliable. We have overcome this difficulty by standardising the inferior border of the mandible as a point in order to trace the marginal mandibular branch pathway. It originates along the gonion and ends at the second premolar tooth area.

RETRACTED: Management of seborrhoeic keratosis and actinic keratosis with an erbium:YAG laser-experience with 547 patients.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal). This article has been retracted at the request of the Editors because the photograph in Figure 1b was a duplicate image of Figure 1a, but with the keratosis removed, and did not represent the surgery that was described in the article. The authors apologise for this error.

Intrasinusal locking technique: a novel use of the ring block technique at sinus perforations for simultaneous implant placement.

Ten patients who underwent sinus lift surgery with simultaneous implant placement using the intrasinusal locking technique were evaluated retrospectively. All patients were scheduled for sinus floor elevation procedures with simultaneous implant placement. Schneiderian membrane perforation occurred during the lifting procedure, and conventional methods failed to repair the perforation. Therefore, an autogenous bone ring was placed at the base of the maxillary sinus and was locked to the alveolar crest with a dental implant. Marginal resorption around the dental implants was measured on panoramic radiographs. Prosthetic rehabilitation was performed at 6 months postoperative. The overall survival rate of the implants over a mean follow-up of 24.3 months was 90%. One case failed due to resorption of the alveolar crest around the implant as a result of infection; the implant and the adjacent ring were removed at 1 month postoperative. At the time of writing, the nine implants placed using the documented technique continue to function well, without any signs of peri-implant disease. The proposed approach allows for simultaneous dental implant placement in the extremely atrophic maxilla, even if there is extensive perforation of the Schneiderian membrane.

Percutaneous treatment of orofacial vascular malformations.

The aim of this study was to evaluate the efficacy of fluoroscopy-guided percutaneous injection of bleomycin as the primary treatment for low-flow vascular malformations. A total of 34 patients (mean (range) age 24 (8-51) years) with orofacial vascular lesions were treated in the Department of Interventional Radiology and Maxillofacial Surgery. There were 20 low-flow venous malformations, 11 lymphatic malformations, and three of mixed type. All patients were treated by fluoroscopy-guided percutaneous injection of a mixture of bleomycin (mean (range) 15 (5-15)mg) and a radio-opaque agent (Ultravist® (iopromide), Bayer)/session. The number of sessions ranged from one to six. The clinical response was complete in 21 patients, obvious in nine, and of clinical benefit in four. Patients were reviewed within the first week, third week, and at three-month periods until 24 months. There were no serious complications such as pulmonary fibrosis. Fluoroscopy-guided intralesional injection of bleomycin should be considered as the first-line treatment for lymphatic malformations because it is effective and reliable with few complications.