RESUMEN
Quasi-solid-state rechargeable zinc-air batteries (ZABs) are suitable for the generation of portable clean energy due to their high energy and power density, safety, and cost-effectiveness. Compared to the typical alkaline aqueous electrolyte in a ZAB, polymer or gel-based electrolytes can suppress the dissolution of zinc, preventing the precipitation of undesirable irreversible zinc compounds. Their low electronic conductivity minimizes zinc dendrite formation. However, gel electrolytes suffer from capacity fade due to the loss of the volatile solvent, failing to deliver high-energy and high-power ZABs. Consequently, developing polymers with high hydroxide ion conductivity and chemical durability is paramount. We report cationic C-C bonded robust polymers with stoichiometrically controlled mobile hydroxide ions as solid-state hydroxide ion transporters. To boot, we increased the viologen-hydroxide-ion concentration through "by-design" monomers. The polymers constructed with these designer monomers exhibit a commensurate increase in their ionic conductivity. The polymer prepared with 4 OH- ion-containing monomer was superior to the one with 3 OH-. The conductivity increases from 7.30 × 10-4 S cm-1 (30 °C) to 2.96 × 10-3 S cm-1 (30 °C) at 95% RH for IISERP-POF12_OH (2_OH) and IISERP-POF13_OH (3_OH), respectively. A rechargeable ZAB (RZAB) constructed using 3_OH@PVA (polyvinyl alcohol) as the electrolyte membrane and Pt/C + RuO2 catalyst delivers a power density of 158 mW cm-2. In comparison, RZABs with a PVA interlayer provided only 72 mW cm-2. Notably, the device suffered an initial charge-discharge voltage gap of merely 0.55 V at 10 mA cm-2, which increased by only 2 mV after 50 hours of running. The battery operated at 10 mA cm-2 and worked steadily for 67 hours. We accomplished a flexible and rechargeable zinc-air battery (F-RZAB) exhibiting a maximum power density of 79 mW cm-2. This demonstration of a cationic viologen-bakelite polymer-based flexible secondary ZAB with versatile stochiometric hydroxide-ion tunability marks an important achievement in hydroxide-ion conducting solid-state electrolyte development.
RESUMEN
Ultramicroporous MOFs enable tight packing of the active functional groups, directly impacting the selective guest-framework interactions. MOFs with pores simultaneously lined by methyl and amine may serve as the ultimate humid CO2 sorbent. However, structural complexity prevents taking full advantage even in a simple zinc-triazolato-acetate layered-pillared MOF.
RESUMEN
Adaptable polymer-based solid-state electrolytes can be a game-changer toward safe, lightweight flexible batteries. We present a robust Bakelite-type organic polymer covalently decked with viologen, triazine, and phenolic moieties. Its flexible structure with cationic viologen centers incorporates counter-balancing free hydroxide ions into the polymeric framework. By design, the aromatic groups and heteroatoms in the framework can be activated under an applied potential to prompt a push-pull drive, setting off the towing of hydroxide ions via weak electrostatic, van der Waals, and hydrogen-bond interactions. The frontier orbitals from a DFT-modeled structure certify this. The hydroxyl-polymer requires minimal KOH wetting to maintain a humid environment for Grotthuss-type transport. The hydroxide ion conductivity reaches a value of 1.4 × 10-2 S cm-1 at 80 °C and 95% RH, which is retained for over 15 h. We enhanced its practical utility by coating it as a thin solid-state separator-cum-electrolyte on readily available filter paper. The composite exhibits a conductivity of 4.5 × 10-3 S cm-1 at 80 °C and 95% RH. A zinc-air battery (ZAB) constructed using this polymer-coated paper as electrolyte yields a maximum power density of 115 mW cm-2 and high specific capacitance of 435 mA h g-1. The power density recorded for our ZAB is among the best reported for polymer electrolyte-based batteries. Subsequently, the flexible battery fabricated with IISERP-POF11_OH@FilterPaper exhibits an OCV of 1.44 V, and three batteries in series power a demo traffic signal. To underscore the efficiency of hydroxide ion transport through the complex multifunctional backbone of the polymer, we calculated the diffusion coefficient for OH- (Exp: 2.9 × 10-5 cm2 s-1; Comp. 5.2 × 10-6 cm2 s-1) using electrochemical methods and MD simulations. Climbing-edge NEB calculations reveal a large energy barrier of 2.11 eV for Zn2+ to penetrate the polymer and identify hydroxide ions within the polymer, suggesting no undesirable Zn2+ crossover. Our findings assert the readily accessible C-C-linked cationic polymer's capacity as a solid-state electrolyte for ZABs and any anion-conducting membrane.
RESUMEN
A composite of catalytic Lewis acidic zirconium oxyhydroxides (8 wt %) and a covalent organic framework (COF) was synthesized. X-ray diffraction and infrared (IR) spectroscopy reveal that COF's structure is preserved after loading with zirconium oxyhydroxides. Electron microscopy confirms a homogeneous distribution of nano- to sub-micron-sized zirconium clusters in the COF. 3D X-ray tomography captures the micron-sized channels connecting the well-dispersed zirconium clusters on the COF. The crystalline ZrOx(OH)y@COF's nanostructure was model-optimized via simulated annealing methods. Using 0.8 mol % of the catalyst yielded a turnover number of 100-120 and a turnover frequency of 160-360 h-1 for Knoevenagel condensation in aqueous medium. Additionally, 2.2 mol % of catalyst catalyzes the hydrolysis of dimethyl nitrophenyl phosphate, a simulant of nerve agent Soman, with a conversion rate of 37% in 180 min. The hydrolytic detoxification of the live agent Soman is also achieved. Our study unveils COF-stabilized ZrOx(OH)y as a new class of zirconium-based Lewis + Bronsted-acid catalysts.
RESUMEN
Coordination flexibility assisted porosity has been introduced into an Iron-isonicotinate metal-organic framework (MOF), (Fe(4-PyC)2 â (OH). The framework showed CO2 -specific gate opening behavior, which gets tuned as a function of temperature and pressure. The MOF's physisorptive porosity towards CO2 , CH4 , and N2 was investigated; it adsorbed only CO2 via a gate opening phenomenon. The isonicotinate, representing a borderline soft base, is bound to the hard Fe3+ centre through monodentate carboxylate and pyridyl nitrogen. This moderately weak binding enables isonicotinate to spin like a spindle under the CO2 pressure opening the gate for a sharp increase in CO2 uptake at 333 mmHg (At 298â K, the CO2 uptake increases from 0.70 to 1.57â mmol/g). We investigated the MOF's potential for CO2 /N2 and CO2 /CH4 gas separation aided by this gating. IAST model reveals that the CO2 /N2 selectivity jumps from 325 to 3131 when the gate opens, while the CO2 /CH4 selectivity increases three times. Interestingly, this Fe-isonicotinate MOF did not follow the trend set by our earlier reported Hard-Soft Gate Control (established for isostructural M2+ -isonicotinate MOFs (M=Mg, Mn)). However, we account for this discrepancy using the different oxidation state of metals confirmed by X-ray photoelectron spectroscopy and magnetism.
RESUMEN
Carbon capture from industrial effluents such as flue gas or natural gas mixture (cf. landfill gas), the primary sources of CO2 emission, greatly aids in balancing the environmental carbon cycle. In this context, the most energy-efficient physisorptive CO2 separation process can benefit immensely from improved porous sorbents. Metal organic frameworks (MOFs), especially the ultramicroporous MOFs, built from readily available small and rigid ligands, are highly promising because of their high selectivity (CO2/N2) and easy scalability. Here, we report two new ultramicroporous Co-adeninato isophthalate MOFs. They concomitantly carry basic functional groups (-NH2) and Lewis acidic sites (coordinatively unsaturated Co centers). They show good CO2 capacity (3.3 mmol/g at 303 K and 1 bar) along with high CO2/N2 (â¼600 at 313 K and 1 bar and â¼340 at 303 K and 1 bar) selectivity, working capacity, and smooth diffusion kinetics (Dc = 7.5 × 10-9 m2 s-1). The MOFs exhibit good CO2/N2 kinetic separation under both dry and wet conditions with a smooth breakthrough profile. Despite their well-defined CO2 adsorption sites, these MOFs exhibit only a moderately strong interaction with CO2 as evidenced from their HOA values. This counterintuitive observation is ubiquitous among many MOFs adorned with strong CO2 adsorption sites. To gain insights, we have identified the binding sites for CO2 using simulation and MD studies. The radial distribution function analysis reveals that despite the amine and bare-metal sites, the pore size and the pore structure determine the positions for the CO2 molecules. The most favorable sites become the confined spaces lined by aromatic rings. A plausible explanation for the lack of strong adsorption in these MOFs is premised from these collective studies, which could aid in the future design of superior CO2 sorbents.
RESUMEN
Covalent organic frameworks are a new class of crystalline organic polymers possessing a high surface area and ordered pores. Judicious selection of building blocks leads to strategic heteroatom inclusion into the COF structure. Owing to their high surface area, exceptional stability and molecular tunability, COFs are adopted for various potential applications. The heteroatoms lining in the pores of COF favor synergistic host-guest interaction to enhance a targeted property. In this report, we have synthesized a resorcinol-phenylenediamine-based COF which selectively adsorbs CO2 into its micropores (12â Å). The heat of adsorption value (32â kJ mol-1 ) obtained from the virial model at zero-loading of CO2 indicates its favorable interaction with the framework. Furthermore, we have anchored small-sized Ag nanoparticles (≈4-5â nm) on the COF and used the composite for chemical fixation of CO2 to alkylidene cyclic carbonates by reacting with propargyl alcohols under ambient conditions. Ag@COF catalyzes the reaction selectively with an excellent yield of 90 %. Recyclability of the catalyst has been demonstrated up to five consecutive cycles. The post-catalysis characterizations reveal the integrity of the catalyst even after five reaction cycles. This study emphasizes the ability of COF for simultaneous adsorption and chemical fixation of CO2 into corresponding cyclic carbonates.
RESUMEN
Here, we report two novel water-stable amine-functionalized MOFs, namely IISERP-MOF26 ([NH2 (CH3 )2 ][Cu2 O(Ad)(BDC)]â (H2 O)2 (DMA), 1) and IISERP-MOF27 ([NH2 (CH3 )2 ]1/2 [Zn4 O(Ad)3 (BDC)2 ]â (H2 O)2 (DMF)1/2 , 2), which show selective CO2 capture capabilities. They are made by combining inexpensive and readily available terephthalic acid and N-rich adenine with Cu and Zn, respectively. They possess 1D channels decorated by the free amine group from the adenine and the polarizing oxygen atoms from the terephthalate units. Even more, there are dimethyl ammonium (DMA+ ) cations in the pore rendering an electrostatic environment within the channels. The activated Cu- and Zn-MOFs physisorb about 2.7 and 2.2â mmol g-1 of CO2 , respectively, with high CO2 /N2 and moderate CO2 /CH4 selectivity. The calculated heat of adsorption (HOA=21-23â kJ mol-1 ) for the CO2 in both MOFs suggest optimal physical interactions which corroborate well with their facile on-off cycling of CO2 . Notably, both MOFs retain their crystallinity and porosity even after soaking in water for 24 hours as well as upon exposure to steam over 24 hours. The exceptional thermal and chemical stability, favorable CO2 uptakes and selectivity and low HOA make these MOFs promising sorbents for selective CO2 capture applications. However, the MOF's low heat of adsorption despite having a highly CO2 -loving groups lined walls is quite intriguing.