Effects of thermal denaturation on the solid-state structure and molecular mobility of glycinin.

The effects of moisture and thermal denaturation on the solid-state structure and molecular mobility of soy glycinin powder were investigated using multiple techniques that probe over a range of length and time scales. In native glycinin, increased moisture resulted in a decrease in both the glass transition temperature and the denaturation temperature. The sensitivity of the glass transition temperature to moisture is shown to follow the Gordon-Taylor equation, while the sensitivity of the denaturation temperature to moisture is modeled using Flory's melting point depression theory. While denaturation resulted in a loss of long-range order, the principal conformational structures as detected by infrared are maintained. The temperature range over which the glass to rubber transition occurred was extended on the high temperature side, leading to an increase in the midpoint glass transition temperature and suggesting that the amorphous regions of the newly disordered protein are less mobile. (13)C NMR results supported this hypothesis.

Water movement into dormant and non-dormant wheat (Triticum aestivum L.) grains.

The movement of water into harvest-ripe grains of dormant and non-dormant genotypes of wheat (Triticum aestivum L.) was investigated using Magnetic Resonance Micro-Imaging (MRMI). Images of virtual sections, both longitudinal and transverse, throughout the grain were collected at intervals after the start of imbibition and used to reconstruct a picture of water location within the different grain tissues and changes over time. The observations were supplemented by the weighing measurements of water content and imbibition of grains in water containing I(2)/KI which stains starch and lipid, thereby acting as a marker for water. In closely related genotypes, with either a dormant or a non-dormant phenotype, neither the rate of increase in water content nor the pattern of water distribution within the grain was significantly different until 18 h, when germination became apparent in the non-dormant genotype. Water entered the embryo and scutellum during the very early stages of imbibition through the micropyle and by 2 h water was clearly evident in the micropyle channel. After 12 h of imbibition, embryo structures such as the coleoptile and radicle were clearly distinguished. Although water accumulated between the inner (seed coat) and outer (pericarp) layers of the coat surrounding the grain, there was no evidence for movement of water directly across the coat and into the underlying starchy endosperm.

Characteristics of starch-based films plasticised by glycerol and by the ionic liquid 1-ethyl-3-methylimidazolium acetate: a comparative study.

This paper reports the plasticisation effect of the ionic liquid, 1-ethyl-3-methylimidazolium acetate ([Emim][OAc]), as compared with the traditionally used plasticiser, glycerol, on the characteristics of starch-based films. For minimising the additional effect of processing, a simple compression moulding process (which involves minimal shear) was used for preparation of starch-based films. The results show that [Emim][OAc] was favourable for plasticisation, i.e., disruption of starch granules (by scanning electron microscopy), and could result in a more amorphous structure in the starch-based materials (by X-ray diffraction and dynamic mechanical analysis). (13)C CP/MAS and SPE/MAS NMR spectroscopy revealed that not only was the crystallinity reduced by [Emim][OAc], but also the amorphous starch present was plasticised to a more mobile form as indicated by the appearance of amorphous starch in the SPE/MAS spectrum. Mechanical results illustrate that, when either glycerol or [Emim][OAc] was used, a higher plasticiser content could contribute to higher flexibility. In spite of the accelerated thermal degradation of starch by [Emim][OAc] as shown by thermogravimetric analysis, the biodegradation study revealed the antimicrobial effect of [Emim][OAc] on the starch-based materials. Considering the high-amylose starch used here which is typically difficult to gelatinise in a traditional plasticiser (water and/or glycerol), [Emim][OAc] is demonstrated to be a promising plasticiser for starch to develop "green" flexible antimicrobial materials for novel applications.