A novel DXA-based hip failure index captures hip fragility independent of BMD.

Capability of a novel dual-energy X-ray absorptiometry (DXA)-based hip failure index (HiFI) to discriminate between hip fracture cases and controls was evaluated. Given the constraints of planar DXA, the femoral neck was assumed a foam-filled ( approximately trabecular bone), thin-walled ( approximately cortical bone) sandwich structure, while HiFI estimated the critical force sufficient to buckle the wall of such a structure. Proximal femur DXA data from 1379 women aged 65yr and older, 268 with prior hip fracture were used. Comparison between standard areal bone mineral density (BMD), femur strength index (FSI), and HiFI was based on areas under receiver operatoring characteristic curves (AUC). The mean femoral neck BMD (SD) was 0.689 (0.109) g/cm(2) among the cases and 0.768 (0.119) g/cm(2) among the controls; the mean FSI 1.33 (0.36) and 1.54 (0.41), and the mean HiFI -0.28 (0.14) and -0.18 (0.15), respectively; all intergroup differences were highly significant (p<0.001). The intergroup difference for HiFI remained significant (p<0.002) after adjusting for age and BMD or FSI. The AUCs were 0.696 (95% confidence interval [CI]: 0.661-0.730) for BMD, 0.665 (0.630-0.700) for FSI, and 0.701 (0.666-0.736) for HiFI. In conclusion, HiFI may capture structural traits that account for femoral neck fragility independently of BMD or FSI. Obviously, the use of actual geometric and structural information from three-dimensional imaging of the femoral neck would help diminish the crude assumptions of the present DXA approach and reveal the true potential of the HiFI approach to gauge hip fragility and identify at-risk individuals for hip fractures.

Culture confirmation of cytomegalovirus and herpes simplex virus by direct enzyme-labeled DNA probes and in situ hybridization.

Using probes consisting of horseradish peroxidase (HRP) directly attached to DNA, scrapings or trypsinized cells from 217 adequate clinical samples were cultured and analyzed in 3 blind studies by in situ hybridization for the presence of cytomegalovirus (CMV) and herpes simplex virus (HSV). Sixty samples were judged inadequate due to insufficient cell numbers; however, this problem was significantly decreased during the course of the study. One hundred and eighteen samples were found positive and 70 samples were found negative for CMV. Scrapings of cultured cells from 29 clinical samples revealed 9 samples which were positive and 20 samples which were negative for HSV. Forty-two additional samples, containing either uninfected cells or cells infected with various strains of CMV, were analyzed for the ability of the HRP-DNA CMV probe to detect such isolates. Twenty samples were positive and 22 negative for CMV. No false-negatives or false-positives were observed for either CMV or HSV. In addition to the specificity noted above neither the CMV nor the HSV DNA probe hybridized to potential contaminants found in clinical specimens.

Femur strength index predicts hip fracture independent of bone density and hip axis length.

INTRODUCTION: Proximal femoral bone strength is not only a function of femoral bone mineral density (BMD), but also a function of the spatial distribution of bone mass intrinsic in structural geometric properties such as diameter, area, length, and angle of the femoral neck. Recent advancements in bone density measurement include software that can automatically calculate a variety of femoral structural variables that may be related to hip fracture risk. The purpose of this study was to compare femoral bone density, structure, and strength assessments obtained from dual-energy X-ray absorbtiometry (DXA) measurements in a group of women with and without hip fracture. METHODS: DXA measurements of the proximal femur were obtained from 2,506 women 50 years of age or older, 365 with prior hip fracture and 2,141 controls. In addition to the conventional densitometry measurements, structural variables were determined using the Hip Strength Analysis program, including hip axis length (HAL), cross-sectional moment of inertia (CSMI), and the femur strength index (FSI) calculated as the ratio of estimated compressive yield strength of the femoral neck to the expected compressive stress of a fall on the greater trochanter. RESULTS: Femoral neck BMD was significantly lower and HAL significantly higher in the fracture group compared with controls. Mean CSMI was not significantly different between fracture patients and controls after adjustment for BMD and HAL. FSI, after adjustment for T score and HAL, was significantly lower in the fracture group, consistent with a reduced capacity to withstand a fall without fracturing a hip. CONCLUSION: We conclude that BMD, HAL, and FSI are significant independent predictors of hip fracture.