Size-Controllable Melt-Electrospun Polycaprolactone (PCL) Fibers with a Sodium Chloride Additive.

Melt-electrospun polycaprolactone (PCL) fibers were fabricated by using NaCl as an additive. The size and morphology of the PCL fibers could be controlled by varying the concentration of the additive. The smallest size of the fibers (2.67 ± 0.57) µm was found in the sample with 8 wt% NaCl, which was an order of magnitude smaller than the PCL fibers without the additive. The melt-electrospun fibers were characterized using the differential scanning calorimeter (DSC), X-ray diffraction (XRD), and Fourier transform infrared spectroscopy (FTIR) techniques. Interestingly, a trace of NaCl was not found in any melt-electrospun fiber. The remaining PCL after melt-electrospinning was evaporated by annealing, and the NaCl residual was found in the glass syringe. The result confirmed that the NaCl additive was not ejected from the glass syringe in the melt-electrospinning process. Instead, the NaCl additive changed the viscosity and the polarization of the molten polymer. Two parameters are crucial in determining the size and morphology of the electrospun fibers. The higher NaCl concentration could lead to higher polarization of the polymer melt and thus a stronger electrostatic force, but it could also result in an exceedingly high viscosity for melt-electrospinning. In addition, the absence of NaCl in the melt-electrospun PCL fibers is advantageous. The fibers need not be cleaned to remove additives and can be directly exploited in applications, such as tissue engineering or wound dressing.

Data on effect of electrospinning conditions on morphology and effect of heat-treatment temperature on the cycle and rate properties of core-shell LiFePO4/FeS/C composite fibers for use as cathodes in Li-ion batteries.

The data in this study are related to the research article "Core-shell electrospun and doped LiFePO4/FeS/C composite fibers for Li-ion batteries" [1]. Core-shell LiFePO4/FeS/C composites fiber were prepared via an electrospinning method for use as cathodes in Li-ion batteries. The data presented in this paper showed the effect of electrospinning parameters, including applied voltage, solution flow rate, the concentration of polyvinylpyrrolidone (PVP) (wt%) and a mixed PVP/PEO (polyethylene oxide) (w/w%) polymers on the morphological properties of composites fibers. These data were developed using scanning electron microscopy (SEM). Then, the effect of heat-treatment temperature on fiber morphology was investigated using transmission electron microscopy (TEM). The voltage profile and cycle rate properties of the core-shell LiFePO4/FeS/C composites obtained after various heat treatments were studied.