Towards Attosecond High-Energy Electron Bunches: Controlling Self-Injection in Laser-Wakefield Accelerators Through Plasma-Density Modulation.

Self-injection in a laser-plasma wakefield accelerator is usually achieved by increasing the laser intensity until the threshold for injection is exceeded. Alternatively, the velocity of the bubble accelerating structure can be controlled using plasma density ramps, reducing the electron velocity required for injection. We present a model describing self-injection in the short-bunch regime for arbitrary changes in the plasma density. We derive the threshold condition for injection due to a plasma density gradient, which is confirmed using particle-in-cell simulations that demonstrate injection of subfemtosecond bunches. It is shown that the bunch charge, bunch length, and separation of bunches in a bunch train can be controlled by tailoring the plasma density profile.

An ultra-high gain and efficient amplifier based on Raman amplification in plasma.

Raman amplification arising from the excitation of a density echelon in plasma could lead to amplifiers that significantly exceed current power limits of conventional laser media. Here we show that 1-100 J pump pulses can amplify picojoule seed pulses to nearly joule level. The extremely high gain also leads to significant amplification of backscattered radiation from "noise", arising from stochastic plasma fluctuations that competes with externally injected seed pulses, which are amplified to similar levels at the highest pump energies. The pump energy is scattered into the seed at an oblique angle with 14 J sr-1, and net gains of more than eight orders of magnitude. The maximum gain coefficient, of 180 cm-1, exceeds high-power solid-state amplifying media by orders of magnitude. The observation of a minimum of 640 J sr-1 directly backscattered from noise, corresponding to ≈10% of the pump energy in the observation solid angle, implies potential overall efficiencies greater than 10%.

Energy transfer and dissipation in forced isotropic turbulence.

A model for the Reynolds-number dependence of the dimensionless dissipation rate C(ɛ) was derived from the dimensionless Kármán-Howarth equation, resulting in C(ɛ)=C(ɛ,∞)+C/R(L)+O(1/R(L)(2)), where R(L) is the integral scale Reynolds number. The coefficients C and C(ɛ,∞) arise from asymptotic expansions of the dimensionless second- and third-order structure functions. This theoretical work was supplemented by direct numerical simulations (DNSs) of forced isotropic turbulence for integral scale Reynolds numbers up to R(L)=5875 (R(λ)=435), which were used to establish that the decay of dimensionless dissipation with increasing Reynolds number took the form of a power law R(L)(n) with exponent value n=-1.000±0.009 and that this decay of C(ɛ) was actually due to the increase in the Taylor surrogate U(3)/L. The model equation was fitted to data from the DNS, which resulted in the value C=18.9±1.3 and in an asymptotic value for C(ɛ) in the infinite Reynolds-number limit of C(ɛ,∞)=0.468±0.006.

Chirped pulse Raman amplification in warm plasma: towards controlling saturation.

Stimulated Raman backscattering in plasma is potentially an efficient method of amplifying laser pulses to reach exawatt powers because plasma is fully broken down and withstands extremely high electric fields. Plasma also has unique nonlinear optical properties that allow simultaneous compression of optical pulses to ultra-short durations. However, current measured efficiencies are limited to several percent. Here we investigate Raman amplification of short duration seed pulses with different chirp rates using a chirped pump pulse in a preformed plasma waveguide. We identify electron trapping and wavebreaking as the main saturation mechanisms, which lead to spectral broadening and gain saturation when the seed reaches several millijoules for durations of 10's - 100's fs for 250 ps, 800 nm chirped pump pulses. We show that this prevents access to the nonlinear regime and limits the efficiency, and interpret the experimental results using slowly-varying-amplitude, current-averaged particle-in-cell simulations. We also propose methods for achieving higher efficiencies.

Spectral analysis of structure functions and their scaling exponents in forced isotropic turbulence.

The pseudospectral method, in conjunction with a technique for obtaining scaling exponents ζ_{n} from the structure functions S_{n}(r), is presented as an alternative to the extended self-similarity (ESS) method and the use of generalized structure functions. We propose plotting the ratio |S_{n}(r)/S_{3}(r)| against the separation r in accordance with a standard technique for analyzing experimental data. This method differs from the ESS technique, which plots S_{n}(r) against S_{3}(r), with the assumption S_{3}(r)∼r. Using our method for the particular case of S_{2}(r) we obtain the result that the exponent ζ_{2} decreases as the Taylor-Reynolds number increases, with ζ_{2}→0.679±0.013 as R_{λ}→∞. This supports the idea of finite-viscosity corrections to the K41 prediction for S_{2}, and is the opposite of the result obtained by ESS. The pseudospectral method also permits the forcing to be taken into account exactly through the calculation of the energy input in real space from the work spectrum of the stirring forces.

Reexamination of the infrared properties of randomly stirred hydrodynamics.

Dynamic renormalization-group (RG) methods were originally used by Forster, Nelson, and Stephen (FNS) to study the large-scale behavior of randomly stirred incompressible fluids governed by the Navier-Stokes equations. Similar calculations using a variety of methods have been performed but have led to a discrepancy in results. In this paper, we carefully reexamine in d dimensions the approaches used to calculate the renormalized viscosity increment and, by including an additional constraint which is neglected in many procedures, conclude that the original result of FNS is correct. By explicitly using step functions to control the domain of integration, we calculate a nonzero correction caused by boundary terms which cannot be ignored. We then go on to analyze how the noise renormalization, which is absent in many approaches, contributes an O(k(2)) correction to the force autocorrelation and show conditions for this to be taken as a renormalization of the noise coefficient. Following this, we discuss the applicability of this RG procedure to the calculation of the inertial range properties of fluid turbulence.