RESUMEN
The reconfigurable intelligent surface (RIS) and rate-splitting multiple access (RSMA) are considered as promising technologies for the beyond Fifth-Generation (B5G) and Sixth-Generation (6G) wireless systems by controlling the propagation environment, which attenuates the transmitted signal, and by managing the interference by splitting the user message into common and private messages. Because conventional RIS elements have each impedance connected to the ground, the sum-rate performance improvement of the RIS is limited. Therefore, the new RISs, which have impedance elements connected to each other, have been proposed recently. To be more adaptive to each channel, the optimization of the grouping of the RIS elements is required. Furthermore, since the solution of the optimal rate-splitting (RS) power-splitting ratio is complex, the value should be simply optimized to be more practical in the wireless system. In this paper, the grouping scheme of the RIS elements according to the user scheduling and the solution of the RS power-splitting ratio based on fractional programming (FP) are proposed. The simulation results showed that the proposed RIS-assisted RSMA system achieved a high sum-rate performance compared to the conventional RIS-assisted spatial-division multiple access (SDMA) system. Therefore, the proposed scheme can perform adaptively for the channel and has a flexible interference management. Furthermore, it can be a more suitable technique for B5G and 6G.
RESUMEN
Reconfigurable intelligent surface (RIS) has emerged as a promising technology to enhance the spectral efficiency of wireless communication systems. However, if there are many obstacles between the RIS and users, a single RIS may not provide sufficient performance. For this reason, a double RIS-aided communication system is proposed in this paper. However, this system also has a problem: the signal is attenuated three times due to the three channels created by the double RIS. To overcome these attenuations, an active RIS is proposed in this paper. An active RIS is almost the same as a conventional RIS, except for the included amplifier. Comprehensively, the proposed system overcomes various obstacles and attenuations. In this paper, an active RIS is applied to the second RIS. To reduce the power consumption of active elements, a partially active RIS is applied. To optimize the RIS elements, the sum of the covariance matrix is found by using channels related to each RIS, and the right singular vector is exploited using singular value decomposition for the sum of the covariance matrix. Then, the singular value of the sum of the covariance value is checked to determine which element is the active element. Simulation results show that the proposed system has better sum rate performance compared to a single RIS system. Although it has a lower sum rate performance compared to a double RIS with fully active elements, the proposed system will be more attractive in the future because it has much better energy efficiency.
RESUMEN
Non-orthogonal multiple access (NOMA) has great potential to implement the fifth-generation (5G) requirements of wireless communication. For a NOMA traditional detection method, successive interference cancellation (SIC) plays a vital role at the receiver side for both uplink and downlink transmission. Due to the complex multipath channel environment and prorogation of error problems, the traditional SIC method has a limited performance. To overcome the limitation of traditional detection methods, the deep-learning method has an advantage for the highly efficient tool. In this paper, a deep neural network which has bi-directional long short-term memory (Bi-LSTM) for multiuser uplink channel estimation (CE) and signal detection of the originally transmitted signal is proposed. Unlike the traditional CE schemes, the proposed Bi-LSTM model can directly recover multiuser transmission signals suffering from channel distortion. In the offline training stage, the Bi-LTSM model is trained using simulation data based on channel statistics. Then, the trained model is used to recover the transmitted symbols in the online deployment stage. In the simulation results, the performance of the proposed model is compared with the convolutional neural network model and traditional CE schemes such as MMSE and LS. It is shown that the proposed method provides feasible improvements in performance in terms of symbol-error rate and signal-to-noise ratio, making it suitable for 5G wireless communication and beyond.