RESUMEN
A reconfigurable intelligent surface (RIS) has potential for enhancing the performance of wireless communication. A RIS includes cheap passive elements, and the reflecting of signals can be controlled to a specific location of users. In addition, machine learning (ML) techniques are efficient in solving complex problems without explicit programming. Data-driven approaches are efficient in predicting the nature of any problem and can provide a desirable solution. In this paper, we propose a temporal convolutional network (TCN)-based model for RIS-based wireless communication. The proposed model consists of four TCN layers, one fully connected layer, one ReLU layer, and lastly a classification layer. In the input, we provide data in the form of complex numbers to map a specified label under QPSK and BPSK modulation. We consider 2×2 and 4×4 MIMO communication using one base station and two single-antenna users. We have considered three types of optimizers to evaluate the TCN model. For benchmarking, long short-term memory (LSTM) and without ML are compared. The simulation results are conducted in terms of the bit error rate and symbol error rate which show the effectiveness of the proposed TCN model.
RESUMEN
This paper proposes a novel hybrid beamforming and relay selection scheme for spectral efficiency maximization in a non-regenerative multi-relay multi-input multi-output (MIMO) system. The analog beamforming component in the radio-frequency (RF) domain must follow an element-wise constant modulus constraint, which makes the underlying design problem mathematically intractable and therefore, it is quite challenging to obtain the global optimal solution. To address this problem, phase-only precoding/combining matrices are derived by maximizing the end-to-end received signal-to-noise ratio (SNR) under transmit power constraint at the source and each relay node. This task is achieved by decomposing the original complicated optimization problem into two independent components. The first component designs the RF precoder/combiner at source and relay nodes by maximizing the received SNR at relay nodes. While the second component attempts to derive the analog precoder/combiner at relay nodes and destination by maximizing the received SNR at the destination. Digital baseband processing matrices are obtained by deriving the closed-form expression, which minimizes interference among different sub-channels. Finally, the relay selection is made by maximizing the overall SNR from the source to the destination. Computer simulations reveal that the performance of the proposed algorithm is close to its fully digital counterpart and approximately 6% higher than the specified relay-assisted hybrid beamforming techniques. Moreover, the proposed method achieves more than 15% higher performance in a sparse scattering environment when compared with the given relay selection techniques.
RESUMEN
Visible light communication (VLC) has contributed new unused spectrum in addition to the traditional radio frequency communication and can play a significant role in wireless communication. The adaptation of VLC technology enhances wireless connectivity both in indoor and outdoor environments. Multiple-input multiple-output (MIMO) communication has been an efficient technique for increasing wireless communications system capacity and performance. With the advantages of MIMO techniques, VLC can achieve an additional degree of freedom. In this paper, we systematically perform a survey of the existing work based on MIMO VLC. We categorize the types of different MIMO techniques, and a brief description is given. Different problem-solving approaches are given in the subsequent sections. In addition, machine learning approaches are also discussed in sufficient detail. Finally, we identify the future study direction for MIMO-based communication in VLC.
Asunto(s)
Aclimatación , Aprendizaje Automático , Tecnología de la Información , LuzRESUMEN
The reconfigurable intelligent surface (RIS) and rate-splitting multiple access (RSMA) are considered as promising technologies for the beyond Fifth-Generation (B5G) and Sixth-Generation (6G) wireless systems by controlling the propagation environment, which attenuates the transmitted signal, and by managing the interference by splitting the user message into common and private messages. Because conventional RIS elements have each impedance connected to the ground, the sum-rate performance improvement of the RIS is limited. Therefore, the new RISs, which have impedance elements connected to each other, have been proposed recently. To be more adaptive to each channel, the optimization of the grouping of the RIS elements is required. Furthermore, since the solution of the optimal rate-splitting (RS) power-splitting ratio is complex, the value should be simply optimized to be more practical in the wireless system. In this paper, the grouping scheme of the RIS elements according to the user scheduling and the solution of the RS power-splitting ratio based on fractional programming (FP) are proposed. The simulation results showed that the proposed RIS-assisted RSMA system achieved a high sum-rate performance compared to the conventional RIS-assisted spatial-division multiple access (SDMA) system. Therefore, the proposed scheme can perform adaptively for the channel and has a flexible interference management. Furthermore, it can be a more suitable technique for B5G and 6G.
RESUMEN
Reconfigurable intelligent surface (RIS) has emerged as a promising technology to enhance the spectral efficiency of wireless communication systems. However, if there are many obstacles between the RIS and users, a single RIS may not provide sufficient performance. For this reason, a double RIS-aided communication system is proposed in this paper. However, this system also has a problem: the signal is attenuated three times due to the three channels created by the double RIS. To overcome these attenuations, an active RIS is proposed in this paper. An active RIS is almost the same as a conventional RIS, except for the included amplifier. Comprehensively, the proposed system overcomes various obstacles and attenuations. In this paper, an active RIS is applied to the second RIS. To reduce the power consumption of active elements, a partially active RIS is applied. To optimize the RIS elements, the sum of the covariance matrix is found by using channels related to each RIS, and the right singular vector is exploited using singular value decomposition for the sum of the covariance matrix. Then, the singular value of the sum of the covariance value is checked to determine which element is the active element. Simulation results show that the proposed system has better sum rate performance compared to a single RIS system. Although it has a lower sum rate performance compared to a double RIS with fully active elements, the proposed system will be more attractive in the future because it has much better energy efficiency.
RESUMEN
Non-orthogonal multiple access (NOMA) has great potential to implement the fifth-generation (5G) requirements of wireless communication. For a NOMA traditional detection method, successive interference cancellation (SIC) plays a vital role at the receiver side for both uplink and downlink transmission. Due to the complex multipath channel environment and prorogation of error problems, the traditional SIC method has a limited performance. To overcome the limitation of traditional detection methods, the deep-learning method has an advantage for the highly efficient tool. In this paper, a deep neural network which has bi-directional long short-term memory (Bi-LSTM) for multiuser uplink channel estimation (CE) and signal detection of the originally transmitted signal is proposed. Unlike the traditional CE schemes, the proposed Bi-LSTM model can directly recover multiuser transmission signals suffering from channel distortion. In the offline training stage, the Bi-LTSM model is trained using simulation data based on channel statistics. Then, the trained model is used to recover the transmitted symbols in the online deployment stage. In the simulation results, the performance of the proposed model is compared with the convolutional neural network model and traditional CE schemes such as MMSE and LS. It is shown that the proposed method provides feasible improvements in performance in terms of symbol-error rate and signal-to-noise ratio, making it suitable for 5G wireless communication and beyond.
Asunto(s)
Redes de Comunicación de Computadores , Noma , Algoritmos , Humanos , Redes Neurales de la Computación , Relación Señal-RuidoRESUMEN
A cell-free massive multiple input multiple output (MIMO) system is an attractive network model that is in the spotlight in 5G and future communication systems. Despite numerous advantages, the cell-free massive MIMO system has a problem in that it is difficult to operate in reality due to its vast amount of calculation. The user-centric cell-free massive MIMO model has a more feasible and scalable benefit than the cell-free massive MIMO model. However, this model has the disadvantage that as the number of users in the area increases, there are users who do not receive the service. In this paper, the proposed scheme creates connections for unserved users under a user-centric scheme without additional access point (AP) installation and disconnection for existing users. A downlink user-centric cell-free massive MIMO system model in which the APs are connected to the central processing unit (CPU) and the APs and users are geographically distributed is considered. First, the downlink spectral efficiency formula is derived and applied to the user-centric cell-free massive MIMO system. Then, the proposed scheme and power control algorithm are applied to the derived formula. The simulation results show that the unserved users within the area disappear by using the proposed scheme, while the bit error rate (BER) performance and sum rate improve compared to the existing scheme. In addition, it is shown that the proposed scheme works well even with a very large number of users in the area, and a significant service performance improvement for the worst 10% of users and the overall improvement of per-user throughput for the bottom 70% of users are ensured.
Asunto(s)
Algoritmos , Simulación por ComputadorRESUMEN
An intelligent reflecting surface (IRS) is a programmable device that can be used to control electromagnetic waves propagation by changing the electric and magnetic properties of its surface. Therefore, IRS is considered a smart technology for the sixth generation (6G) of communication networks. In addition, machine learning (ML) techniques are now widely adopted in wireless communication as the computation power of devices has increased. As it is an emerging topic, we provide a comprehensive overview of the state-of-the-art on ML, especially on deep learning (DL)-based IRS-enhanced communication. We focus on their operating principles, channel estimation (CE), and the applications of machine learning to IRS-enhanced wireless networks. In addition, we systematically survey existing designs for IRS-enhanced wireless networks. Furthermore, we identify major issues and research opportunities associated with the integration of IRS and other emerging technologies for applications to next-generation wireless communication.