RESUMEN
We demonstrate that oil-in-water emulsions can be prepared from hydrophobic eutectic systems (ES). Light microscopy and dynamic light scattering show that droplets are formed and zeta potential measurements indicate sufficient stability against coalescence. We investigate whether Ostwald ripening occurs in these ES-in-water emulsions by following the droplet growth over time and comparing it with an emulsion comprising decane in water. At first sight, the Ostwald ripening rate of the ES-in-water emulsion is expected to be orders of magnitude larger than the ripening of the decane-in-water emulsion due to a much higher solubility of the dispersed phase. However, experimentally we find that the ES-in-water emulsion actually grows a factor of two slower than the decane-in-water emulsion. We attribute this to the two-component nature of the ES, since the growth rate is mainly set by the least-soluble component of the ES. Thus, ESs offer the advantage of creating liquid emulsions of solid components, while setting the emulsion stability through their composition.
RESUMEN
The solubility of CO2 in hydrophobic deep eutectic solvents (DESs) has been measured for the first time. Six different hydrophobic DESs are studied in the temperature range from 298 to 323 K and at CO2 pressures up to 2 MPa. The results are evaluated by comparing the solubility data with existing hydrophilic DESs and currently applied physical solvents and fluorinated ionic liquids. The DESs are prepared by mixing decanoic acid with a quaternary ammonium salt with different halide anions and alkyl chain lengths. The measured CO2 solubilities are similar to those found in renowned fluorinated ILs, while the heats of CO2 absorption are in the range of nonpolar solvents. The presented DESs show good potential to be used as CO2 capture agents.
RESUMEN
Lignocellulosic biomass has gained extensive research interest due to its potential as a renewable resource, which has the ability to overtake oil-based resources. However, this is only possible if the fractionation of lignocellulosic biomass into its constituents, cellulose, lignin and hemicellulose, can be conducted more efficiently than is possible with the current processes. This article summarizes the currently most commonly used processes and reviews the fractionation with innovative solvents, such as ionic liquids and deep eutectic solvents. In addition, future challenges for the use of these innovative solvents will be addressed.
RESUMEN
Hydrophobic deep eutectic solvents were used for the first time for the removal of metal ions from non-buffered water. It was shown that the extraction occurs via an ion exchange mechanism in which all transition metal ions could be extracted with high distribution coefficients, even for high Co2+ concentrations and low DES/water mass ratios. Maximum extraction efficiency could be reached within 5 s and regeneration was possible.