Comparison of Surface Persistence of SARS-CoV-2 Alpha and Delta Variants on Stainless Steel at 4°C and 24°C.

Most studies on surface persistence of SARS-CoV-2 have been conducted at temperatures between 20°C and 30°C. There is limited data on the survival of SARS-CoV-2 at low temperatures. In this study, the stability of SARS-CoV-2 Alpha and Delta variants on stainless steel was investigated at two temperatures (4°C and 24°C). The results show that both variants decayed more rapidly at 24°C compared with 4°C. At 24°C, Alpha and Delta variants showed reductions of 0.33 log10 and 1.02 log10, respectively, within the first 2.5 h. However, at 4°C, Alpha variant showed a reduction of 0.16 log10 within the first 2.5 h while no reduction was observed with Delta variant. After remaining in situ for 24 h at 24°C, log10 reductions of 2.66 (Alpha) and 3.11 (Delta) were observed. No viable Alpha and Delta variant was recovered after 48 h and 72 h, respectively. After 24 h in a refrigerated environment (4°C) log10 reductions of 1.16 (Alpha) and 0.95 (Delta) were observed. Under these experimental conditions, both viruses survived on stainless steel for at least 1 week. No viable Alpha and Delta variant was recovered after 10 days. These findings support the potential for increased fomite transmission of SARS-CoV-2 during winter months in colder regions worldwide and in some industrial sectors. IMPORTANCE Human transmission is believed to occur primarily through direct transfer of infectious droplets or aerosols. However, fomite transmission through contact with contaminated surfaces may also play an important role. This study provides novel evidence comparing the stability of Alpha and Delta variants on stainless steel surfaces at 4°C and 24°C. At 4°C both variants were found to be still detectable for up to 7 days. At 24°C Delta variant could be recovered over 2 days compared with Alpha variant which could not be recovered after 2 days. This has implications for fomite transmission interventions for people living and working in cold environments.

Persistence of Bacteriophage Phi 6 on Porous and Nonporous Surfaces and the Potential for Its Use as an Ebola Virus or Coronavirus Surrogate.

The infection of health care workers during the 2013 to 2016 Ebola outbreak raised concerns about fomite transmission. In the wake of the coronavirus disease 2019 (COVID-19) pandemic, investigations are ongoing to determine the role of fomites in coronavirus transmission as well. The bacteriophage phi 6 has a phospholipid envelope and is commonly used in environmental studies as a surrogate for human enveloped viruses. The persistence of phi 6 was evaluated as a surrogate for Ebola virus (EBOV) and coronaviruses on porous and nonporous hospital surfaces. Phi 6 was suspended in a body fluid simulant and inoculated onto 1-cm2 coupons of steel, plastic, and two fabric curtain types. The coupons were placed at two controlled absolute humidity (AH) levels: a low AH of 3.0 g/m3 and a high AH of 14.4 g/m3 Phi 6 declined at a lower rate on all materials under low-AH conditions, with a decay rate of 0.06-log10 PFU/day to 0.11-log10 PFU/day, than under the higher AH conditions, with a decay rate of 0.65-log10 PFU/h to 1.42-log10 PFU/day. There was a significant difference in decay rates between porous and nonporous surfaces at both low AH (P < 0.0001) and high AH (P < 0.0001). Under these laboratory-simulated conditions, phi 6 was found to be a conservative surrogate for EBOV under low-AH conditions in that it persisted longer than Ebola virus in similar AH conditions. Additionally, some coronaviruses persist longer than phi 6 under similar conditions; therefore, phi 6 may not be a suitable surrogate for coronaviruses.IMPORTANCE Understanding the persistence of enveloped viruses helps inform infection control practices and procedures in health care facilities and community settings. These data convey to public health investigators that enveloped viruses can persist and remain infective on surfaces, thus demonstrating a potential risk for transmission. Under these laboratory-simulated Western indoor hospital conditions, we assessed the suitability of phi 6 as a surrogate for environmental persistence research related to enveloped viruses, including EBOV and coronaviruses.

Stability of SARS-CoV-2 variants of concern (Delta and Omicron) on surfaces at room temperature.

Surfaces contaminated with infectious SARS-CoV-2 particles have the potential to cause human infection and any increase in surface survivability of a SARS-CoV-2 variant may increase its prevalence over other variants. This study investigated whether there were differences in surface persistence between Delta and Omicron variants leading to Omicron's dominance globally. Stainless steel coupons were inoculated with suspensions of either Delta or Omicron variant and exposed to typical environmental conditions within a containment level 3 laboratory. Coupons were recovered at different timepoints and enumerated using plaque assay. Both variants were recoverable for >48 h on the coupons. Omicron showed a greater reduction of viability after 48 h compared to Delta with a 20-fold decrease versus 15-fold respectively, but this difference was not statistically significant (p = 0.424). These results indicate that Omicron's surface persistence is unlikely to contribute to it becoming the dominant variant over Delta.