Impact of Drug Physicochemical Properties on Lipolysis-Triggered Drug Supersaturation and Precipitation from Lipid-Based Formulations.

In this study we investigated lipolysis-triggered supersaturation and precipitation of a set of model compounds formulated in lipid-based formulations (LBFs). The purpose was to explore the relationship between precipitated solid form and inherent physicochemical properties of the drug. Eight drugs were studied after formulation in three LBFs, representing lipid-rich (extensively digestible) to surfactant-rich (less digestible) formulations. In vitro lipolysis of drug-loaded LBFs were conducted, and the amount of dissolved and precipitated drug was quantified. Solid form of the precipitated drug was characterized with polarized light microscopy (PLM) and Raman spectroscopy. A significant solubility increase for the weak bases in the presence of digestion products was observed, in contrast to the neutral and acidic compounds for which the solubility decreased. The fold-increase in solubility was linked to the degree of ionization of the weak bases and thus their attraction to free fatty acids. A high level of supersaturation was needed to cause precipitation. For the weak bases, the dose number indicated that precipitation would not occur during lipolysis; hence, these compounds were not included in further studies. The solid state analysis proved that danazol and griseofulvin precipitated in a crystalline form, while niclosamide precipitated as a hydrate. Felodipine and indomethacin crystals were visible in the PLM, whereas the Raman spectra showed presence of amorphous drug, indicating amorphous precipitation that quickly crystallized. The solid state analysis was combined with literature data to allow analysis of the relationship between solid form and the physicochemical properties of the drug. It was found that low molecular weight and high melting temperature increases the probability of crystalline precipitation, whereas precipitation in an amorphous form was favored by high molecular weight, low melting temperature, and positive charge.

Molecular Structuring and Phase Transition of Lipid-Based Formulations upon Water Dispersion: A Coarse-Grained Molecular Dynamics Simulation Approach.

The internal molecular structure of lipid-based formulations (LBFs) is poorly understood. In this work we aimed at establishing coarse-grained molecular dynamics simulations as a tool for rapid screening and investigation of the internal environment of these formulations. In order to study complex LBFs composed of different kinds of lipids we simulated a number of systems containing either medium-chain or long-chain lipids with varying proportions of tri-, di-, and monoglycerides. Structural and dynamic measurements and analyses identified that the internal environment in a mixture of lipids was locally ordered even in the absence of water, which might explain some of the previously reported effects on drug solubility in these systems. Further, phase changes occurring upon water dispersion are well captured with coarse-grained simulations. Based on these simulations we conclude that the coarse-grained methodology is a promising in silico approach for rapid screening of structures formed in complex formulations. More importantly it facilitates molecular understanding of interactions between excipients and water at a feasible time scale and, hence, opens up for future virtual drug formulation studies.

Tools for Early Prediction of Drug Loading in Lipid-Based Formulations.

Identification of the usefulness of lipid-based formulations (LBFs) for delivery of poorly water-soluble drugs is at date mainly experimentally based. In this work we used a diverse drug data set, and more than 2,000 solubility measurements to develop experimental and computational tools to predict the loading capacity of LBFs. Computational models were developed to enable in silico prediction of solubility, and hence drug loading capacity, in the LBFs. Drug solubility in mixed mono-, di-, triglycerides (Maisine 35-1 and Capmul MCM EP) correlated (R(2) 0.89) as well as the drug solubility in Carbitol and other ethoxylated excipients (PEG400, R(2) 0.85; Polysorbate 80, R(2) 0.90; Cremophor EL, R(2) 0.93). A melting point below 150 °C was observed to result in a reasonable solubility in the glycerides. The loading capacity in LBFs was accurately calculated from solubility data in single excipients (R(2) 0.91). In silico models, without the demand of experimentally determined solubility, also gave good predictions of the loading capacity in these complex formulations (R(2) 0.79). The framework established here gives a better understanding of drug solubility in single excipients and of LBF loading capacity. The large data set studied revealed that experimental screening efforts can be rationalized by solubility measurements in key excipients or from solid state information. For the first time it was shown that loading capacity in complex formulations can be accurately predicted using molecular information extracted from calculated descriptors and thermal properties of the crystalline drug.

Effect of lipids on absorption of carvedilol in dogs: Is coadministration of lipids as efficient as a lipid-based formulation?

Lipid-based formulations (LBFs) is a formulation strategy for enabling oral delivery of poorly water-soluble drugs. However, current use of this strategy is limited to a few percent of the marketed products. Reasons for that are linked to the complexity of LBFs, chemical instability of pre-dissolved drug and a limited understanding of the influence of LBF intestinal digestion on drug absorption. The aim of this study was to explore intestinal drug solubilization from a long-chain LBF, and evaluate whether coadministration of LBF is as efficient as a lipid-based drug formulation containing the pre-dissolved model drug carvedilol. Thus, solubility studies of this weak base were performed in simulated intestinal fluid (SIF) and aspirated dog intestinal fluid (DIF). DIF was collected from duodenal stomas after dosing of water and two levels (1 g and 2 g) of LBF. Similarly, the in vitro SIF solubility studies were conducted prior to, and after addition of, undigested or digested LBF. The DIF fluid was further characterized for lipid digestion products (free fatty acids) and bile salts. Subsequently, carvedilol was orally administered to dogs in a lipid-based drug formulation and coadministered with LBF, and drug plasma exposure was assessed. In addition to these studies, in vitro drug absorption from the different formulation approaches were evaluated in a lipolysis-permeation device, and the obtained data was used to evaluate the in vitro in vivo correlation. The results showed elevated concentrations of free fatty acids and bile salts in the DIF when 2 g of LBF was administered, compared to only water. As expected, the SIF and DIF solubility data revealed that carvedilol solubilization increased by the presence of lipids and lipid digestion products. Moreover, coadministration of LBF and drug demonstrated equal plasma exposure to the lipid-based drug formulation. Furthermore, evaluation of in vitro absorption resulted in the same rank order for the LBFs as in the in vivo dog study. In conclusion, this study demonstrated increased intestinal solubilization from a small amount of LBF, caused by lipid digestion products and bile secretion. The outcomes also support the use of coadministration of LBF as a potential dosing regimen in cases where it is beneficial to have the drug in the solid form, e.g. due to chemical instability in the lipid vehicle. Finally, the in vitro lipolysis-permeation used herein established IVIVC for carvedilol in the presence of LBFs.

Models for Predicting Drug Absorption From Oral Lipid-Based Formulations.

In this review, we describe the in vitro tools currently used to identify when a lipid-based formulation has the potential to deliver a poorly water-soluble drug via the oral route. We describe the extent to which these tools reflect the in vivo performance of the formulation and, more importantly, we present strategies that we foresee will improve the in vitro-in vivo correlations. We also present emerging computational methods that are likely to allow large parts of the formulation development to be carried out in the computer rather than in the test tube. We suggest that these computational tools will also improve the mechanistic understanding of in vivo formulation performance in the complex and dynamic environment of the gut.