A novel green synthesis of MnO2-Coal composite for rapid removal of silver and lead from wastewater.

The presence of Ag(I) and Pb(II) ions in wastewater poses a significant threat to human health in contemporary times. This study aims to explore the development of a novel and economical adsorbent by grafting MnO2 particles onto low-rank coal, providing an innovative solution for the remediation of water contaminated with silver and lead. The synthesized nanocomposites, referred to as MnO2-Coal, underwent thorough characterization using FTIR, XRD, BET, and SEM to highlight the feasibility of in-situ surface modification of coal with MnO2 nanoparticles. The adsorption of Ag(I) and Pb(II) from their respective aqueous solution onto MnO2-Coal was systematically investigated, with optimization of key parameters such as pH, temperature, initial concentration, contact time, ionic strength, and competing ions. Remarkably adsorption equilibrium was achieved within a 10 min, resulting in impressive removal rates of 80-90 % for both Ag(I) and Pb(II) at pH 6. The experimental data were evaluated using Langmuir, Freundlich, and Temkin isotherm models. The Langmuir isotherm model proved to be more accurate in representing the adsorption of Ag(I) and Pb(II) ions onto MnO2-Coal, exhibiting high regression coefficients (R2 = 0.99) and maximum adsorption capacities of 93.57 and 61.98 mg/g, along with partition coefficients of 4.53 and 71.92 L/g for Ag(I) and Pb(II), respectively, at 293 K. Kinetic assessments employing PFO, PSO, Elovich, and IPD models indicated that the PFO and PSO models were most suitable for adsorption mechanism of Pb(II) and Ag(I) on MnO2-Coal composites, respectively. Moreover, thermodynamic evaluation revealed the spontaneous and endothermic adsorption process for Ag(I), while exothermic behavior for adsorption of Pb(II). Importantly, this approach not only demonstrates cost-effectiveness but also environmental friendliness in treating heavy metal-contamination in water. The research suggests the potential of MnO2-Coal composites as efficient and sustainable adsorbents for water purification applications.

Microwave-assisted synthesis of MnO2 nanosorbent for adsorptive removal of Cs(I) and Sr(II) from water solutions.

In this study, a flower-like porous δ-MnO2 nanostructure was synthesized by a microwave-assisted hydrothermal process for adsorptive removal of strontium (Sr(II)) and cesium (Cs(I)) from wastewater. The prepared δ-MnO2 nanosorbent exhibited superior affinity for Sr(II) over Cs(I) in the single-solute system, with partition coefficient (PC) values of 10.2 and 2.3 L/g, respectively, at pH 6.0. In the two-solute system, the flower-like δ-MnO2 also adsorbed Sr(II) (PC = 3.81 L/g) more selectively than Cs(I) (PC 1.15 L/g). Further, their adsorption capacities decreased by 12 and 16%, respectively, relative to the single-solute system. In contrast, adsorption of the ions onto δ-MnO2 was affected less sensitively in dual than in single system when changes occurred in environmental variables such as pH (2-8) and ionic strength (1-100 mM). Adsorption kinetics, thermodynamics, and isotherm studies demonstrated the pivotal role of the monolayer surface active sites of endothermic δ-MnO2 (e.g., a complexation interaction with Mn-OH). Furthermore, the δ-MnO2 nanosorbent exhibited good regenerability, retaining more than 80% of its adsorption capacity when tested over four reuse cycles. The overall results of this study are expected to help establish strategies to effectively remove metal contaminants from wastewater using a green and low-cost hierarchical nanosorbent.