RESUMO
We report here on the development of a multi-Watt power tunable single frequency ultra-low noise laser system emitting around 620 nm. More than 5 W of output power is obtained between 616.5 nm and 630.8 nm using sum frequency generation of 1050 nm and 1550 nm tunable laser sources in a periodic poled lithium niobate crystal. The tunability is achieved through temperature and channel shift, and only limited by the crystal characteristics. An output power of 10.1 W and an optical-optical efficiency of 45% are reached at 624.5 nm. The relative intensity noise properties of the conversion process have been experimentally investigated in different configurations showing excellent agreement with the analytical prediction.
RESUMO
We demonstrate a 17 W single-frequency, low-intensity-noise green source at 532 nm, by single-pass second-harmonic generation of a 50 W continuous-wave fiber laser in a 30 mm MgO-doped periodically-poled stoichiometric lithium tantalate crystal. The maximum conversion efficiency is about 37%. A nearly Gaussian beam (M2<1.15 at 15 W) and low wavefront distortion are obtained. The system shows stable behavior over 100 h of uninterrupted operation. The evolution of the relative-intensity-noise transfer from the fundamental to the second harmonic is theoretically and experimentally investigated with high resolution.
RESUMO
We report herein on the development of a linearly polarized, single-frequency tunable laser system producing more than 10 W in the 1550 nm range, using a two-stage erbium/ytterbium co-doped fiber-based master oscillator power amplifier (MOPA) architecture. The all-fiber MOPA provides an ultralow intensity noise of -160dBc/Hz beyond 200 kHz between 1533 and 1571 nm (Δλ=38nm) at full output power and a minimum optical signal to noise ratio of 38 dB. A good stability is obtained over 4 h at maximum power for several wavelengths with peak-to-peak fluctuation less than 3% and rms below 0.5%.
RESUMO
We demonstrate a robust linearly polarized 365 W, very low amplitude noise, single frequency master oscillator power amplifier at 1064â nm. Power scaling was done through a custom large mode area fiber with a mode field diameter of 30â µm. No evidence of stimulated Brillouin scattering or modal instabilities are observed. The relative intensity noise is reduced down to -160 dBc/Hz between 2 kHz and 10 kHz via a wide band servo loop (1â MHz bandwidth). We achieve 350 W of isolated power, with a power stability < 0.7% RMS over 1100 hours of continuous operation and a near diffraction limited beam (M2 < 1.1).
RESUMO
We report on a monolithic narrow spectral linewidth master oscillator power amplifier (MOPA) delivering up to 39 W around 976 nm with very high contrast. The amplifier is based on an ytterbium-doped large mode area (LMA) octagonal double clad (DC) active fiber with parameters optimized for long living three-level operation.