Single-Frequency Ion Parking in a Digital 3D Quadrupole Ion Trap.

Single-frequency ion parking, a useful technique in electrospray mass spectrometry (ESI-MS), involves gas-phase charge-reduction ion/ion reactions in an electrodynamic ion trap in conjunction with the application of a supplementary oscillatory voltage to selectively inhibit the reaction rate of an ion of interest. The ion parking process provides a means for limiting the extent of charge reduction in a controlled fashion and allows for ions distributed over a range of charge states to be concentrated into fewer charge states (a single charge state under optimal conditions). As charge reduction inherently leads to an increase in the mass-to-charge (m/z) ratio of the ions, it is important that the means for storing and analyzing ions be able to accommodate ions of high m/z ratios. The so-called 'digital ion trap' (DIT), which uses a digital waveform as the trapping RF, has been demonstrated to be well-suited for the analysis of high m/z ions by taking advantage of its ability to manipulate the waveform frequency. In this study, the feasibility of ion parking in a 3D quadrupole ion trap operated as a DIT using a slow-amplitude single-frequency sine-wave for selective inhibition of an ion/ion reaction is demonstrated. A recently described model that describes ion parking has been adjusted for the DIT case and is used to interpret experimental data for proteins ranging in mass from 8600 Da to 467,000 Da.

Periodic Photobleaching with Structured Illumination for Diffusion Imaging.

The use of periodically structured illumination coupled with spatial Fourier-transform fluorescence recovery after photobleaching (FT-FRAP) was shown to support diffusivity mapping within segmented domains of arbitrary shape. Periodic "comb-bleach" patterning of the excitation beam during photobleaching encoded spatial maps of diffusion onto harmonic peaks in the spatial Fourier transform. Diffusion manifests as a simple exponential decay of a given harmonic, improving the signal to noise ratio and simplifying mathematical analysis. Image segmentation prior to Fourier transformation was shown to support pooling for signal to noise enhancement for regions of arbitrary shape expected to exhibit similar diffusivity within a domain. Following proof-of-concept analyses based on simulations with known ground-truth maps, diffusion imaging by FT-FRAP was used to map spatially-resolved diffusion differences within phase-separated domains of model amorphous solid dispersion spin-cast thin films. Notably, multi-harmonic analysis by FT-FRAP was able to definitively discriminate and quantify the roles of internal diffusion and exchange to higher mobility interfacial layers in modeling the recovery kinetics within thin amorphous/amorphous phase-separated domains, with interfacial diffusion playing a critical role in recovery. These results have direct implications for the design of amorphous systems for stable storage and efficacious delivery of therapeutic molecules.

Anomalous Diffusion Characterization by Fourier Transform-FRAP with Patterned Illumination.

Fourier transform fluorescence recovery after photobleaching (FT-FRAP) with patterned illumination is theorized and demonstrated for quantitatively evaluating normal and anomalous diffusion. Diffusion characterization is routinely performed to assess mobility in cell biology, pharmacology, and food science. Conventional FRAP is noninvasive, has low sample volume requirements, and can rapidly measure diffusion over distances of a few micrometers. However, conventional point-bleach measurements are complicated by signal-to-noise limitations, the need for precise knowledge of the photobleach beam profile, potential for bias due to sample heterogeneity, and poor compatibility with multiphoton excitation because of local heating. In FT-FRAP with patterned illumination, the time-dependent fluorescence recovery signal is concentrated to puncta in the spatial Fourier domain, with substantial improvements in signal-to-noise, mathematical simplicity, representative sampling, and multiphoton compatibility. A custom nonlinear optical beam-scanning microscope enabled patterned illumination for photobleaching through two-photon excitation. Measurements in the spatial Fourier domain removed dependence on the photobleach profile, suppressing bias from imprecise knowledge of the point spread function. For normal diffusion, the fluorescence recovery produced a simple single-exponential decay in the spatial Fourier domain, in excellent agreement with theoretical predictions. Simultaneous measurement of diffusion at multiple length scales was enabled through analysis of multiple spatial harmonics of the photobleaching pattern. Anomalous diffusion was characterized by FT-FRAP through a nonlinear fit to multiple spatial harmonics of the fluorescence recovery. Constraining the fit to describe diffusion over multiple length scales resulted in higher confidence in the recovered fitting parameters. Additionally, phase analysis in FT-FRAP was shown to inform on flow/sample translation.

Ion trap operational modes for ion/ion reactions yielding high mass-to-charge product ions.

To better probe large biomolecular complexes, developments in mass spectrometry (MS) have focused on improving technologies used to generate, transmit, and measure high m/z ions. The additional tandem-MS (MSn) capabilities of ion trap mass spectrometers (ITMS) facilitate experiments that facilitate probing complex biomolecular ions. In particular, charge reduction using gas-phase ion/ion reactions increase separation of charge states generated via electrospray ionization (ESI), which increases confidence in charge state assignments and therefore masses determined from the observed charge states. Current ITMS technologies struggle to generate and measure low charge states of large (>50 kDa) proteins and complexes because of power limitations associated with conventional high-frequency sine wave operation. Other approaches, including frequency scanning techniques and use of digital waveforms, reduce or eliminate some of these limitations. The work presented here studies five different operational modes for a quadrupole ion trap (QIT) mass spectrometer used to generate and measure low charge states of bovine serum albumin (BSA), pyruvate kinase (PK), and GroEL. While digital operation of a QIT presents limitations during the ion/ion reaction period of the experiment, it generally provided the best spectra in terms of resolution and signal at m/z > 50,000.

Guiding synchrotron X-ray diffraction by multimodal video-rate protein crystal imaging.

Synchronous digitization, in which an optical sensor is probed synchronously with the firing of an ultrafast laser, was integrated into an optical imaging station for macromolecular crystal positioning prior to synchrotron X-ray diffraction. Using the synchronous digitization instrument, second-harmonic generation, two-photon-excited fluorescence and bright field by laser transmittance were all acquired simultaneously with perfect image registry at up to video-rate (15 frames s(-1)). A simple change in the incident wavelength enabled simultaneous imaging by two-photon-excited ultraviolet fluorescence, one-photon-excited visible fluorescence and laser transmittance. Development of an analytical model for the signal-to-noise enhancement afforded by synchronous digitization suggests a 15.6-fold improvement over previous photon-counting techniques. This improvement in turn allowed acquisition on nearly an order of magnitude more pixels than the preceding generation of instrumentation and reductions of well over an order of magnitude in image acquisition times. These improvements have allowed detection of protein crystals on the order of 1 µm in thickness under cryogenic conditions in the beamline. These capabilities are well suited to support serial crystallography of crystals approaching 1 µm or less in dimension.

Mass spectrometric studies of fast pyrolysis of cellulose.

A fast pyrolysis probe/linear quadrupole ion trap mass spectrometer combination was used to study the primary fast pyrolysis products (those that first leave the hot pyrolysis surface) of cellulose, cellobiose, cellotriose, cellotetraose, cellopentaose, and cellohexaose, as well as of cellobiosan, cellotriosan, and cellopentosan, at 600°C. Similar products with different branching ratios were found for the oligosaccharides and cellulose, as reported previously. However, identical products (with the exception of two) with similar branching ratios were measured for cellotriosan (and cellopentosan) and cellulose. This result demonstrates that cellotriosan is an excellent small-molecule surrogate for studies of the fast pyrolysis of cellulose and also that most fast pyrolysis products of cellulose do not originate from the reducing end. Based on several observations, the fast pyrolysis of cellulose is suggested to initiate predominantly via two competing processes: the formation of anhydro-oligosaccharides, such as cellobiosan, cellotriosan, and cellopentosan (major route), and the elimination of glycolaldehyde (or isomeric) units from the reducing end of oligosaccharides formed from cellulose during fast pyrolysis.

Multiported pulsed valve interface for a linear quadrupole ion trap mass spectrometer to enable rapid screening of multiple functional-group selective ion-molecule reactions.

Ion-molecule reactions provide a powerful tool for structural elucidation of ionized pharmaceutical analytes in tandem mass spectrometry. However, all previous interfaces for the introduction of reagents for ion-molecule reactions have utilized a single reagent approach. In this study, a multiported pulsed valve system was designed and characterized for rapid introduction of three neutral reagents into a linear quadrupole ion trap. Additionally, automatic triggering was used to allow for the introduction of the reagents on a chromatographic time scale. This system enables automatic, high throughput screening of complex mixtures by using at least three different ion-molecule reactions. Further, rapid testing of new neutral reagents is also possible.

High frame-rate multichannel beam-scanning microscopy based on Lissajous trajectories.

A simple beam-scanning optical design based on Lissajous trajectory imaging is described for achieving up to kHz frame-rate optical imaging on multiple simultaneous data acquisition channels. In brief, two fast-scan resonant mirrors direct the optical beam on a circuitous trajectory through the field of view, with the trajectory repeat-time given by the least common multiplier of the mirror periods. Dicing the raw time-domain data into sub-trajectories combined with model-based image reconstruction (MBIR) 3D in-painting algorithms allows for effective frame-rates much higher than the repeat time of the Lissajous trajectory. Since sub-trajectory and full-trajectory imaging are simply different methods of analyzing the same data, both high-frame rate images with relatively low resolution and low frame rate images with high resolution are simultaneously acquired. The optical hardware required to perform Lissajous imaging represents only a minor modification to established beam-scanning hardware, combined with additional control and data acquisition electronics. Preliminary studies based on laser transmittance imaging and polarization-dependent second harmonic generation microscopy support the viability of the approach both for detection of subtle changes in large signals and for trace-light detection of transient fluctuations.

Unleashing Precision and Freedom in Optical Manipulation: Software-Assisted Real-Time Precision Opto-Control of Intracellular Molecular Activities and Cell Functions.

The traditional method in biological science to regulate cell functions often employs chemical interventions, which commonly lack precision in space and time. While optical manipulation offers superior spatial precision, existing technologies are constrained by limitations in flexibility, accuracy, and response time. Here, we present an adaptable and interactive optical manipulation platform that integrates laser scanning, chemical sensing, synchronized multi-laser control, adaptable target selection, flexible decision-making, and real-time monitoring of sample responses. This software-assisted real-time precision opto-control (S-RPOC) platform facilitates automatic target selection driven by optical signals while permitting user-defined manual delineation. It allows the treatment of mobile or stationary targets with varying laser dosages and wavelengths simultaneously at diffraction-limited spatial precision and optimal accuracy. Significantly, S-RPOC showcases versatile capabilities including adaptive photobleaching, comprehensive quantification of protein dynamics, selective organelle perturbation, control of cell division, and manipulation of individual cell behaviors within a population. With its unprecedented spatiotemporal precision and adaptable decision-making, S-RPOC holds the potential for extensive applications in biological science.

Spatiotemporally Precise Optical Manipulation of Intracellular Molecular Activities.

Controlling chemical processes in live cells is a challenging task. The spatial heterogeneity of biochemical reactions in cells is often overlooked by conventional means of incubating cells with desired chemicals. A comprehensive understanding of spatially diverse biochemical processes requires precise control over molecular activities at the subcellular level. Herein, a closed-loop optoelectronic control system is developed that allows the manipulation of biomolecular activities in live cells at high spatiotemporal precision. Chemical-selective fluorescence signals are utilized to command lasers that trigger specific chemical processes or control the activation of photoswitchable inhibitors at desired targets. This technology is fully compatible with laser scanning confocal fluorescence microscopes. The authors demonstrate selective interactions of a 405 nm laser with targeted organelles and simultaneous monitoring of cell responses by fluorescent protein signals. Notably, blue laser interaction with the endoplasmic reticulum leads to a more pronounced reduction in cytosolic green fluorescent protein signals in comparison to that with nuclei and lipid droplets. Moreover, when combined with a photoswitchable inhibitor, microtubule polymerization is selectively inhibited within the subcellular compartments. This technology enables subcellular spatiotemporal optical manipulation over chemical processes and drug activities, exclusively at desired targets, while minimizing undesired effects on non-targeted locations.

A differentially pumped dual linear quadrupole ion trap (DLQIT) mass spectrometer: a mass spectrometer capable of MS(n) experiments free from interfering reactions.

A novel differentially pumped dual linear quadrupole ion trap (DLQIT) mass spectrometer was designed and built to facilitate tandem MS experiments free from interfering reactions. The instrument consists of two differentially pumped Thermo Scientific linear quadrupole ion trap (LQIT) systems that have been connected via an ion transfer octupole encased in a machined manifold. Tandem MS experiments can be performed in the front trap and then the resulting product ions can be transferred via axial ejection into the back trap for further, independent tandem MS experiments in a differentially pumped area. This approach allows the examination of consecutive collision-activated dissociation (CAD) and ion-molecule reactions without unwanted side reactions that often occur when CAD and ion-molecule reactions are examined in the same space. Hence, it greatly facilitates investigations of ion structures. In addition, the overall lower pressure of the DLQIT, as compared to commercial LQIT instruments, results in a reduction of unwanted side reactions with atmospheric contaminants, such as water and oxygen, in CAD and ion-molecule experiments.

Real-time precision opto-control of chemical processes in live cells.

Precision control of molecular activities and chemical reactions in live cells is a long-sought capability by life scientists. No existing technology can probe molecular targets in cells and simultaneously control the activities of only these targets at high spatial precision. We develop a real-time precision opto-control (RPOC) technology that detects a chemical-specific optical response from molecular targets during laser scanning and uses the optical signal to couple a separate laser to only interact with these molecules without affecting other sample locations. We demonstrate precision control of molecular states of a photochromic molecule in different regions of the cells. We also synthesize a photoswitchable compound and use it with RPOC to achieve site-specific inhibition of microtubule polymerization and control of organelle dynamics in live cells. RPOC can automatically detect and control biomolecular activities and chemical processes in dynamic living samples with submicron spatial accuracy, fast response time, and high chemical specificity.

Increasing the Upper Mass/Charge Limit of a Quadrupole Ion Trap for Ion/Ion Reaction Product Analysis via Waveform Switching.

Quadrupole ion traps (QITs) are versatile platforms for performing experiments with gas-phase ions due to their abilities to store ions of both polarities and to conduct MSn experiments. The QIT is particularly useful as a reaction cell for ion/ion reactions. In the case of an ion/ion reaction experiment in a QIT, multiply charged reactant ions may initially be of relatively low m/z (e.g., m/z < 1000) whereas the product ions can be one or more orders of magnitude higher in m/z (e.g., m/z > 100,000). Several factors can limit the m/z range over which an ion/ion reaction experiment can be conducted. These include (1) the efficiency of the detector, (2) the m/z range over which oppositely charged ions can be mutually stored, and (3) the m/z range over which ions can be mass selectively ejected into an external detector. High-frequency waveforms provide larger m/z trapping ranges for mutual storage of oppositely charged ions whereas low-frequency waveforms provide better trapping for very high m/z product ions. Presented here is a method that switches from a high-frequency sine wave prior to and during an ion/ion reaction to a low-frequency square wave to eject low m/z reagent ions and improves confinement of the product ions before mass-selective ejection by scanning the frequency of the square wave. This approach addresses the third issue, which is the primary limiting factor with QITs operated at high RF (e.g., > 900 MHz). Graphical Abstract.