Spatial variation of organochlorine pesticides and dissolved organic matter in urban closed lakes.

Closed lakes located in urban parks act as sinks of organochlorine pesticides (OCPs), which have been used, for decades, as insecticides, herbicides and fungicides. The closed lakes from Bucharest, Romania, are periodically managed to prevent eutrophication and accumulation of pollutants. However, it is not known if these practices reduce or enhance the legacy pollution with OCPs. The aim of this study was to explore the spatial variation of OCPs in closed lakes. The total concentration of OCPs in water and sediments ranged between 0.0176 and 37.1 µg/L, and between 122 to 1,890 ng/g, respectively. The concentrations of OCPs were compared with the consensus-based sediment quality guidelines (SQGs) in order to evaluate the ecological risks of sediments. The highest potential adverse effects were associated with γ-HCH exposure. Periodical draining and dredging of lakes lead to the resuspension of contaminants, increasing pesticide bioavailability and accumulation in sediments. In addition, we observed that fluorescent dissolved organic matter (DOM) might influence the OCPs cycle. The quantity and character of fluorescent DOM can provide further insight into OCPs degradation. Also, this study may help urban planners to determine the state of urban waters and to find the best solution for water management.

Seasonal Variation of Eutrophication in Some Lakes of Danube Delta Biosphere Reserve.

To understand the trophic state of lakes, this study aims to determine the dynamics of phytoplankton assemblages and the main factors that influence their seasonal variation. Sampling campaigns were carried out in three lakes from the Danube Delta Biosphere Reserve. Spectral analysis of specific phytoplankton pigments was applied as a diagnostic marker to establish the distribution and composition of phytoplankton taxonomic groups. Fluorescence spectroscopy was used to quantify changes in dissolved organic matter (DOM). The relative contribution of the main phytoplankton groups to the total phytoplankton biomass and the trend of development during succession of the seasons showed that cyanobacteria could raise potential ecological or human health problems. Moreover, fluorescence spectroscopy revealed that Cryptophyta and cyanobacteria were the main contributors to the protein-like components of DOM. It was concluded that fluorescence could be used to provide a qualitative evaluation of the eutrophication degree in Danube Delta lakes.

Role of non-fluorescent chromophores in inner filter effect correction and PARAFAC decomposition.

Numerous studies have shown the impact of inner filter effect (IFE) on the fluorescence signal. IFE reduces the fluorescence intensity and distorts the fluorescence peak shape and position, through the absorption of the emitted radiation by the sample components. In this study, we aimed to understand the role of a non-fluorescing chromophore in IFE correction and PARAFAC decomposition. Solutions of three fluorophores, tryptophan, fluorescein and quinine sulfate, and an absorbing compound, green ink, have been prepared using the controlled dilution approach (CDA). PARAFAC identified three components associated with quinine sulfate, fluorescein and an IFE artifact, which was caused by a shift in peak position. Results showed that the absorption of the chromophore played an important role in component determination. We observed that CDA-PARAFAC was able to correct the quinine sulfate and fluorescein signals, and to suppress the IFE artifact component. However, the method was not effective in removing the IFE impact at high concentrations. The results have significant implications on the analysis of samples that contain complex mixtures of fluorophores and chromophores, such as colored natural organic matter or nutrients, like NO32-.

In situ fluorescence measurements of dissolved organic matter: A review.

There is a need for an inexpensive, reliable and fast monitoring tool to detect contaminants in a short time, for quick mitigation of pollution sources and site remediation, and for characterization of natural dissolved organic matter (DOM). Fluorescence spectroscopy has proven to be an excellent technique in quantifying aquatic DOM, from autochthonous, allochthonous or anthropogenic sources. This paper reviews the advances in in situ fluorescence measurements of DOM and pollutants in various water environments. Studies have demonstrated, using high temporal-frequency DOM fluorescence data, that marine autochthonous production of DOM is highly complex and that the allochthonous input of DOM from freshwater to marine water can be predicted. Furthermore, river measurement studies found a delayed fluorescence response of DOM following precipitation compared to turbidity and discharge, with various lags, depending on season, site and input of dissolved organic carbon (DOC) concentration. In addition, research has shown that blue light fluorescence (λemission = 430-500 nm) can be a good proxy for DOC, in environments with terrestrial inputs, and ultraviolet fluorescence (λemission = UVA-320-400 nm) for biochemical oxygen demand, and also E. coli in environments with sanitation issues. The correction of raw fluorescence data improves the relationship between fluorescence intensity and these parameters. This review also presents the specific steps and parameters that must be considered before and during in situ fluorescence measurement session for a harmonized qualitative and quantitative protocol. Finally, the strengths and weaknesses of the research on in situ fluorescence are identified.

Fluorescence spectroscopy for wastewater monitoring: A review.

Wastewater quality is usually assessed using physical, chemical and microbiological tests, which are not suitable for online monitoring, provide unreliable results, or use hazardous chemicals. Hence, there is an urgent need to find a rapid and effective method for the evaluation of water quality in natural and engineered systems and for providing an early warning of pollution events. Fluorescence spectroscopy has been shown to be a valuable technique to characterize and monitor wastewater in surface waters for tracking sources of pollution, and in treatment works for process control and optimization. This paper reviews the current progress in applying fluorescence to assess wastewater quality. Studies have shown that, in general, wastewater presents higher fluorescence intensity compared to natural waters for the components associated with peak T (living and dead cellular material and their exudates) and peak C (microbially reprocessed organic matter). Furthermore, peak T fluorescence is significantly reduced after the biological treatment process and peak C is almost completely removed after the chlorination and reverse osmosis stages. Thus, simple fluorometers with appropriate wavelength selectivity, particularly for peaks T and C could be used for online monitoring in wastewater treatment works. This review also shows that care should be taken in any attempt to identify wastewater pollution sources due to potential overlapping fluorophores. Correlations between fluorescence intensity and water quality parameters such as biochemical oxygen demand (BOD) and total organic carbon (TOC) have been developed and dilution of samples, typically up to ×10, has been shown to be useful to limit inner filter effect. It has been concluded that the following research gaps need to be filled: lack of studies on the on-line application of fluorescence spectroscopy in wastewater treatment works and lack of data processing tools suitable for rapid correction and extraction of data contained in fluorescence excitation-emission matrices (EEMs) for real-time studies.

Characterisation of dissolved organic matter fluorescence properties by PARAFAC analysis and thermal quenching.

The fluorescence intensity of dissolved organic matter (DOM) in aqueous samples is known to be highly influenced by temperature. Although several studies have demonstrated the effect of thermal quenching on the fluorescence of DOM, no research has been undertaken to assess the effects of temperature by combining fluorescence excitation - emission matrices (EEM) and parallel factor analysis (PARAFAC) modelling. This study further extends previous research on thermal quenching by evaluating the impact of temperature on the fluorescence of DOM from a wide range of environmental samples, in the range 20 °C - 0 °C. Fluorescence intensity increased linearly with respect to temperature decrease at all temperatures down to 0 °C. Results showed that temperature affected the PARAFAC components associated with humic-like and tryptophan-like components of DOM differently, depending on the water type. The terrestrial humic-like components, C1 and C2 presented the highest thermal quenching in rural water samples and the lowest in urban water samples, while C3, the tryptophan-like component, and C4, a reprocessed humic-like component, showed opposite results. These results were attributed to the availability and abundance of the components or to the degree of exposure to the heat source. The variable thermal quenching of the humic-like components also indicated that although the PARAFAC model generated the same components across sites, the DOM composition of each component differed between them. This study has shown that thermal quenching can provide additional information on the characteristics and composition of DOM and highlighted the importance of correcting fluorescence data collected in situ.

Continuous fluorescence excitation-emission matrix monitoring of river organic matter.

Real-time fluorescence monitoring has been mostly performed in marine systems, with little progress being made in the application of fluorescence excitation-emission matrix (EEM) spectroscopy, especially for freshwater monitoring. This paper presents a two weeks experiment where real-time fluorescence EEM data have been obtained for Bourn Brook, Birmingham, UK, using an in-situ fibre-optic probe. Fluorescence EEMs were measured every 3 min for two weeks, with control 'grab' samples every hour analyzed for fluorescence EEMs as well as pH, conductivity and dissolved organic carbon. Comparison of real-time and control samples showed an excellent agreement, with no evidence of fibre-optic probe fouling. EEMs of different character were identified using self-organizing maps, which demonstrated seven clusters of fluorescence EEMs which related to the intensity of fluorescence and relative intensities of peak T(1) and T(2) vs. peak C and peak A fluorescence. Fluorescence intensity of peaks A and C were observed to increase with rainfall, and a diesel pollution event was detected through an increase in T(2) fluorescence.