RESUMO
The quadruple-level cell technology is demonstrated in an Au/Al2 O3 /HfO2 /TiN resistance switching memory device using the industry-standard incremental step pulse programming (ISPP) and error checking/correction (ECC) methods. With the highly optimistic properties of the tested device, such as self-compliance and gradual set-switching behaviors, the device shows 6σ reliability up to 16 states with a state current gap value of 400 nA for the total allowable programmed current range from 2 to 11 µA. It is demonstrated that the conventional ISPP/ECC can be applied to such resistance switching memory, which may greatly contribute to the commercialization of the device, especially competitively with NAND flash. A relatively minor improvement in the material and circuitry may enable even a five-bits-per-cell technology, which can hardly be imagined in NAND flash, whose state-of-the-art multiple-cell technology is only at three-level (eight states) to this day.
RESUMO
Semiconductor gas sensors are advantageous in miniaturization and can be used in a wide range of applications, yet consume large power due to high operating temperature. Here we demonstrated the ability of nanoscale scratches produced with mechanical abrasion to enhance the chemical sensitivity of thin-film-type semiconductor sensors. Well-aligned arrays of scratches parallel to the electrical current direction between the source and drain electrodes were made, using typical polishing machines with diamond suspensions, on semiconductor thin films produced with various deposition methods such as atomic layer deposition (ALD), sputtering, and the sol-gel technique. Processing with sharp diamond microparticles left nano-grooves on the surface, together with changes in chemical composition. For all of the tested metal oxide thin films, the introduction of scratches yielded increased quantities of oxygen vacancies and metallic components. Scratched ZnO devices exhibited superior performance even at room temperature, as predicted by a computational simulation that showed increased binding energy of gas molecules on defects. The scratch technique shown in the present study may be used to produce dense arrays of nanometer-scale, chemically functionalized line patterns on substrates larger than a few tens of centimeters with minimum cost, which in turn may be used in a variety of applications including massive arrays of sensors displaying high sensitivity.