RESUMO
In this study, we conduct simulation research on simultaneous desulfurization and denitrification in a multistaggered baffle spray scrubber. By employing two-phase flow simulations within the Euler-Lagrange framework and calculating the gas-liquid mass transfer rate with user-defined functions, we comprehensively analyzed the effects of various operational parameters. Initially, we validated our simulation model by comparing the simulation results with experimental data. Under conditions of a 0.2 mm droplet diameter, a liquid-to-gas ratio (L/G) of 12 L/m3, and a gas flow rate of 5 CMM using a full cone nozzle, the simulation indicated a desulfurization efficiency of 99.90 versus 99.84% obtained experimentally and a denitrification efficiency of 92.01 versus 90.67% obtained experimentally. This comparison confirmed the reliability of the simulation model. Our findings indicate that a droplet size of 2 mm is optimal, enhancing the desulfurization efficiency from 99.90 to 99.98% and the denitrification efficiency from 92.01 to 99.76%. However, when the droplet size exceeds 2 mm, efficiencies marginally decrease. Increasing the liquid-to-gas ratio to 16 L/m3 further improves desulfurization and denitrification efficiencies to 99.98 and 99.80%, respectively. In contrast, higher inlet flue gas flow rates reduce these efficiencies, with a decline observed from 100% to as low as 93.90% for denitrification with 2 mm droplets. Additionally, the use of a swirl cone nozzle, compared to full or hollow cone nozzles, better disperses droplets, enhancing the gas-liquid contact and achieving efficiencies of 99.99% for desulfurization and 99.81% for denitrification with 2 mm droplets. These insights are valuable for optimizing operational conditions in industrial-scale spray scrubbers, significantly contributing to mitigating the environmental impacts of industrial emissions.