Electronic and charge transfer properties of bio-inspired flavylium ions for applications in TiO2-based dye-sensitized solar cells.

We present here a complete study on four synthetic environmentally friendly flavylium salts employed as sensitizers for dye-sensitized solar cells (DSSCs). The effect of several donor groups on the molecular structure of flavylium ions was investigated by combining electrochemical, spectroscopic and computational means. The computational investigation indicated that these molecules can interact strongly with the TiO2 surface by a single OH group of the dihydroxybenzene moiety, and can efficiently inject electrons into the TiO2 following the excitation of their lowest singlet states exhibiting charge transfer (CT) character. In general, all dyes within the explored series exhibited quite good regeneration efficiencies, often ≥70%, in the presence of an iodide electron donor, explaining the high IPCEs and photocurrents recorded in the presence of high lithium content electrolytes. The combination of molecular orbital calculations and electrochemical measurements has also revealed that the introduction of donor groups on the benzopyrylium ring has a generally positive effect resulting in an extended low energy light harvesting and in a potential improvement of the photoinduced charge separation at the semiconductor/dye/electrolyte interface. It also increases the reversibility of the oxidative redox processes of these bio-inspired species, a feature in favour of their long-term stability. At present the best dye within the explored series is 7-(N,N-diethylamino)-3',4'-dihydroxyflavylium chloride based on a dialkylamine donor which is capable of delivering, under optimized conditions, a short-circuit current density of 15 mA cm-2. This is the highest value so far obtained for synthetic analogues of anthocyanins.

Nanostructured anatase TiO2 densified at high pressure as advanced visible light photocatalysts.

This study reports on characterization and photoactivity of nanostructured TiO2 samples, which have been permanently densified under high pressures, up to 2.1 GPa. Commercial Mirkat 211 anatase has been used as a benchmark sample, in order to investigate the effect of unidirectional high pressure on structural, optical and photocatalytic properties of TiO2. Vibrational Raman spectroscopy shows that the treatment does not cause transitions among the different crystalline phases of titanium dioxide. UV-vis diffuse reflectance spectra reveal that increasing pressure gives rise to a shift of the absorption onset towards higher wavelength enhancing the photoactivity under visible radiation. Samples are also photo-electrochemically characterized and tested in the gas phase with partial oxidation of ethanol to acetaldehyde under visible irradiation. Compaction up to 0.8 GPa depresses both the alcohol conversion and the aldehyde yield, while samples treated under higher pressures show enhanced characteristics of conversion compared to the pristine material. Moreover, promising results in the reduction of CO2 are also obtained under UV-visible radiation.

Synthetic analogues of anthocyanins as sensitizers for dye-sensitized solar cells.

Seven flavylium salt dyes were employed for the first time as sensitizers for dye-sensitized solar cells (DSSCs). The theoretical and experimental wavelengths of the maximum absorbances, the HOMO and LUMO energy levels, the coefficients, the oscillator strengths and the dipole moments are calculated for these synthetic dyes. The introduction of a donor group in the flavylium molecular structure was investigated. Photophysical and photoelectrochemical measurements showed that some of these synthetic analogues of anthocyanins are very promising for DSSC applications. The best performance was obtained by a DSSC based on the novel compound 7-(N,N-diethylamino)-3',4'-dihydroxyflavylium which produced a 2.15% solar energy-to-electricity conversion efficiency, under AM 1.5 irradiation (100 mW cm(-2)) with a short-circuit current density (J(sc)) of 12.0 mA cm(-2), a fill factor of 0.5 and an open-circuit voltage (V(oc)) of 0.355 V; its incident photocurrent efficiency of 51% at the peak of the visible absorption band of the dye is remarkable. Our results demonstrated that the substitution of a hydroxylic group with a diethylamine unit in position 7 of ring A of the flavylium backbone expanded the π-conjugation in the dye and thus resulted in a higher absorption in the visible region and is advantageous for effective electron injection from the dye into the conduction band of TiO2.

A Photoelectrochemical Study of Bioinspired 2-Styryl-1-Benzopyrylium Cations on TiO2 Nanoparticle Layer for Application in Dye-Sensitized Solar Cells.

In the present work, five 2-styryl-1-benzopyrylium salts and their relative self-assembly processes towards TiO2 nanocrystalline layers were evaluated as photosensitizers in dye-sensitized solar cells (DSSCs). Integration of these 2-styryl-1-benzopyrylium salts with the semiconductor allow for the performance of highly specific functions suitable for smart applications in material science. Spectroscopic and photoelectrochemical measurements conducted on these five bio-inspired dyes, in solution and upon adsorption onto titanium dioxide films, allowed detailed discussion of the anchoring ability of the different donor groups decorating the 2-styryl-1-benzopyrylium core and have demonstrated their ability as photosensitizers. Our results suggest that the introduction of a dimethylamino group in position 4' of the 2-styryl-1-benzopyrylium skeleton can alter the conjugation of the molecule leading to larger absorption in the visible region and a stronger electron injection of the dye into the conduction band of TiO2. Moreover, our experimental data have been supported by theoretical calculations with the aim to study the energy of the excited states of the five compounds. In this specific case, the simulations reported contributed to better describe the properties of the compounds used and to help create the necessary basis for the design of new and targeted bio-inspired molecules.

Absorption spectra and photovoltaic characterization of chlorophyllins as sensitizers for dye-sensitized solar cells.

Dye-sensitized solar cells (DSSCs) based on Chlorine-e6 (Chl-e6), a Chlorophyll a derivative, and Chl-e6 containing Cu, have been investigated by carrying out incident photon to current efficiency (IPCE) and current-voltage (I-V) measurements. The effect of the metallic ion and the influence of the solvent polarity on the dye aggregation and their absorption bands have been analysed by performing electronic absorption measurements. The dependence of the photoelectrochemical parameters of these DSSCs on the electrolyte by the addition of pyrimidine and/or pyrrole has been discussed in details. For the first time I-V curves for a DSSC based on copper Chl-e6 dye have been shown and compared with Zn based chlorophyllin. Furthermore, the performance of a Cu-Chl-e6 based DSSC has been deeply improved by a progressive optimization of the TiO2 multilayer photoanode overcoming the best data reported in literature so far for this dye. It's worth to emphasize that, the analysis reported in this paper supplies very useful information which paves the way to further detailed studies turned to the employment of natural pigments as sensitizers for solar cells.

Brown seaweed pigment as a dye source for photoelectrochemical solar cells.

Chlorophylls based-dyes obtained from seaweeds represent attractive alternatives to the expensive and polluting pyridil based Ru complexes because of their abundance in nature. Another important characteristic is that the algae do not subtract either cropland or agricultural water, therefore do not conflict with agro-food sector. This pigment shows a typical intense absorption in the UV/blue (Soret band) and a less intense band in the red/near IR (Q band) spectral regions and for these reasons appear very promising as sensitizer dyes for DSSC. In the present study, we utilized chlorophylls from samples of the brown alga Undaria pinnatifida as sensitizer in DSSCs. The dye, extracted by frozen seaweeds and used without any chemical purification, showed a very good fill factor (0.69). Even the photelectrochemical parameters if compared with the existent literature are very interesting.