RESUMO
A simple and eco-friendly procedure of esterification of graphite oxide (GO), which uses acetic anhydride as a model reagent and ethyl acetate as a green solvent, is reported. The procedure leads to high functionalization degrees (at least up to 4.5 mol % of acetyl groups, referred to as graphitic C atoms) and it is much more effective than the literature method based on pure acetic anhydride. Surprisingly, our acetylation procedure does not destroy or reduce GO crystallinity but, irrespective of a substantial increase of distance between GO layers (from 0.84 nm up to 0.95 nm), leads to an increased order in the direction perpendicular to the graphitic planes. This phenomenon indicates that acetyl groups of acetylated GO (AcGO) are easily accommodated between graphitic layers, even improving interlayer order. The esterification procedure is generally applicable with various anhydrides providing differently functionalized graphite oxide. Dispersion of crystalline functionalized GO in volatile organic solvents followed by solvent fast removal, can easily lead to complete exfoliation.
RESUMO
Small amounts of carbon nanofillers, specifically high-surface-area graphite (HSAG) and more effectively carbon black (CB), are able to solve the well-known problem of degradation (molecular weight reduction) during melt processing, for the most relevant biodegradable polymer, namely poly(lactic acid), PLA. This behavior is shown by rheological measurements (melt viscosity during extrusion experiments and time sweep-complex viscosity) combined with gel permeation chromatography (GPC) experiments. PLA's molecular weight, which is heavily reduced during melt extrusion of the neat polymer, can remain essentially unaltered by simple compounding with only 0.1 wt % of CB. At temperatures close to polymer melting by compounding with graphitic fillers, the observed stabilization of PLA melt could be rationalized by scavenging traces of water, which reduces hydrolysis of polyester bonds. Thermogravimetric analyses (TGA) indicate that the same carbon fillers, on the contrary, slightly destabilize PLA toward decomposition reactions, leading to the loss of volatile byproducts, which occur at temperatures higher than 300 °C, i.e., far from melt processing conditions.