Use of stable isotope labeled probes to facilitate liquid chromatography/mass spectrometry based high-throughput screening of time-dependent CYP inhibitors.

Inhibition curve shift is a commonly used approach for screening of time-dependent CYP inhibitors which requires parallel paired incubations to obtain two inhibition curves for comparison. For the control incubation, a test compound is co-incubated with a probe substrate in human liver microsomes (HLM) fortified with NADPH; for the time-dependent incubation (TDI), the test compound is pre-incubated with NADPH-fortified HLM followed by a secondary incubation with a probe substrate. For both incubations, enzyme activity is measured respectively by liquid chromatography/tandem mass spectrometry (LC/MS/MS) analysis of the CYP-specific metabolite, and a TDI inhibitor can be readily identified by inhibition curve shifting as a result of CYP inactivation by the test compound during the pre-incubation. In the present study, we describe an alternative approach to facilitate TDI screening in which stable isotope labeled CYP-specific probes are used for the TDI, and non-labeled substrates are included in the control incubation. Because CYP-specific metabolites produced in the TDI are stable isotope labeled, two sets of incubation samples can be combined and then simultaneously analyzed by LC/MS/MS in the same batch run to reduce the run time. This new method has been extensively validated using both a number of known competitive and TDI inhibitors specific to five most common CYPs such as 1A2, 2C9, 2C19, 2D6, and 3A4. The assay is performed in a 96-well format and can be fully automated. Compared to the traditional method, this approach in combination with sample pooling and a short LC/MS/MS gradient significantly enhances the throughput of TDI screening and thus can be easily implemented in drug discovery to evaluate a large number of compounds without adding additional resource.

Orally efficacious thrombin inhibitors with cyanofluorophenylacetamide as the P2 motif.

2-Cyano-6-fluorophenylacetamide was explored as a novel P2 scaffold in the design of thrombin inhibitors. Optimization around this structural motif culminated in 14, which is a potent thrombin inhibitor (K(i)=1.2nM) that exhibits robust efficacy in canine anticoagulation and thrombosis models upon oral administration.

Design, synthesis, and biological evaluation of novel potent and selective alphavbeta3/alphavbeta5 integrin dual inhibitors with improved bioavailability. Selection of the molecular core.

A novel series of potent and selective alpha(v)beta(3)/alpha(v)beta(5) dual( )()inhibitors was designed, synthesized, and evaluated against several integrins. These compounds were synthesized through a Mitsunobu reaction between the guanidinium mimetics and the corresponding central templates. Guanidinium mimetics with enhaced rigidity (i.e., (2-pyridylamino)propoxy versus the 2-(6-methylamino-2-pyridyl)ethoxy) led to improved activity toward alpha(v)beta(3). Exemplary oral bioavailability in mice was achieved using the indole central scaffold. Although, oral bioavailability was maintained when the indole molecular core was replace with the bioisosteric benzofuran or benzothiophene ring systems, it was found to not significantly impact the integrin activity or selectivity. However, the indole series displayed the best in vivo pharmacokinetic properties. Thus, the indole series was selected for further structure-activity relationships to obtain more potent alpha(v)beta(3)/alpha(v)beta(5) dual antagonist with improved oral bioavailability.

Using in vitro human tissues to predict pharmacokinetic properties.

Pressure on drug discovery teams to predict the success of drug candidates earlier in the drug discovery process has led to the development of in vitro assays using human tissues, cells or fluids that aid chemists and biologists in their decision-making process. The use of human material is often related to the species-specific nature of the enzymatic biotransformations or transport processes that are involved in drug bioavailability. In vitro assays have been developed to indicate liabilities in scaffolds relating to the absorption, distribution or metabolism of new chemical entities. These models have been applied not only to screening and ranking of potential drug candidates but also to the understanding of the mechanisms leading to in vivo pharmacokinetic outcomes. The use of these models is leading to the development of structure-ADME property relationships in a manner similar to classical structure-activity relationship development, and in the future this is expected to lead to in silico models for predicting physiological and pharmacological effects prior to experimentation.

ADME optimization and toxicity assessment in early- and late-phase drug discovery.

Integrating physicochemical, drug metabolism, pharmacokinetics, ADME, and toxicity assays into drug discovery in order to reduce the attrition rates in clinical development is reviewed. The review is organized around three main decision points used in discovery including hit generation, lead optimization and final candidate selection stages. The preclinical strategies used at each decision point are discussed from a drug discovery perspective. Typically, preclinical data produced at these stages use lower throughput assays, smaller amounts of compounds and operate within a timeframe that is consistent with the iterative cycle of most drug discovery research projects. Understanding the false positive rates of these drug discovery preclinical assays is a must in reducing attrition rates in development.

Pharmacokinetic properties of TDP4815 after single intravenous and oral administrations to rat, rabbit, monkey, dog and in vitro drug metabolism.

The pharmacokinetics of TDP4815 was evaluated in rats, rabbits, dogs and monkeys. After intravenous administration, TDP4815 achieved C(O) of 3255 ng/ml in rats at 5 mg/kg, 9066 ng/ml in rabbits and 7858 ng/ml in monkeys at 6 mg/kg, and 4457 ng/ml in dogs at 3 mg/kg. The clearance (C(L)) was 3105, 1692, 835 and 640 ml/h/kg in rats, rabbits, monkeys and dogs, respectively. The volume of distribution (V(Z)) was more than 3861 ml/kg in all species, except 1915 ml/kg in monkeys. The oral bioavailability was rabbit >rat> monkey compared at 100 mg/kg, but it was much higher in dogs (>64%) after oral administrations. The calculated intrinsic clearance data suggested that the clearance of dog and human was restricted by binding to the plasma protein, and the clearance of rat and monkey was dependent on both the free fraction of plasma protein binding and the liver blood flow rate. The unbound hepatic intrinsic clearance of monkey was close to its C(L) suggesting that the hepatic clearance was an important excretion in monkeys. The poor oral bioavailability in the monkey may be related to the extensive glucuronidation. The V(Z).kg and C(L).kg in test species showed good correlation with the animal body weights (R(2)=0.87 and 0.96).

Isobaric metabolite interferences and the requirement for close examination of raw data in addition to stringent chromatographic separations in liquid chromatography/tandem mass spectrometric analysis of drugs in biological matrix.

In addition to matrix effects, common interferences observed in liquid chromatography/tandem mass spectrometry (LC/MS/MS) analyses can be caused by the response of drug-related metabolites to the multiple reaction monitoring (MRM) channel of a given drug, as a result of in-source reactions or decomposition of either phase I or II metabolites. However, it has been largely ignored that, for some drugs, metabolism can lead to the formation of isobaric or isomeric metabolites that exhibit the same MRM transitions as parent drugs. The present study describes two examples demonstrating that interference caused by isobaric or isomeric metabolites is a practical issue in analyzing biological samples by LC/MS/MS. In the first case, two sequential metabolic reactions, demethylation followed by oxidation of a primary alcohol moiety to a carboxylic acid, produced an isobaric metabolite that exhibits a MRM transition identical to the parent drug. Because the drug compound was rapidly metabolized in rats and completely disappeared in plasma samples, the isobaric metabolite appeared as a single peak in the total ion current (TIC) trace and could easily be quantified as the drug since it was eluted at a retention time very close to that of the drug in a 12-min LC run. In the second example, metabolism via the ring-opening of a substituted isoxazole moiety led to the formation of an isomeric product that showed an almost identical collision-induced dissociation (CID) MS spectrum as the original drug. Because two components were co-eluted, the isomeric product could be mistakenly quantified and reported by data processing software as the parent drug if the TIC trace was not carefully inspected. Nowadays, all LC/MS data are processed by computer software in a highly automated fashion, and some analysts may spend much less time to visually examine raw TIC traces than they used to do. Two examples described in this article remind us that quality data require both adequate chromatographic separations and close examination of raw data in LC/MS/MS analyses of drugs in biological matrix.

Discovery, SAR, and X-ray structure of novel biaryl-based dipeptidyl peptidase IV inhibitors.

The discovery, SAR, and X-ray crystal structure of novel biarylaminoacyl-(S)-2-cyano-pyrrolidines and biarylaminoacylthiazolidines as potent inhibitors of dipeptidyl peptidase IV (DPP IV) are reported.

Oxyguanidines: application to non-peptidic phenyl-based thrombin inhibitors.

Although thrombin has been extensively researched with many examples of potent and selective inhibitors, the key characteristics of oral bioavailability and long half-life have been elusive. We report here a novel series non-peptidic phenyl-based, highly potent, highly selective and orally bioavailable thrombin inhibitors using oxyguanidines as guanidine-mimetics.