Co2SnO4 nanoparticles as a high performance catalyst for oxidative degradation of rhodamine B dye and pentachlorophenol by activation of peroxymonosulfate.

Spinel Co2SnO4 nanoparticles are synthesized by a facile hydrothermal route in alkaline solution using SnCl4 and CoCl2 as precursors. The structure, morphology and chemical composition of the nanoparticles are characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), energy dispersive X-ray (EDX), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS) and thermogravimetric analysis (TGA). The catalytic performance of the Co2SnO4 nanoparticles is thoroughly evaluated for peroxymonosulfate (PMS) activation for removal of rhodamine B (RhB) and pentachlorophenol (PCP) from water. The influence of different process parameters on the RhB degradation efficiency is examined and the catalytic stability is evaluated. Under optimized conditions, the Co2SnO4/PMS system is very efficient with a full degradation of RhB and PCP in less than 10 min at room temperature, as revealed by high performance liquid chromatography (HPLC) analysis. Quenching experiments suggested that sulfate radicals (SO4˙-) are the main active species in the degradation process. Moreover, the Co2SnO4 catalyst is stable without any apparent activity loss after 5 cycling runs.

Mixed Ionic and Electronic Conduction in TeO2-ZnO-V2O5 Glasses towards Good Dielectric Features.

The melt-quenching technique was used to synthesize tellurite glasses of the chemical composition 80TeO2-(20-x) ZnO-xV2O5. X-ray diffraction (XRD) patterns indicate the amorphous nature of the prepared glasses. Raman and FTIR measurements demonstrate a progressive substitution of the Te-O-Te linkages by the Te-O-V bridges and the formation of VO4 and VO5 units by a change of the vanadium coordination due to the higher number of oxygens incorporated by further addition of V2O5. The AC conductivity was investigated in the frequency range of 40 Hz to 107 Hz between 473 K to 573 K. A good coherence of the AC conductivity was found using a model correlating the barrier hopping (CPH) and the dominant conduction process changes from ionic to polaronic with the addition of V2O5. The dielectric constant exhibits high values in the range of lower and medium frequencies. Both variations of the electric modulus and the dielectric loss parameters with frequency and temperature showed a relaxation character mainly assigned to the vanadate phases. The electric modulus displays a non-Debye dielectric dispersion and a relaxation process. The present results open the door to future zinc-tellurite glasses-doped vanadium exploitation as a potential electrolyte-based material for solid-state batteries.

Transport Mechanisms and Dielectric Features of Mg-Doped ZnO Nanocrystals for Device Applications.

Magnesium-doped zinc oxide "ZnO:Mg" nanocrystals (NCs) were fabricated using a sol gel method. The Mg concentration impact on the structural, morphological, electrical, and dielectric characteristics of ZnO:Mg NCs were inspected. X-ray diffraction (XRD) patterns display the hexagonal wurtzite structure without any additional phase. TEM images revealed the nanometric size of the particles with a spherical-like shape. The electrical conductivity of the ZnO NCs, thermally activated, was found to be dependent on the Mg content. The impedance spectra were represented via a corresponding circuit formed by a resistor and constant phase element (CPE). A non-Debye type relaxation was located through the analyses of the complex impedance. The conductivity diminished with the incorporation of the Mg element. The AC conductivity is reduced by raising the temperature. Its plot obeys the Arrhenius law demonstrating a single activation energy during the conduction process. The complex impedance highlighted the existence of a Debye-type dielectric dispersion. The various ZnO:Mg samples demonstrate high values of dielectric constant with small dielectric losses for both medium and high-frequency regions. Interestingly, the Mg doping with 3% content exhibits colossal dielectric constant (more than 2 × 104) over wide temperature and frequency ranges, with Debye-like relaxation. The study of the electrical modulus versus the frequency and at different temperatures confirms the non-Debye relaxation. The obtained results reveal the importance of the ZnO:Mg NCs for device applications. This encourages their application in energy storage.

Processing and Study of Optical and Electrical Properties of (Mg, Al) Co-Doped ZnO Thin Films Prepared by RF Magnetron Sputtering for Photovoltaic Application.

In this study, high transparent thin films were prepared by radio frequency (RF) magnetron sputtering from a conventional solid state target based on ZnO:MgO:Al2O3 (10:2 wt %) material. The films were deposited on glass and silicon substrates at the different working pressures of 0.21, 0.61, 0.83 and 1 Pa, 300 °C and 250 W of power. X-ray diffraction patterns (XRD), atomic force microscopy (AFM), UV-vis absorption and Hall effect measurements were used to evaluate the structural, optical, morphological and electrical properties of thin films as a function of the working pressure. The optical properties of the films, such as the refractive index, the extinction coefficient and the band gap energy were systematically studied. The optical band gap of thin films was estimated from the calculated absorption coefficient. That parameter, ranged from 3.921 to 3.655 eV, was hardly influenced by the working pressure. On the other hand, the lowest resistivity of 8.8 × 10-2 Ω cm-1 was achieved by the sample deposited at the lowest working pressure of 0.21 Pa. This film exhibited the best optoelectronic properties. All these data revealed that the prepared thin layers would offer a good capability to be used in photovoltaic applications.

Impact of Ag2O Content on the Optical and Spectroscopic Properties of Fluoro-Phosphate Glasses.

Glasses with the system (84.60-x) NaPO3-5 ZnO-(9.40-x) NaF-x Ag2O-1 Er2O3, (x = 0, 2, 4, and 6) (mol%) were synthesized by the conventional melt-quenching method. The impact of the addition of Ag2O on the physical, thermal, structural, and optical properties of the glasses is discussed. The Judd-Oflet analysis was used to evaluate the radiative properties of the emission transitions of the glasses. The enhancement of luminescence properties due to Ag2O is discussed in terms of consequent changes in the local electromagnetic field, symmetry, and the ligand field around the Er3+ ion. The heat treatment of the glass was performed in order to precipitate Ag nanoparticles (NPs), which form as a layer at the surface of the heat-treated glasses as confirmed using scanning electron microscopy (SEM). The Ag NPs were found to increase the intensity of the emission at 1.5 µm.

Hydrothermal synthesis of ZTO/graphene nanocomposite with excellent photocatalytic activity under visible light irradiation.

A facile and efficient one-step hydrothermal approach for the synthesis of Zn2SnO4 nanoparticles/reduced graphene oxide (ZTO/rGO) nanocomposites using zinc acetate, tin chloride and graphene oxide (GO) as precursors, and sodium hydroxide as reducing agent has been developed. This approach allows simultaneous reduction of GO and growth of spinel ZTO nanoparticles (NPs) on the rGO sheets. The morphology and microstructure characterizations of ZTO/rGO nanocomposites revealed that this method leads to close interfacial contact of ZTO NPs and rGO and efficient dispersion of ZTO NPs on the surface of rGO sheets. The photocatalytic activity of the ZTO/rGO nanocomposite was investigated for the reduction of rhodamine B under visible light irradiation. Compared to pure ZTO NPs, ZTO/rGO nanocomposite exhibited superior photocatalytic activity with a full degradation of rhodamine B within 15min. The enhanced photocatalytic performance of ZTO/rGO was mainly attributed to excellent electron trapping and effective adsorption properties of rGO.

Hydrothermal synthesis, phase structure, optical and photocatalytic properties of Zn2SnO4 nanoparticles.

Zinc stannate (Zn2SnO4 or ZTO) nanoparticles were synthesized via hydrothermal method using NaOH as a mineralizer. X-ray diffraction (XRD), transmission electron microscopy (TEM) and high-resolution transmission electron microscopy (HRTEM) of the synthesized ZTO nanoparticles revealed the formation of highly pure ZTO phase with the spinel-like structure. The nanoparticles have spherical shape with an average size of about 25 nm. The Raman spectrum of the sample was dominated by the A(1g) vibration mode of pure ZTO phase. From UV-Vis measurement, a band gap E(g) of 3.465 eV was determined. The photocatalytic activity of the ZTO nanoparticles was evaluated for the photodegradation of rhodamine B (RhB) under visible light irradiation. The influence of catalyst concentration and irradiation time on the photocatalytic process was investigated. The ZTO catalyst showed the best photocatalytic performance at a concentration of 0.2 g/L, and the photodecomposition of RhB followed first-order kinetics with a rate constant k=0.0249 min(-1). The ZTO-assisted photocatalytic degradation of RhB occurred via two competitive processes: a photocatalytic process and a photosensitized process. The detection of hydroxyl radicals by fluorescence measurements suggests that these species play an important role in the photocatalytic process.